Uplift desk Pdc005-tray User manual

Wire tray

(long or short width. qty 2)

3mm Allen wrench

Power block screws

Extension washers

Package Contents

Power & Data Rail: Wire Tray

SKU: PDC005-TRAY

Step 1 - Single Tray

The Extension washers and the screws used to attach the Pow-

er block to the Rail assembly will also be used to attach the

Wire trays.

Loosen all four screws of the Extension washers. Then loosen

the two Power block screws on the side the rst Wire tray is

being attached to. Only loosen these screws enough to slide

the Wire tray underneath (about two full turns). DO NOT COM-

PLETELY REMOVE THESE SCREWS.

Align the slots of the Wire tray with the Power block screws.

Then slide the tray underneath both the Power block screw

heads and the wings of the Extension washers as far as it will

go. Make sure that the outer lip of the Wire tray is facing up

towards the top of the Rail assembly and away from the oor.

Once the Wire tray is in place, tighten the Power block screws

with the 3mm Allen wrench. If you are going to add a second

Wire tray to the other side of the Rail, do not tighten the Exten-

sion washer screws yet.

Step 2 - Dual Trays

Once the rst Wire tray is in place and the Power block screws

have been tightened, loosen the other two Power block screws

about two full turns. Again, DO NOT COMPLETELY REMOVE

THESE SCREWS.

Slide the second Wire tray under the Power block screw heads

and the Extension washer wings just like the rst Wire tray.

Once the second Wire tray is in place, tighten the two Power

block screws and the four Extension washer screws completely

using the 3mm Allen wrench.

Copyright Notice: These instructions are a component of this accessory. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website: uplift-

desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.