V-tech Popping Surprise Seal Assembly Instructions

91-003859-004 UK
Popping Surprise Seal
Parent’s Guide

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

3
INTRODUCTION
Thank you for purchasing the Popping Surprise Seal!
Playing with this cute and fun seal is sure to entertain your child! See
the ball launch up into the seal’s hat from his magical tail! Then, clap
along with him in celebration! You can even enjoy songs, phrases
and music at the press of a button, making playtime even more fun!
Please note:
This is not a bath toy. Do not submerge or expose the seal to water.
Warning:
Do not put, or attempt to launch anything other than the ball provided
onto/from the seal’s tail.
Warning:
When the seal launches it’s ball into the air please ensure you are
an appropriate distance away to avoid the ball coming too close to
people’s faces and eyes.
On/Off/Volume Switch
3 Shape Buttons
Light Up
Nose Button

4
INCLUDED IN THIS PACKAGE
One Popping Surprise Seal
One Ball
One Parent’s Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE:
Please keep this Parent’s Guide as it contains important information.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the
electronic module. Use a screwdriver
to loosen the screw and open the
battery cover.
3. Remove old batteries by pulling up on
one side of each battery.
4. Install 4 new AA batteries following
the diagram inside the battery box.
(The use of a new alkaline battery
is recommended for maximum
performance).
5. Replace the battery cover and tighten the screw to secure.
Removing the packaging locks:
Rotate the packaging locks anticlockwise 90
degrees.
Pull out the packaging locks and discard.

5
BATTERY NOTICE
• UsenewalkalinebatteriesorfullychargedNI-MH(NickelMetal-
hydride) rechargeable batteries for best performance.
• Useonlybatteriesofthesameorequivalenttypeas
recommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc)orrechargeable,ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging(if
removable).
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.
Disposal of batteries and product
Thecrossed-outwheeliebinsymbolsonproductsand
batteries,orontheirrespectivepackaging,indicatesthey
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
ThechemicalsymbolsHg,CdorPb,wheremarked,indicate
that the battery contains more than the specified value of
mercury(Hg),cadmium(Cd)orlead(Pb)setoutinBattery
Directive(2006/66/EC).
The solid bar indicates that the product was placed on the
marketafter13thAugust,2005.
Helpprotecttheenvironmentbydisposingofyourproductor
batteries responsibly.
Formoreinformation,pleasevisit:
www.recycle-more.co.uk
www.recyclenow.com

6
PRODUCT FEATURES
1. On/Off/Volume Switch
To turn the unit On, slide the On/Off/
Volume Switch to the Low Volume
or High Volume position.
You will hear a song, phrase and fun
sound. To turn the unit Off, slide the
On/Off Volume Switch to the Off
position.
2. Light Up Nose Button
The Light Up Nose Button will teach the colour of the seal’s nose,
introduce the seal, and play playful songs and melodies.
3. Three Shape Buttons
The Three Shape Buttons introduce the seal, numbers, colours,
shapes, and play playful songs and melodies.
4. Automatic Shut Off
To preserve battery life, the Popping Surprise Seal will
automatically power down after approximately 50 seconds
without input. The unit can be turned on again by pressing any
button.
Note:
This product is in Try Me mode in the packaging. After opening the
package, turn the unit off and on again to proceed with normal play.If the
unit repeatedly powers down while playing, please install a new set of
batteries.

7
ACTIVITIES
1. Light Up Nose Button
Press the Light Up Nose Button
to learn about the colour of seal’s
nose and to play playful songs and
melodies. The light will ash with the
sounds.
2. Shape Buttons
Press the Shape Buttons to learn
colours, shapes, numbers, to
introduce the seal, and to play playful
songs and melodies. The light will
ash with the sounds.
3. Magic Sensor
Put the ball on the seal’s tail, then
see the ball launch up into the hat.
The Magic Sensor on Seal’s hat
can recognise the ball and will play
fun phrases and sound effects. Seal
will also, move forward and clap his
hands.
Note:
If the unit repeatedly powers down while playing, please install a new set
of batteries.

8
SING-ALONG SONG LYRICS
Song 1
I’m a playful seal, I love to play,
I ip my tail, then watch and see.
The ball will land on top of my hat,
Then I'll clap my hands happily!
Song 2
I like to clap, clapping is fun.
Clap your hands together!
Follow along and clap with me.
One, two, three, clap, clap, clap!
Song 3
Hello, my friend,
I live in the sea!
We can play together and sing so happily!
MELODY LIST
1. Alouette
2. Alphabet Song
3. Animal Fair
4. Bingo
5. Camptown Races
6. Entertainer
7. Pop Goes the Weasel
8. Toyland
9. Ta Ra Ra Boom De Ay
10. Yankee Doodle
11. She’ll Be Comin’ ‘Round the Mountain
12. Row, Row, Row Your Boat
13. Skip To My Lou
14. Mulberry Bush
15. Can-can

9
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Please turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
If the problem persists, please contact our Consumer Services
Department and a service representative will be happy to help you.

10
CONSUMER SERVICES
CreatinganddevelopingVTech®products is accompanied by a
responsibility that we at VTech®take very seriously. We make every
efforttoensuretheaccuracyoftheinformation,whichformsthe
valueofourproducts.However,errorssometimescanoccur.Itis
important for you to know that we stand behind our products and
encourageyoutocallourConsumerServicesDepartmentwith
anyproblemsand/orsuggestionsthatyoumighthave.Aservice
representative will be happy to help you.
UK Customers:
Phone:03306780149(fromUK)or+443306780149(outsideUK)
Website:www.vtech.co.uk/support
Australian Customers:
Phone:1800862155
Website:support.vtech.com.au
NZ Customers:
Phone:0800400785
Website:support.vtech.com.au
PRODUCT WARRANTY/
CONSUMER GUARANTEES
UK Customers:
Readourcompletewarrantypolicyonlineatvtech.co.uk/warranty.
Australian Customers:
VTECHELECTRONICS(AUSTRALIA)PTYLIMITED–
CONSUMERGUARANTEES
UndertheAustralianConsumerLaw,anumberofconsumerguarantees
applytogoodsandservicessuppliedbyVTechElectronics(Australia)
PtyLimited.Pleaserefertovtech.com.au/consumerguaranteesfor
further information.