Vaxcel T0541 Instruction manual

191127
W
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
Hardware Package (included):
Mounting Screw (B) Rubber Pad (E) Cross Bar Unit (A) Wire Connector (C) Bolt Nut (D)
T0541 / T0543
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.
Installation steps
1. Remove the two bolt nuts (D), the two rubber pads (E)
and the cross bar unit (A) from the backplate.
2. Attach the cross bar unit (A) to the outlet box using
two mounting screws (B). Adjust the length of the
preinstalled headless screws if necessary.
Note: Make sure that the headless screws are lined
up horizontally to make the fixture level.
Turn off the power at fuse or circuit box.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Wire Connector (C)
House Grounding Wire
Outlet Box
Mounting Screw (B)
Green Grounding Screw
Headless Screw
Cross Bar Unit (A)
Fixture Wire
Fixture Grounding Wire
Backplate
Bolt Nut (D)
Rubber Pad (E)
Socket
Glass Shade
Metal Frame
Set Screw x 3
Fixture
Max.60W Type T Bulb
(not included)

191127
3. Remove the three set screws and the metal frame from the fixture.
4. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
• Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
• Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
• Attach the fixture grounding wire (usually green insulation or bare wire) to the cross bar unit (A) with the
green grounding screw. Then, depending on local code connect it to the house grounding wire with the wire
connector (C).
Carefully put all of the wires back into the outlet box.
5. Attach the backplate of the fixture to the cross bar unit (A) by aligning and inserting the two headless screws from
the cross bar unit (A) into the open holes on the backplate, then place the two rubber pads (E) over the exposed
headless screws before screwing the two bolt nuts (D).
Note: With silicone caulking compound, caulk completely around where the backplate meets with the wall
surface to prevent water from seeping into the outlet box.
6. Install bulb (not included). See relamping label at socket area or packaging for maximum wattage allowed .
7. Attach the glass shade into the metal frame.
8. Attach the metal frame and glass shade to the fixture, then secure it with the set screws.
Turn on the power at fuse or circuit box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Hardware
6185MM (1SET)
T0541
Glass Shade
X1
10131CS
T0543
Glass Shade
X1
10132CS
Mounting Screw (B) Rubber Pad (E) Cross Bar Unit (A) Wire Connector (C) Bolt Nut (D)
Set Screw
6188SER
T0541
A: 12-1/2”
B: 7-1/2”
C: 9-1/2”
T0543
A: 16”
B: 9-1/2”
C:12”
A
B
C