Villeroy & Boch TVS00036150061 User manual

Universal valve 1-function
VILLEROY-BOCH.COM
DE Montageanleitung IT Instruzioni di montaggio
EN Installation Instructions NL Montage-instructie
ES Instrucciones de montaje PL Instrukcja montażu
FR Instructions de montage ZH 装配说明

2www.villeroy-boch.com // V 1.0 // 19.05.2017 //
TVS00036150061 Universal valve 1-function

www.villeroy-boch.com // V 1.0 // 19.05.2017 // 3
Notes prior to installation
1. Inspect all parts prior to installation for suitability and/or defects.
2. Any suspected defect should be reported as soon as possible.
3. Should any product be installed despite a fault having been found
and reported, Argent will not accept liability for the cost of labour
to remove and install any replacement product/s.
Notes for installation
1. Please ensure pipework is clear of debris by flushing lines prior to installation.
Pressure and temperature requirements
1. Inlet pressure range: 100 - 500 kPa
2. Maximum hot water temperature: 60 °C
3. AS/NZS 3500 requires 500 kPa maximum operating pressure at any outlet within a building.
4. Hot & cold inlets should have equalised water pressures.
Cleaning and maintenance
•The special chrome finish only requires cleaning with mild household detergent and drying with a
clean cotton cloth to retain its lustrous shine.
•Avoid cleaning with abrasive materials or cleaners.

4www.villeroy-boch.com // V 1.0 // 19.05.2017 //
Based on the size of the body and
the wall type, either secure it to
the noggins or embed it into the
wall at an approximate height of
1100 mm.
Installation depth of body
max. 67 mm, min. 47 mm.
Ensure that body is installed level,
plump and square.
Connect the hot (LHS) and the
cold (RHS) supply and the mixed
water pipe using applicable sealing
practices. Remove the plastic tiling
template and test for water security
with the mixer in both open
and shut positions, replace the
template.

www.villeroy-boch.com // V 1.0 // 19.05.2017 // 5
Either sheet around the mixer
body with fibre cement sheeting or
backfill the exposed channels ready
for tiling.
Ensure tiles are cut as close to
the plastic template covering the
mixer dome as possible: remove
the plastic template after the tiling
is complete.
Install the trim cover plate over the
dome.
Install the lever securing it with the
grub screw provided.

6www.villeroy-boch.com // V 1.0 // 19.05.2017 //