Uniden DECT HS950 User manual

1
DECT HS950
Accessory Headset
For more exciting new products please visit our website:
Australia: www.uniden.com.au
New Zealand: www.uniden.co.nz

2
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:
◆ This unit is NOT waterproof. DO NOT expose this unit to moisture.
◆ DO NOT expose this unit to rain
◆ Do not use this product near water, for example, near a bath tub,
wash bowl, kitchen sink or laundry tub, in a wet basement or near a
swimming pool.
◆ Avoid using a telephone (other than a cordless type) during an
electrical storm. There may be a remote risk of electric shock from
lightning.
◆ Do not use the telephone to report a gas leak in the vicinity of the
leak.
SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
◆ The grant of a NZ Telepermit for any item of terminal equipment
indicates only that Telecom has accepted that the item complies with
minimum conditions for connection to its network. It indicates no
endorsement of the product by Telecom, nor does it provide any sort of
warranty. Above all, it provides no assurance that any item will work
correctlyin all respects with another item of Telepermitted equipment
of a differentmake or model, nor does it imply that any product is
compatiblewith all of Telecom’s network services.
◆ The maximum volume setting of this telephone exceeds the Telecom
specified volume requirement. Telecom takes no responsibility for the
high volume available on this telephone, who believe this telephone is too
loud should contact the manufacturer at the website indicated on owner’s
manual warranty page.
◆ For telephone networks other than Telecom there may be a charge
incurred for local calls if the Insert 0 feature is on. Turn Insert 0 off.
◆ This equipment may not provide for the effective hand-over of a call to
another device connected to the same line.
General Notices for New Zealand Model:
Under power failure conditions this appliance may not operate. Please
ensure that a separate telephone, not dependent on local power, is available
for emergency use.
Important Notice

3
◆ If any items are missing or damaged, contact your place of purchase
immediately. Never use damaged products!
◆ Need help? Get answers at our website:
www.uniden.com.au for Australian model
www.uniden.co.nz for New Zealand model.
What’s in the Box?
Cordless headset
with ear loop and
ear cap attached
Charge Cradle
Headband
Additional earpiece
loops (2)
AC adaptor
Additional ear
caps (2)
HS950

4
Compatible Uniden Cordless Phone
PREPARING YOUR HEADSET
Attach Earpiece Loop or Headband
◆ Choose the appropriate
size Earpiece Loop.
Charge the Battery
◆ Charge the headset completely (about 3 hours) before using it.
◆ Do not charge the headset when the ambient temperature is below 0° C
(32°F) or above 40°C (104°F).
1. Connect the AC adaptor to the
charge cradle jack and to a wall
outlet.
2. Place the headset in the charging
cradle with the status LED facing
forward. If the LED doesn’t light
up, reseat the headset or connect
the charger to a different outlet.
3. When the headset is fully
charged, the status LED will
show blue.
VOLUME +/-
ON/OFF/TALK
STATUS LED
MUTE/FLASH
◆ SSE35/37 series
◆ DECT30/31 series
◆ Elite91 series
◆ XDECT80 series
◆ XDECT61 series
Flash
Mute
Headset peg
Earloop
Earloop
eyelet
◆ Push the selected
Earpiece Loop or
Headband eyelet onto
headset mounting peg.

5
If.. Try..
xthere is no dial tone
xthe error tone sounds
xcharging the headset until fully
charged and then retry connection
Test the Connection
A. On the phone base, press and hold
FIND HANDSET
for 5 seconds.
#On some models (such as the XDECT 6145BT) press
MENU
, select
Register Accy. from the display menu selection, and then press
SElEcT.
B. On the headset, press and hold
VOlUME +
/
-
for 5 seconds.
The status LED will blink rapidly, allowing for the registration mode.
When registered, a confirmation tone sounds at the phone base and the
headset LED flashes blue once every 10 seconds.
Register the Headset
Pick up the headset and press
ON/OFF/TAlK
. Listen for a dial tone.
(Press
ON/OFF/TAlK
to hang up.)
REGISTERING TO A BASE
To Power On To Power Off
xpress and hold
ON/OFF/TAlK
for 3
seconds
.
xpress and hold
ON/OFF/TAlK
for 3
seconds
To answer a call To adjust call or ringer volume
xpress
ON/OFF/TAlK
and speak
clearly
xpress
ON/OFF/TAlK
again to end
call
call (in use) or ringer (standby):
xpress
+
to increase or
–
to decrease
To mute the microphone To answer call waiting call
xpress
MUTE/FlASH
to mute
xpress
MUTE/FlASH
again to
unmute
xpress and hold
MUTE/FlASH
xpress and hold
MUTE/FlASH
to
return
The accessory headset won’t work until you register it to a compatible
Uniden cordless phone!
OPERATION

6
◆ Use only the supplied AC adaptors.
◆ Do not place the unit in direct sunlight or subject it to high
temperatures.
Parts Number Input Voltage Output Voltage
PS-S0540NL2 100-240V~, 50-60Hz
150mA
5.4V 400mA
Type Capacity Talk time Standby Time
Lithium-ion 230mAh, 3.7VDC about 6 hours about 3 days
IMPORTANT INFORMATION
AC Adaptor
Battery Information
◆ Please contact your place of purchase if the battery fails.
◆ When the battery gets low, the headset sounds an alert tone and the
status indicator shows red once every 10 seconds to indicate the unit
needs charging.
General Information
Cleaning the Headset
◆ You cannot use the headset while it is charging.
◆ Actual range varies depending on environmental conditions and battery
power level.
◆ If necessary, remove the Ear Cap and Earpiece loop. Dampen a lint-free
cloth with water or a cleaner specially designed for electronics, and
gently wipe the headset clean.
#Do not expose this product to liquid (water, alcohol, etc.) or
submerse in liquid for any reason.

7
ONEYEAR LIMITED WARRANTY
Terms of Warranty: Uniden Aust/NZ warrants to the original retail
purchaser only that the HS950 (“the Product”), will be free from
defects in materials and craftsmanship for the duration of the warranty
period, subject to the limitations and exclusions set out below.
Warranty Period: This warranty to the original retail purchaser is only
valid in the original country of purchase for a Product first purchased
either in Australia or New Zealand and will expire one (1) year from the
date of the original retail sale. If a warranty claim is made, this warranty
will not apply if the Product is found by Uniden to be:
A. Damaged or not maintained in a reasonable manner or as recommended
in the relevant Uniden Owner’s Manual;
B. Modified, altered or used as part of any conversion kits, subassemblies or
any configurations not sold by Uniden Aust or Uniden NZ;
C. Improperly installed contrary to instructions contained in the relevant
Owner’s Manual
D. Repaired by someone other than an authorized Uniden Repair Agent in
relation to a defect or malfunction covered by this warranty; or
E. Used in conjunction with any equipment, parts or a system
notmanufactured by Uniden.
Parts Covered: This warranty covers the Product and included
accessories.
User-generated Data: This warranty does not cover any claimed loss of
or damage to user-generated data (including but without limitation phone
numbers, addresses and images)that may be stored on your Product.
Satisfactory evidence of the original purchase is required for warranty
service. Please refer to our Uniden website for any details or warranty
durations offered in addition to those contained below.
The warrantor is either Uniden Australia Pty Limited ABN 58 001 865 498
(“Uniden Aust”) or Uniden New Zealand Limited (“Uniden NZ”) as the
case maybe.
UNIDEN DECT HS950
Important:
Warrantor:

Statement of Remedy: If the Product is found not to conform to this
warranty as stated above, the Warrantor, at its discretion, will either
repair the defect or replace the Product without any charge for parts or
service. This warranty does not include any reimbursement or payment
of any consequential damages claimed to arise from a Product’s failure to
comply with the warranty. Our goods come with guarantees that cannot
be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure. This warranty is in addition
to and sits alongside your rights under either the COMPETITION AND
CONSUMER ACT 2010 (Australia) or the CONSUMER GUARANTEES
ACT (New Zealand) as the case may be, none of which can be excluded.
Procedure for Obtaining Warranty Service: Depending on the
country in which the Product was first purchased, if you believe that
your Product does not conform with this warranty, you should deliver
the Product, together with satisfactory evidence of your original
purchase (such as a legible copy of the sales docket) to Uniden at the
addresses shown below. You should contact Uniden regarding any
compensation that may be payable for your expenses incurred in making
a warranty claim. Prior to delivery, we recommend that you make a
backup copy of any phone numbers, images or other data stored on
your Product, in case it is lost or damaged during warranty service.
UNIDEN AUSTRALIA PTY LTD
Service Division
345 Princes Highway,
Rockdale, NSW 2216
Phone number: 1300 366 895
Email: custser[email protected]
UNIDEN NEW ZEALAND LTD
Service Division
150 Harris Road, East Tamaki
Auckland 2013
Phone number: [phone]
Email: ser[email protected].nz
©2012 Uniden Australia Pty Ltd/Uniden New Zealand Ltd
Printed in Vietnam U01UU272BZZ(0)