Variquest Perfecta 2400PRO User manual

Perfecta® 2400PRO
Poster Design System
Assembly Instructions
Note:
• An A4/Letter sheet of paper (not included) is needed for
printhead alignment during set-up.
• LAN not included (needed if LAN connection required).
• Printhead already installed.
Contents:
1. Plastic bag which includes:
a. Assembly Instructions
b. Quick Start Guide
c. Power Cord
d. USB Cord
e. VariQuest Resource Center Registration Card
2. Printer w/ pre-installed introductory ink cartridges.
3. Automatic Sheet Feeder (packaged separately)
Unpack the Printer
1. Remove the plastic bag from on top of the printer.
2. Open the plastic wrap and remove the orange bands.
Open the aps widely.
3. Have two people, one person on each side of the
printer, lift the printer out of the box and onto a table.
Attention: Do not turn the printer upside down or on its
side because the ink may leak and cause damage to
the printer.
4. Slightly lift the printer and remove the foam end pieces
one-by-one.
Perfecta®2400PRO Assembly InstructionsPage 1
All manuals and user guides at all-guides.com

5. Remove the plastic covering.
6. Remove the tapes and desiccant bag.
7. Remove the 2 spindle tapes and retainers.
8. Open the front door. Rotate, and remove the pin.
9. Remove the cardboard.
10.Connect the power cable to the printer and outlet. Turn
on the printer.
11.The front panel will now guide you through printer
setup.
TECHNICAL SUPPORT
For technical assistance, please contact your
Authorized VariQuest Dealer or the VariQuest
Technical Support Team.
• Email: [e-mail]
• Phone: [phone]
Perfecta®2400PRO Assembly Instructions Page 2Y2901027 8/21 ©2021 Varitronics, LLC. All rights reserved.
All manuals and user guides at all-guides.com