VEVOR 451P User manual

HANDHELD DIGITAL ENDOSCOPE
USER MANUAL

HANDHELD DIGITAL
ENDOSCOPE
Installation Instruction
Model: 451P
Have product questions? Need technical suppo?
Please feel free to contact us:
CustomerSe[email protected]
NEED HELP? CONTACTUS!
This is the original instruction, please read all manual
instructions carefully before operating. VEVOR resees
clear interpretation of our user manual. The appearance of
the product shall be subject to the product you received.
Please forgive us that we won't inform you again if there
are any technology or software updates on our product.
0101

SAFETY WARNING
Please read the following instructions carefully and save
this manual.
Failure to follow the instructions listed in this manual may
result in electric shock, re, or serious personal inju.
WELCOME
Thank you for choosing our product. Please read the
instructions carefully before use.
This product is a new type of practical device that can view
videos in real-time video, record, and takes pictures. Mainly
used in areas where the line of sight cannot be obseed,
such as: car repair, sewer inspection/maintenance, air
conditioning inspection, etc.
FEATURES
1. 4.5-inch color high-denition IPS screen
2. 1080P HD image
3. 360° image rotation
4. TF card can be installed to achieve le storage function.
Maximum suppo 32GB.
5. 8mm HD camera
6. Front lens clear viewing range from 3cm to 10cm
7. Type-c plug-in, easy to replace dierent lenses
8. 8 adjustable LED lights
9. IP67 waterproof
8
02

APPLICATION
It is widely used in aviation, automobiles, ships, electrical,
chemical, electric power, natural gas, atomic energy,
civil engineering and construction. Industrial endoscopes can
also monitor, record, store and analyze targets.
ACCESSORIES LIST
1. Digital endoscope
2. Manual
3. USB data cable
4. Accessories - Hook, magnet, protective cap
FEATURES
(1) Pa Name And Function
03

04
Camera
Cable
Settings button
Light adjustment
Reset button hole
Micro TF card slot
Charging indicator Unlock switch
4.5 inch IPS screen
Back button
Down
OK
Up and rotate
Take pictures
DC 5V/1A charging po
(2) Function Introduction
1. Micro TF card slot: Suppos up to 32GB Micro TF card,
Only suppos TF cards with class 10 or higher FAT32
format( equipped with this product ).
2. Micro po: 5V/1A power supply.
3. Power button: Long press for 3 seconds to turn on or o
the device.
4. Photo button: Sho press to take a photo.
5. Video button: Long press to sta recording, press again to
stop recording.
6. Setting button: Sho press to enter the menu page, where
you can set the Resolution / Language settings /
Date&time / Date label / Brightness / Screen protector /
Automatic shut-down / Format / Default settings / Version.
7. Up button: Image mode is a rotation function.
Other modes are left or up movement.
8. OK button: Sho press to conrm.
9. Back button: Sho press to return to the previous menu.
10. LED brightness adjustment button: Camera rightness is
divided into three levels.
11. Indicator light: The charging indicator light is always on
and the light becomes green when fully charged.

05
INSTALLATION NOTES
(1) Installation Hose
(2) Installation Accessories
Inse the Type-C inteace into the display screen
How to install the three accessories?
The protective cap, hook, and magnet can be installed
similarly.
Push the buckle forcibly
Inse the cable into
the inteace slot

06
Magnet Hook Protective
cap
STEPS FOR USAGE
(1) Basic Operation
1. Inse the Micro TF card (not equipped with this unit) into
the Micro TF card slot; Press gently until the card is locked
(note: the class 10 Micro TF card must be inseed to
record and store pictures and videos). To prevent data
loss or damage, power o the device before inseing or
removing the memo card
2. When turning it on, press the LED brightness adjustment
button to adjust the brightness of the camera.
TF card
3. Sho press the camera button to take a photo, long press
the video button to record.
STEPS FOR USAGE
When the batte is low, inse the miniature end of the data
cable into the charging po at the bottom of the fuselage,
and then plug the other end of the power adapter into the
standard AC outlet.

07
The charging indicator light is always red when charging, and
it lights up green when fully charged. The charging time is
4 to 5 hours.
TECHNICAL PARAMETERS
Product name
Monitor
Lens Angle
Language
Line length
Focal Length of
Three Lenses
Waterproof level
Lens diameter
Batte capacity
Batte endurance
Industrial endoscope
4.5-lnch IPS screen,
Screen Resolution: 854 x 480
Each of the three lenses is 70°
Lens Resolution 1920 x 1080
English, German,
Simplied Spanish, French,
Russian, Japanese
5m
Front: 3-10cm, Side B: 2-6cm,
Side C: 2-6cm
IP67 (only for lens/line)
8mm
2860mAh
About 3.5 H
TROUBLE SHOOTING
Device cannot be
turned on.
Problem
TF card reading
failed.
Solution
The batte is low, charge ttie machine for
about 4-5H, resta.
1. TF card format is incorrect? (This device
only suppos FAT32 le format).
2. Reinse after removing the TF card.

08
After ttie device is
connected to the PC,
the TF card cannot
be read.
1. Reconnect the device and PC.
2. Conrm whether to enter the Mass
storage mode.
Problem Solution
Device crash.
First, inse the USB data cable to charge
the product. It will automatically shut down.
Then, press the power button to reset.
It can be reset by lightly pressing the reset
hole with a ne needle.
Smudges or smears
are present on the
screen.
Wipe the screen and lens gently with a
clean cloth dipped in alcohol.
Cannot charge or
the charging indicator
does not light up.
Please replace ihe charging cable.
FCC INFORMATION
This device complies with Pa 15 of the FCC Rules.
Subject to the following two conditions：
1. This device does not cause harmful inteerence.
2. This device must accept any inteerence received,
including inteerence that may cause undesired operation.
Changes or modications not expressly approved by the
pay responsible for compliance could void the user's
authority to operate the equipment.
EU ENVIRONMENTAL PROTECTION
1. Waste electrical products should not be disposed of with
household waste.
2. Please consult your local government or retailer for
recycling advice.
3. lf the number contained in the user manual has any minor
changes without prior notice.

09
Waste electrical products should not be disposed
of with household waste.
Please consult your local government or retailer
for recycling advice.
* There are any minor changes to the numbers included in the user
manual without prior notice.
EU Impoer: WAITCHX
Address: 250 bis boulevard Saint-Germain 75007 Paris
UK Impoer: FREE MOOD LTD
Address: 2 Holywell Lane, London, England, EC2A 3ET
Add: 1301#Block 3,Tian'an Yun Gu Industrial Park,
Bantian Longgang District,Shenzhen City,China
EU ENVIRONMENTAL PROTECTION
UK REP
EUREP GmbH
Unterlettenweg 1a, 85051 Ingolstadt,
Germany
EC REP
EUREP UK LTD
UNIT 2264, 100 OCK STREET, ABINGDON
OXFORDSHIRE ENGLAND OX14 5DH