V-tech Go! Go! Cory Carson Fire Rescue Freddie User manual

Go! Go! Cory Carson®
Fire Rescue Freddie™
Rotate the packaging lock counterclockwise
several times.
Pull out the packaging lock and discard.
Unlock the Packaging Locks
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Find the battery cover located on the bottom of
the unit, use a screwdriver to loosen the screw
and then open the battery cover.
3. Remove old batteries by pulling up on one end
of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries
are recommended).
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeablebatteries.
• Onlybatteriesofthesameorequivalenttypeasrecommendedaretobe
used.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use.
• Removeexhaustedbatteriesfromthetoy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinfire.
RECHARGEABLE BATTERIES
• Removerechargeablebatteriesfromthetoybeforecharging.
• Rechargeablebatteriesareonlytobechargedunderadultsupervision.
• Donotchargenon-rechargeablebatteries.
PRODUCT FEATURES
1. On/Off Switch
To turn the unit On, slide the On/Off Switch to
the On position. To turn the unit Off, slide the
On/Off Switch to the Off position.
2. Automatic Shut-Off
To preserve battery life, the Go! Go! Cory Carson® character will automatically
power down after approximately 30 seconds without input.The unit can be turned
on again by pressing the Light-Up Button, placing or removing the accessory on
thecharacterorbyrollingthecharacterquickly.
12
91-003967-000 US
WARNING: All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not
part of this toy, and should be discarded for your child’s safety.
NOTE: Please keep this parents’ guide as it contains important
information.
ATTENTION : Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches, étiquettes, cordons et vis d’emballage. Ils ne
font pas partie du jouet.
NOTE : Il est conseillé de conserver ce guide des parents car il comporte
des informations importantes.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

NOTE : This product is in a Try-Me mode in the packaging. After opening the packaging,
turn the character Off and On again, or before the product goes into sleep mode,
put the accessory on top of the character for more than 2 seconds to proceed with
normal play. If the unit powers down while playing, we suggest changing the batteries.
NOTE : Ce produit est actuellement en mode démonstration. Une fois déballé,
veuillezéteindrepuisremettre enmarche cejouet ouveuillezplacer l’accessoire
surlepersonnagependantplusde2secondesavantqu’ilnesemetteenveillepour
activertoutessesfonctionnalités.Silepersonnages’éteintpendantlejeu,veuillez
insérer des piles neuves.
ACTIVITIES
1. Light-Up Button
Press the Light-Up Button to hear sounds,
songs, phrases and melodies.The light will flash
with the sounds.
2. Stacking Fun
Placetheaccessoryonthecharacter’sbackto
unlock new phrases and fun content. The lights
will flash with the sounds.
3. Sounds and Melodies
Push to hear fun sounds. If a melody is already
playing, push the character to add fun sounds
on top of the melody. The light will flash with
the sounds.
34
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat sources.
3. Remove the batteries if the unit will not be in use for an extended period of time.
4. Donotdroptheunitonhardsurfacesanddonotexposetheunittomoistureorwater.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to play again.
5. If the product still does not work, install a new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at
1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to our
website vtechkids.com and filling out our Contact Us form located under
the Customer Support link. Creating and developing VTech products is
accompanied by a responsibility that we take very seriously. We make every
effort to ensure the accuracy of the information, which forms the value of our
products. However, errors sometimes can occur. It is important for you to know
that we stand behind our products and encourage you to contact us with any
problems and/or suggestions you might have. A service representative will be
happy to help you.
Note
ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassB
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
Thisequipmentgenerates,usesandcanradiateradiofrequencyenergyand,ifnot
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occurinaparticularinstallation.Ifthisequipmentdoescauseharmfulinterference
toradioortelevisionreception,whichcanbedeterminedbyturningtheequipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:

• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthe
receiver is connected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Caution: Changes or modifications not expressly approved by the party responsible
forcompliancecouldvoidtheuser’sauthoritytooperatetheequipment.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5452
Product name: Fire Rescue Freddie™
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156W.ShureDrive,Suite200,
Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
CAN ICES-003(B)/NMB-003(B)
91-003967-000
US
Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
vtechkids.ca
TM & © 2021 VTech Holdings Limited.
All rights reserved.
Printed in China.
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty