Vaxcel T0503 Instruction manual

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
.stnemeriuqergnidnuorgdnagniriwrofsedoclacirtcelelacoltlusnoc,gnillatsnierofeB.1:SETON
2. READ AND SAVE THESE INSTRUCTIONS.
T0503
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
Turn off the power at fuse or circuit box
Turn on the power at fuse or circuit box
Installation Steps
181212
1. Unscrew the metal frame and the set screws on
the bottom frame. (Fig.1)
2. Make the bottom of the fixture upward, gently
place four glass panels into the metal frame,
then press the clips to secure the glass panels. (Fig.2)
Wire Connector (B)
Fitter Screw (A)
Fig.2
Glass Panel
Clip
Metal
Frame
Grounding Wire
Fixture Wire
Wire Connector (B)
Post
Fitter
Glass Panel
Metal Frame
Photocell
Fitter Screw (A)
3. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.
4. Pull out the wires and grounding wire from the post. Make wire connections using the wire connectors (B):
---The black wire from the fixture to the black wire from the post.
---The white wire from the fixture to the white wire from the post.
---The grounding wire from the fixture to the grounding wire from the post.
Carefully put the wires back into the post.
5. Place the fitter on the post, then secure it with the fitter screws (A).
CAUTION: With silicone caulking compound, caulk completely around where the fitter meets with the post
surface to prevent water from seeping into the post.
Fig.1
Metal
Frame
Set Screw
Fitter
Bottom
Frame
Bulb Type A Max.60W
(not included)

Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
181212
A:8"
B:18"
1. Turn off the power at the fuse or circuit box before starting installation.
2. Unthread the fitter screw and plate, and then Loosen the wire connectors connected with the
wires from photocell. (See Fig.3)
Note: Do not move the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire connectors (B) : (See Fig.4)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the back plate of the fixture.
Operation the Unit Without Photocell
Photocell
White Wires From
Photocell
Wire Connector
Wire Connector (B)
Black Wire From
Fixture
Wires From Fixture
Wires From
Main Power
White Pigtail
Pigtail
Red Wires From
Photocell
Black Wires From
Photocell
Fig.2 Fig.4
White Wire From
Fixture
Plate
Fitter Screw
Photocell
Wire Connector
Black Wire From
Fixture
White Pigtail
Fig.3
Plate
Washer
Hex Nut
Assembly Kit
6054MM (1SET)
Spare Parts List:
Glass Panel
10071RG (4PCS)
Wire Connector (B)
Fitter Screw (A)
B
A