Vaporfi PULSE User manual

USER MANUAL

01
VAPORFI PULSE USER MANUAL
Thank you for purchasing the VaporFi Pulse Electronic Cigarette.
In order to use your electronic cigarette correctly, efficiently and
safely, please follow the instructions in this manual.

THE VAPORFI PULSE STARTER KIT INCLUDES:
» 2 Rechargeable Advanced Batteries (750 mAh)
» 2 Premium Tanks
» 1 Wall Charging Adaptor
» 1 Cordless Charger with USB
» 1 User Manual

03
GETTING STARTED
1. Unscrew the mouthpiece in order to fill the tank with e-liquid (see page 4).
2. Point and pour e-liquid into the sides of the tank. Fill to about 75% capacity of the tank.
(DO NOT OVER-FILL OR POUR E-LIQUID INSIDE OF THE CENTER TUBE)
3. Screw the mouthpiece back onto the tank.
4. Screw the tank onto the battery.
5. Do not over tighten parts, but ensure that all parts are securely assembled.
6. Quickly press down and release on the battery’s power button 5 times within 2 seconds
to turn on your battery.
7. To use, press down and hold the power button while you take a puff. Release the button
when you have finished puffing and enjoy!

REFILLING E-LIQUID
When you have about 25% of e-liquid remaining or you experience
a slightly burnt taste, you will need to refill your tank with e-liquid
1. Always remove the battery from the tank before refilling with
e-liquid. When unscrewing your tank from your battery, always
turn your device sideways, hold the steel cap located on the tank
and unscrew the battery counterclockwise.
2. Unscrew and remove the mouthpiece in order to fill the tank.
3. While holding your tank, lightly press down on the atomizer head
with your thumb, point and pour e-liquid into the sides of the
tank. Fill to about 75% capacity of the tank. (DO NOT OVER-FILL
OR POUR E-LIQUID INSIDE OF THE CENTER TUBE)
4. Screw the mouthpiece back onto the tank.

05
CHANGING YOUR ATOMIZER HEAD
Once you experience a burnt taste, a decrease in flavor or vapor production, it may be
time to replace your atomizer head. It is recommended to change your atomizer head once
every 1-4 weeks (depending on use).
To get the truest flavor from your e-liquid, we also suggest changing your atomizer head
when switching e-liquid flavors.
1. Before replacing your atomizer head, make sure your tank does not contain any e-liquid.
2. To replace your atomizer head, unscrew and remove the mouthpiece of the tank by
gripping the mouthpiece and turning it counterclockwise.
3. Grab the rubber seal located at the top of the atomizer and pull and remove the atomizer
head.

4. Once the old atomizer has been removed, push and connect the new atomizer head.
5. Screw the mouthpiece back onto your tank by turning it clockwise. Make sure not to over
tighten.

07
BATTERY OPERATION
TURNING BATTERY ON/OFF
» To turn the battery on, quickly press and release the power button 5 times within 2
seconds. The power button will flash 3 times to indicate that the device is ready for use.
» To turn the battery off, quickly press and release the power button 5 times within 2
seconds. The power button will flash 5 times to indicate that the device has turned off.
POWER SAVING SAFETY FEATURE
» If the battery’s power button is continuously pressed and held for 10 seconds, the
battery will flash 3 times and go into standby mode (hibernating). To continue use of the
device after the battery hibernates, simply press the battery’s power button and use as
normal.

CHARGING BATTERY
1. The LED display indicates how much battery capacity is available and when the battery
will need to be recharged.
2. Connect the circular charger to the USB charging cable.
3. Then connect the USB charging cable to either the USB port
located on the wall charging adapter or to a fully powered USB
port, such as on a computer.
4. Insert (do not screw) the battery’s end in the center hole of the
circular charger.
5. Once the battery is properly connected to the circular charger, the
LED lights on the battery will flash 3 times to confirm charging has
begun. The LED lights will remain off through the completion of the charge.
6. Allow 2.5 hours for your battery to complete charging.