V-tech Switch & Go Triceratops Race Car User manual

TRICERATOPS RACE CARTRICERATOPS RACE CAR
®
Instruction Manual
91-003922-005 US CA

2
INTRODUCTION
Thank you for purchasing Switch & Go
®
Triceratops Race Car.
Transform this ferocious Triceratops into a sleek and cool Race Car in just
a few simple steps. 30+ sounds and phrases bring the action to life in your
very own dino universe!
Off/Low/High
Volume Selector
Crest Activator

3
INCLUDED IN THE PACKAGE
• Switch & Go®Triceratops Race Car
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes, cordons et vis d’emballage. Ils ne font pas partie
du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’instructions car il
comporte des informations importantes.

4
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver
to loosen the screw, and then open
the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 1 new AA (LR6/AM-3) battery
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
Note: If there is no response when the unit is switched on, please
install brand new batteries and try switching the unit on again.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.

6
IMPORTANT : INFORMATIONS CONCERNANT LES PILES
Les piles fournies avec le produit permettent de tester le jouet en
magasin mais ne sont pas des piles longue durée.
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec des
usagés.
• Ne pas mélanger différents types de piles : alcalines, zinc-carbone
et rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en
court-circuit (en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES :
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour
les recharger.
• Les accumulateurs ne doivent être chargés que sous la surveil-
lance d’un adulte.
• Ne pas tenter de recharger des piles non rechargeables.

7
PRODUCT FEATURES
1. Off/Low/High
Volume Selector
To turn the unit On or to adjust the
volume, slide the switch to Low
volume or High volume . To
turn the unit Off, slide the switch to
Off .
2. Crest Activator
Tilt the Crest Activator back to hear
fun phrases and race car sounds in
Vehicle mode. In Dino mode, tilt the
Crest Activator to hear fun phrases,
dinosaur facts and cool dinosaur
sounds. The light projection will show
with the response.
3. Motion Sensor
Move Triceratops Race Car to hear wild dinosaur sounds and
phrases in Dino mode. In Vehicle mode, move Triceratops Race
Car to hear great vehicle sounds.
4. Automatic Shut-Off
To preserve battery life, the Triceratops Race Car will
automatically shut off after approximately 30 seconds without
input. The unit can be turned on again by tilting the Crest
Activator back, or by switching between Dino and Vehicle
modes. The unit will also automatically shut off when battery
power is very low.

8
2. Pull the legs backward.1. Vehicle mode.
TRANSFORMATION
4. Pull the front legs down.3. Pull the feet down.
5. Rotate the crest 180 degrees. 6. The unit is now in Dino mode.
NOTE
To switch from Dino mode to Vehicle mode, follow the above steps
in reverse order.

9
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat source.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use with again.
5. If the unit still does not work, install a new set of batteries.

10
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and filling
out our Contact Us form located under the Customer Support
link. Creating and developing VTech products is accompanied by
a responsibility that we take very seriously. We make every effort
to ensure the accuracy of the information, which forms the value of
our products. However, errors sometimes can occur. It is important
for you to know that we stand behind our products and encourage
you to contact us with any problems and/or suggestions you might
have. A service representative will be happy to help you.
NOTE
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.