Vaxcel T0165 Instruction manual

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0165
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
141204
Turn off the power at fuse or circuit box.
Fitter Screw(A) Wire Nut(B)
Grounding Wire
Fixture Wire
Wire Nut (B)
Post
Fitter Screw(A)
Metal Frame
LED 6W
Photocell
Fitter
Screw
Glass Shade
Clip
Cover
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
1. Place the glass shade into the metal frame carefully, and then secure it by pressing the clips from the top side. (See Fig.1)
2. Attach the cover to the metal frame and secure it with two screws.
3. Pull out the source wires from the post. Make wire connections using wire nuts as follow:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the post.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the post.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the grounding wire from the post.
Carefully put the wires back into the post.
4. Place the fitter on the post, then secure it with the fitter screws.
CAUTION: With silicone caulking compound, caulk completely around where the fitter meets with the post
surface to prevent water from seeping into the post.
Turn on the power at fuse or circuit box.
Installation Steps
Metal Frame
Glass Shade
Fig.1
Clips

The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit
5167MM (1 SET) Glass Shade
9646CK
Fitter Screw(A) Wire Nut(B)
A: 8"
B: 16"
141204