V-tech Winnie the Pooh 2-in-1 Baby Activity Walker User manual

© Disney Based on the “Winnie the Pooh”
works by A.A. Milne and E.H. Shepard.
Visit the Disney website at www.disney com
© 2010 VTech Printed in China
2-in-1 Baby
Activity Walker
User’s Manual
6-36
Months

2
INTRODUCTION
Thank you for purchasing the VTech®2-in-1 Baby Activity Walker!
The 2-in-1 Baby Activity Walker will entertain your little one from sitting
to walking. Easy grip handle, textured wheels and durable design help
encourage those precious first steps. The detachable activity panel is
perfect for sitting play with features to press, spin, push and turn to
hear fun phrases, sounds, sing-along songs and cheerful music. With
a motion sensor inside the activity panel, little ones will be rewarded as
they walk along while hearing fun songs, phrases and cheerful music.
Introduction
Spinning
flower mirror
On/Off/Volume
control switch
Handle
Roller ball
Play/Music
mode selector
Bee button
Sliding
caterpillar Sliding ladybug
Flipping
book page 2
Light-up
button

3
Battery Installation
INCLUDED IN THIS PACKAGE
- One Electronic Activity Panel
- One Main Walker Body
- Two Legs with Wheels
- One Walker Handle
- One User’s Manual
WARNING: All packing materials, such as tape, plastic sheets, packing
locks, wire ties and tags are not part of this toy, and should
be discarded for your child’s safety.
NOTE: Please keep user’s manual as it contains important
information.
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the
unit. Use a coin or a screwdriver to loosen the
screw.
3. Install 2 new ‘AA’ (AM-3/LR6) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• The use of new alkaline batteries is recommended for maximum
performance.
• Non-rechargeable batteries are not to be recharged.

4
• Rechargeable batteries are to be removed from the toy before being
charged (if removable).
• Rechargeable batteries are only to be charged under adult supervision
(if removable).
• Do not mix old and new batteries.
• Do not mix batteries of different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Only batteries of the same or equivalent type as recommended are to
be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• The toy is not to be connected to more than the recommended number
of power supplies.
• Do not dispose of batteries in fire.
WE DO NOT RECOMMEND THE USE OF RECHARGEABLE BATTERIES.
To ensure your child’s safety, this toy must be assembled by an adult.
Please ensure that the legs, handle and activity panel are securely
locked into position to avoid injury.
The activity panel can be used detached from the walker for sit-down play
or while attached to the walker. The activity panel has a convenient handle
for on-the-go learning fun.
ASSEMBLY INSTRUCTIONS
1. Push in and unscrew the two fasteners at the
top of the walker.
Battery Notice

5
2. Insert the legs into the slots with the wheels
facing outward, as shown in the diagram.
3. Gently pull the legs back until they click into
place. Please ensure the legs are fully inserted
into the slots.
4. Stand the walker upright and insert the handle
into the slots on the top to secure the legs.
5. Push and screw in the fasteners at the top of
the walker to secure the handle and legs.
Attaching/Removing the Activity Panel
1. To attach the activity panel, align the bottom of
the activity panel to the bottom of the walker.
Then push it back until you hear it click into
place. Please ensure the activity panel is
attached securely to the walker.
Assembly Instructions

6
2. To remove the activity panel, locate the red
release lock above Pooh’s head. Slide the lock
up and lift the activity panel, removing it from
the walker.
PRODUCT FEATURES
1. ON/OFF/VOLUME CONTROL SWITCH
To turn the unit ON, slide the ON/OFF/
VOLUME CONTROL SWITCH to the LOW
VOLUME ( ) or the HIGH VOLUME ( )
position.
To turn the unit OFF, slide the ON/OFF/
VOLUME CONTROL SWITCH to the OFF ( )
position.
2. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech®2-in-1 Baby Activity Walker’s
electronic activity panel will automatically power-down after
approximately 30 seconds without input. The unit can be turned on
again by pressing any button. Pushing the walker will not turn on the
activity panel.
3. PLAY/MUSIC MODE SELECTOR
Two modes of play include Play Mode and
Music Mode. Slide the PLAY/MUSIC MODE
SELECTOR on the activity panel to choose a
mode of play.
Product Features

7
ACTIVITIES
1. Slide the ON/OFF/VOLUME CONTROL
SWITCH to turn the unit ON. You will hear a
song, fun sounds and a phrase. The light will
flash with the sounds.
2. Press the BEE BUTTON to hear fun sounds and
phrases in Play Mode or a fun sound and a
melody in Music Mode. The light will flash with
the sounds.
3. Move the SLIDING CATERPILLAR to hear fun
sounds, a short tune and phrases in Play Mode
or a fun sound and a melody in Music Mode.
The light will flash with the sounds.
4. Press the LIGHT-UP BUTTON to hear a short
tune and fun phrases in Play Mode or a song
and melodies in Music Mode. The light will
flash with sounds.
5. Turn the FLIPPING BOOK PAGE to the right side
to hear a fun sound, a song about letters and
a melody. Turn the FLIPPING BOOK PAGE to
the left side to hear a fun sound, a song about
numbers and a melody. The light will flash with
the sounds.
Activities

8
6. Move the ROLLER BALL to hear fun sounds
and phrases in Play Mode or fun sounds and
a melody in Music Mode. The light will flash
with the sounds.
7. Turn the SPINNING FLOWER MIRROR to hear
fun sounds, phrases and melodies in Play
Mode or fun sounds and melodies in Music
Mode. The light will flash with the sounds.
8. Push the walker with the activity panel attached and turned on to
activate the MOTION SENSOR. You will hear fun phrases, songs,
a short tune and melodies. The light will flash with the sounds. The
MOTION SENSOR is located inside the activity panel.
9. When a melody is playing, press the buttons or move the features
to jam in fun sounds. Activate the MOTION SENSOR to jam in fun
sounds and phrases. Turn the FLIPPING BOOK PAGE to interrupt the
melody.
10. If there is no input after approximately 10 seconds, you will hear a
fun phrase and a short tune. After another 10 seconds of no input,
you will hear a song. If there is no input for a further 10 seconds,
Pooh will say “Good-bye” and the unit will go into sleep mode. The
unit can be re-activated by pressing any button or feature excluding
the motion sensor.
Activities

9
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to
moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit on. The unit should now be ready to play again.
5. If the product still does not work, replace with a new set of batteries.
If the problem persists, please call our Consumer Services Department at
1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, and a service
representative will be happy to help you.
Care & Maintenance/Troubleshooting