Unitech HT650 User manual

HT650
Quick Reference Guide
HT650 Package Contents
Please ensure the following contents are in the HT650 packaging. If anything is missing or
damaged, please contact your local account manager or Unitech, Inc.
HT650 Handheld Computer
Product CD
USB Communication / Charging Cable
Battery Pack (1100mAH)
Power Adaptor & Plugs
Wrist Strap
Stylus
HT650 Front View HT650 Rear View
Keypad
The HT650's 21-key keypad features: numeric, alpha,
function, escape, enter, scan trigger and cursor keys.
[SCAN]
Scan Trigger - Use this key to activate the barcode
scanner.
[ENT]
Enter Key - Use this key to confirm data entry.
[FUNC]
Function Key - Use this key to access function keys
shown on the keypad in orange.
 Press the [FUNC] key once to activate this state,
followed by another key.
[ESC]
Escape Key - Use this key to cancel or abort a current operation.

[ALPHA]
Alpha Key - Use this key to access the secondary layer of characters.
 Press the [ALPHA] key once to lock the keypad into Alpha state.
 Press the [ALPHA] key a second time to return to the normal state.
Install the Battery
1. Pinch the battery latches together and lift the cover from the HT650.
2. Insert the battery, from bottom first, into the battery compartment. Press down on the
battery until it snaps into place.
3. Replace the battery cover and secure it into place by sliding the latches into locking
position.
Before using the HT650, ensure that the battery is fully charged. The initial charge requires
approximately sixteen hours. Subsequent charges are completed in less than four hours.
Note：When the battery is charging, the HT650 Power LED lights red.
When charging is complete, the LED will turn green.
Charging the HT650
The battery in the HT650 can be charged using the Charging Cable or the Single-Slot USB
Cradle.
 Charging the battery with the Charging Cable
1. Plug the Charging Cable into the I/O port at the bottom of the HT650.
2. Connect the Power Supply to the Charging Cable.
3. Insert the Power Supply's plug into an electrical outlet.

 Charging the battery pack with Single Dock
a) Do not leave the battery pack inside of the Handy Terminal.
1. Plug the Power Supply into the Power Jack on the back of the Single-Slot Cradle.
2. Insert the Power Supply's plug into an electrical outlet.
3. Slide the HT650 into the cradle. When inserted properly, the HT650 Power LED will
light red to signify charging status.
b) The Single-Slot Cradle features an additional slot for charging spare batteries.
1. Insert the battery, from bottom first, into the battery compartment.
2. Press down on the battery until the battery snaps into place.
Note：When the battery is charging, the HT650 Power LED lights red.
When charging is complete, the LED will turn green.
Note:
The HT650 includes a backup battery that temporarily provides power and retains data in the
absence of main battery power. The backup battery maintains its charge by drawing power
from the main battery.
Unitech recommends frequent connection of your HT650 to an external power source to
conserve main battery power and recharge the backup battery. Always store an unused HT650
with a fully charged main battery pack.
If the main battery and backup battery are depleted, the HT650 will revert to factory default
values.
P/N 400993G Ver.0.2
http://www.ute.com/