V-tech Pack & Go Travel Mobile User manual

Pack & Go Travel Mobile
User’s Manual
91-003308-001 UK
© 2016 VTech
Printed in China
All rights reserved

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

3
Introduction
INTRODUCTION
Thank you for purchasing the VTech®Pack & Go Travel Mobile!
The Pack & Go Travel Mobile by VTech®is the perfect mobile for
babies on the go, featuring spinning stars, lights and soothing music.
This compact mobile easily attaches to most cots, playpens, prams
and baby carriers.
ON/OFF/MOBILE
SWITCH
TIME SELECTOR
SWITCH
LOBSTER CLAW
LIGHT UP
BUTTON
VOLUME CONTROL
BUTTONS
NIGHT LIGHT
BUTTON

4
Included In This Package / Getting Started
INCLUDED IN THIS PACKAGE
- One VTech®Pack & Go Travel Mobile electronic module
- One mobile support post
- One mobile
- Three plush dangling stars
- One lobster claw with elastic strap with hook and loop closure
- One user’s manual
WARNING: All packing materials, such as tape, plastic
sheets, packaging locks and tags are not part of
this toy, and should be discarded for your child’s
safety.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate thebattery coveronthe back of
theelectronicmodule.Useascrewdriver
to loosen the screw.
3. Install 3 new AA (AM-3/LR6 batteries
following the diagram inside the battery
box. (The use of new alkaline
batteries are recommended for
maximum performance).
4. Replace the battery cover and tighten
the screw to secure.
Unlock the packaging locks:
Turn the packaging lock anticlockwise
several times.
Pull out and discard the packaging lock.
1.5V AA/LR6/AM-3
1.5V AA/LR6/AM-3
1.5V AA/LR6/AM-3

5
Battery Notice
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
ThechemicalsymbolsHg,Cd or Pb, where marked, indicate
that the battery contains more than the specified value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com

6
DEMO TAG
The demo tag should be removed automatically when the product is
taken out of the packaging. If the demo tag is still in position, please
remove the plastic strip from the back of the product before placing in
a cot. This will activate normal play.
With the VTech®Pack & Go Travel Mobile, safety comes first.
• Keep the mobile out of baby’s reach. To avoid entanglement
injuries, please remove the mobile portion from the cot or
playpen once baby begins sitting or pushing up on all fours.
• Age range of mobile - Birth to 5 months
• The cot mobile is intended for visual stimulation and is not
intended to be grasped by a child.
• Always attach all provided fasteners (strings, straps, clamps, etc).
tightly to the cot according to the instructions. Check frequently.
Attach only to cots with sturdy rails and spindles.
• Do not add additional strings or straps to attach to a cot.
• To ensure your child’s safety, this product should be assembled
by an adult.
• Please make sure that the cot attachment straps are out of your
child’s reach.
• NEVER use this product in a motor vehicle. Death or serious injury
can occur from hard objects in the event of a motor vehicle
accident.
Demo Tag / Safety Information

7
To ensure your child’s safety, this product should be assembled by an
adult. Please ensure that the cot attachment clamp is securely locked
into position to avoid injury. Follow the instructions below carefully and
make sure that the final assembly is correct.
ASSEMBLY INSTRUCTIONS
1. Attach the three plush stars to the
mobile. Thread the cord from one of
the plush stars up through the hole in
the bottom of one of the leaves, then
thread it down through the hole on the
opposite side. Secure the loop over
the notch on the underside of the leaf.
Pull gently on the star to make sure it
issecurelyfastened.Follow the above
instructions for the remaining stars.
2. Attach the mobile to the bottom of the
electronic module. You will hear the
mobile click into place when inserted
correctly.
3. Attach the mobile support post to
cots and playpens with rails that are
between 1.02cm and 3.98cm wide.
Twist the blue sleeve to tighten the
clamp to the cot rail or playpen. Pull
slightly on the post to make sure the
clamp has been securely fastened.
Please check the post frequently to
ensure it is still secure.
Assembly Instructions

8
4. Attach the electronic module to the
support post by pressing the small
blue button on the support post while
sliding the electronic module onto the
supportpost. Checktomakesurethe
electronicmodule isattachedsecurely
to avoid injuries.
5. To use the mobile as a travel mobile,
remove the electronic module from
the mobile support post by pulling
gently on the electronic module while
pressing the blue button to the right of
the electronic module.
6. Thread the elastic hook and loop
closure through the slot on the top of
the electronic module, securing the
hook and loop fabric together.
7. Usetheelasticlooporthelobsterclaw
toattachthemobiletobaby carriers or
prams.Alwayschecktomakesurethe
mobile is attached securely to avoid
injuries.
1 2
Assembly Instructions

9
Product Features
PRODUCT FEATURES
1. ON/OFF/MOBILE SWITCH
ToturntheunitON,slidetheON/OFF
MOBILE SWITCH to the TURNING
MODE ( ) or the STATIONARY
MODE ( ) position. To turn the
unit OFF, slide the ON/OFF/MOBILE
SWITCH to the OFF ( ) position.
2. TIME SELECTOR SWITCH
Slide the TIME SELECTOR SWITCH
to the 10, 20 or 30 minute position.
3. VOLUME CONTROL BUTTONS
To adjust the volume, press the
VOLUME + and VOLUME – buttons.
4. NIGHT LIGHT BUTTON
Press the NIGHT LIGHT BUTTON
to turn the night light on or off. This
feature only works when the mobile is
connected to the mobile support post.

10
Product Features / Activities
5. SOUND SENSOR
The VTech®Pack & Go Travel Mobile is equipped with a special
sound sensor. To preserve battery life, the sound sensor will only
function when the mobile is connected to the mobile support post.
Once the selected time setting has ended, the unit will automatically
shut off.The sensor will reactivate the program when it detects baby's
cry for approximately 4 seconds without interruption.
6. AUTOMATIC SHUT OFF
To preserve battery life, the VTech®Pack & Go Travel Mobile will
automatically shut off after the selected time has ended. The unit
can be turned on again by pressing any button.
Note: If the unit repeatedly shuts off quickly or the light up button
fades out, we suggest changing the batteries.
ACTIVITIES
1. Slide the ON/OFF/MOBILE SWITCH
to the TURNING MODE ( ) or the
STATIONARY MODE ( ) position
to turn the unit ON. You will hear a
soothing phrase followed by soothing
music. The light up button will fade
in and out with the sound when the
electronic module is removed from the
mobile support post.
2. Press the LIGHT UP BUTTON to play
the next song or melody. Hold down
theLIGHT UPBUTTON tohearashort
tune. The light up button will fade in
and out with the sounds when the
electronicmoduleisremovedfromthe
mobile support post.