V-tech Toot-Toot Friends Pirate Ship Assembly Instructions

Parent’s Guide
Pirate Ship
91-003548-009 UK

2
INTRODUCTION
Thank you for purchasing the VTech®Toot-Toot FriendsTM Pirate
Ship! Place Captain Monty, Sailor Stanley and the Monkey on the
MagicPointTM location to hear fun sounds and music. Press the
cannon button to launch the cannonball and to hear fun sounds. You
can also open up the ship to reveal a treasure island for more pirate
role play fun!
3 Light Up Buttons
Hawk Figurehead
Battery Door
Seesaw
Cannonball
Monkey Octopus Sailor Stanley Captain Monty
Treasure Chest
Mast with
Sails
Crow’s Nest
Cannon
Button
MagicPointTM
Location
Pull Cord

3
INCLUDED IN THIS PACKAGE
NOTE: This toy is not intended for teething.
This toy is not intended for play in water.
• One character -
Sailor Stanley
• One octopus
• One mast with sails
• One character -
Captain Monty
• One character -
Monkey
• One cannonball • One treasure chest
• One cannon • One hawk
gurehead

4
• One parent’s guide
Removing the packaging locks:
(There are two packaging locks located on the octopus).
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE: Please keep this parent’s guide as it contains important
information.
WARNING:
For your child’s safety, please do not put
anything but the cannonball included with
the product into the cannon.
• One small sails • One pirate ship with
MagicPointTM
• One label sheet
Turn the packaging locks
anticlockwise several times.
Pull out and discard the
packaging locks.
1
2

5
GETTING STARTED
Battery Installation - Pirate Ship
1. Make sure the toy is turned OFF.
2. Locate the battery cover on the
bottom right of the pirate ship. Use a
screwdriver to loosen the screw.
3. Install 2 new AA size (LR6/AM-3)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended for
maximum performance).
4. Replace the battery cover and tighten
the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
• Use only batteries of the same or equivalent type as
recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in re.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specied
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in Battery Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com
CAUTION:
Adult assembly required. For your child’s safety, do not let your child
play with this toy until it is fully assembled.
ASSEMBLY INSTRUCTIONS
With the VTech®Toot-Toot Friends™ Pirate Ship, safety comes
rst. To ensure your child’s safety, adult assembly is required.

7
1. Insert the Mast with Sails into
the mounting hole behind the
MagicPointTM as shown in the
picture. Then rmly push the mast
into place, and you will hear a click
when it is properly inserted.
2. Insert the Small Sails into the
mounting hole beside the helm as
shown in the picture. Then push
down rmly and you will hear a
click when it is properly inserted.
3. Insert the Cannon into the
mounting hole on the front deck as
shown in the picture. Push down
rmly and you will hear a click
sound when properly inserted.
4. Attach the Hawk Figurehead to
the small nub on the front of the
ship as shown in the picture. Push
rmly towards the ship and you will
hear a click sound when properly
inserted.

8
LABEL APPLICATION
Please stick the labels to the play set securely as indicated below.
12
345
67
8910
11
12 13 14 15
16 17 18

9
1
5
2
7
9
6
8 3
4
18
16
15
10
13
14 12
11
17