Vaxcel T0076 Instruction manual

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0076
Dome
Parts:
140328
Parts Number (4996MM)
Wire Nut (B)
Metal Frame
Ball Nut Assembly (D)
Post Grounding Wire
Fixture Wire
Wire Nut (B)
Post
Fitter
Fixture Grounding Wire
Fitter Screw (A)
Bulb Type B Max.60W
(not included)
Fitter Screw (A)
Parts Number (9593CS)
Glass Panel (C) (X4)
Parts Number (4998SS)
Ball Nut Assembly (D) (X2)
Glass Panel (D)
Clip
Fig.1
Clip
Glass Panel
Clip
Glass Panel
Photocell
1. Take a glass panel and gently slide it into the frame in place, then press the clips which on the top
of the metal frame and the clips which on the bottom of the metal frame to secure them.(See Fig.1)
Repeat with other glass panels.
2. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the cross bar with the green grounding screw. Then connect
it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
IMPORTANT:
The sensor has an excellent photocell function to enable the light to turn on at dusk and off at dawn
automatically.

140328
A: 9"
B: 15-1/2"
A
B
3. Place the fitter on the post, then secure it with three fitter screws.
CAUTION: With silicone caulking compound, caulk completely around where the fitter meets
with the post surface to prevent water from seeping into the post.
4. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
5. Attach the dome to the metal frame, then secure it with the ball nut assemblies.
6. Turn on the power at the main fuse or circuit breaker box.
1. Turn off the power at the main fuse or circuit breaker box before starting installation.
2. Unscrew the hex nut and washer to remove the plate from the fixture.
2. Loosen the wire nuts connected with the wires from photocell. (See Fig.1)
Note: Do not move the photocell to prevent water from seeping into the post.
3. Take a white pigtail and black pigtail and make wire connections using wire nuts: (See Fig.2)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the post.
Photocell
White Wires From
Photocell
Wire Nuts
Black Wire From
Fixture
Wires From Fixture
Wires From
Main Power
Wire Nut
White Pigtail
Pigtail
Red Wires From
Photocell
Black Wires From
Photocell
Operation the Unit Without Photocell
Fig.1 Fig.2
White Wire From
Fixture
Hex Nut
Washer
Plate