VERITAS 5250 Manual

Removing and replacing a bezel: Veritas appliance
Document Number: 315
Version: 1.0 (05/04/2020)
Purpose
This document describes the process for removing and replacing the bezel for the Veritas 5250
appliance.
Affected appliance models
• 5250 Appliance
Electrical Safety
The static discharged by human bodies can damage static-sensitive components on the boards.
When installing and maintaining the equipment, observe appropriate electrostatic safety precautions
to prevent personnel injuries or device damage.
When operating a device in an electrostatic sensitive area, you must take electrostatic-discharge
(ESD)-preventive measures. These include wearing ESD-preventive gloves, an ESD-preventive wrist
strap, and ESD-preventive clothes to avoid personnel injury or device damage.
To prevent damage to the device, pay attention to the following during operations:
• Do not touch devices with bare hands because ESD from the human body may damage the
electrostatically sensitive elements on a board.
• When dealing with the server or any of the internal components, wear an ESD-preventive wrist
strap, ESD-preventive gloves, and ESD-preventive suit.
About removing the appliance bezel
This document describes how to remove and replace the 5250 Appliance bezel.
This procedure can be accomplished with the appliance installed in the rack.
Requirements
Verify that you have the following items:
1
Veritas Appliance
Hardware Service Procedure

• Veritas 5250 Appliance replacement bezel
• ESD wrist strap
Removing the appliance bezel
To remove the bezel appliance bezel
1Locate the Veritas 5250 Appliance with the bezel that you want to replace.
2Unlock the bezel with the key. Gently grasp and pull the left side of the bezel towards you, and
slide it out from the right rack handle.
Replacing the appliance bezel
To replace the appliance bezel
1Remove the replacement bezel from the box.
With the front of the bezel facing you, locate the two protruding latches along the bezel's right
edge. The latches snap into the latch holes on the left side of the appliance control panel.
2At a slight angle, slide the right side of the replacement bezel and its latch into the appliance's
right rack handle. Be cautious of the bezel hitting against the power button and disrupting the
operation of the appliance.
2
HSP #315: Bezel removal and replacement: Veritas Appliance

3Finally, push the left side of the bezel towards the chassis and lock the bezel using the key.
3
HSP #315: Bezel removal and replacement: Veritas Appliance