Videx 6200 Series User manual

QG_6272_V.1.0_11/14
TECHNICAL SUPPORT
Tel: [phone]
Fax: [phone]
Email: [e-mail]
Web: www.videx-security.com
The Power to Secure
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
6272
Colour screen videophone
QUICK GUIDE
OVERVIEW
RECEIVING A CALL
OPEN THE DOOR
ART. 6272
Intelligent videophone incorporating a 3.5” Hi-Res full colour active
matrix LCD monitor, with “camera recall”, “door open/concierge call”, 2
“service” buttons plus 2 LEDs one for generic use (door opening usually)
and one to indicate privacy service enabled.
Programmable settings: video mode (coax or balanced), melody and
number of rings.
Adjustments: call tone volume (2 levels plus privacy position), microphone
volume, picture hue, contrast and brightness.
During a call
LCD color screen Headset
Privacy activation and
Ring volume adjustement
Privacy actived LED
Open Door button
Service button 1
Service button 2
Open Door LED
Brightness display adjustement During a
conversation
To answer to a call it’s enough to release the handset.
Press to open the door. The lightened red LED under
the symbol indicates
that the door is open
(if connected during the
installation).
‘Camera Recall’ button

zZz
zZz
zZz
zZz
zZz
zZz
zZz
zZz
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
SERVICE BUTTON
PRIVACY SERVICE
CAMERA RECALL
When the
system is in
stand-by
When the
system is in
stand-by
RING VOLUME ADJUSTEMENT BRIGHTNESS DISPLAY ADJUSTEMENT
During a call, a
conversation or on
camera recall mode
In every
situation
In every
situation
During an incoming
call, with the service
enabled, the device
does not emit any
acoustic signal
To set the service buttons, please contact a technical
personnel.
To set up the service turn the volume switch of the call
tone to the left.
The LED under the symbol the will illuminate.
To stop the service turn the switch to the centre or the
right and wait for the expire of the programmed time.
The LED expires.
During the ‘Camera Recall’ it’s possible:
To release the handset to begin the conversation;
To push to open the door;
To push to set up the secondary service
Hang up the handset to close the conversation.
When the planned time,
established during the
installation, is over, the
service stops and the
system returns to the
standby position.
Push or to set up the correspondent
secondary installed services.
Push to set up the ‘Camera Recall’.
The display shows the picture recorded with the
camera on the outdoor station.
Move the switch, under the symbol to the centre
for a lower volume and to the right for a higher volume.
The position on the left sets up the privacy service.
Turn the roller under the symbol to the left to
reduce and to the right to increase the brightness.