Vision Fitness E3600HRC User manual

MODEL E3600HRC FITNESS BIKE
FITNESS
VISION
Guide
Assembly

upright fitness cycle
E3600HRC
1
STEP
2
STEP
3
STEP
4
STEP
5
STEP
To avoid possible damage to this Fitness Cycle, please follow these assembly steps in the correct order. Before proceeding though,
enter your new Fitness Cycle’s serial number here:
Refer to this number when calling for service, and also enter this serial number on your Warranty Card and in your own records.
Be sure to read your Owner’s Guide before using your new Fitness Cycle.
If any parts, hardware or tools are missing, please call 1.800.335.4348, Extension 12
NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your Fitness Cycle, to prevent
loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt.
Before you begin…

3
BLACK BAG
20MM L x 8MM D Bolt
Quantity: 4
ORANGE BAG
60MM L x 8MM D Bolt
Quantity: 2
BLUE BAG
20MM L x 8MM D Bolt
Quantity: 4
M8 x 1.5T Washer
Quantity: 4
HARDWARE INCLUDED
M8 x 1.5T Washer
Quantity: 2
5MM Allen Wrench
13MM Wrench
Screwdriver

4
2
STEP
• Slide the rubber cover onto the con-
sole mast.
• Unfold the wire and attach it to the
string located inside the mast. Guide
the wire up through the mast while
simultaneously sliding the mast onto
the frame bracket.
• Bolt the mast to the frame using the
two bolts and two washers; make sure
these are tight!
• Slide the rubber cover down over
the bolt heads.
ORANGE BAG
1
STEP
• Install the rear foot with the four
bolts, using the Blue 5MM Allen
wrench.
BLACK BAG 1
STEP
2
STEP

5
3
STEP
• Feed the handlebar wires through
the small hole in the front of the
console mast, then up and out the top
of the console mast. Mount the upper
handlebars to the console mast using
the four bolts and four washers.
BLUE BAG 3
STEP
4
STEP
• Remove the four screws from the
back of the console. Plug the wire
connectors from inside the mast into
the console. The cable connectors are
slotted, so do not force them!
• Mount the console to the mast using
the four screws. Do not pinch the
cable!
CONSOLE 4
STEP

6
5
STEP
5
STEP
• Slide the seat post down through
the rubber cover and into the frame.
The seat height numbers should be
facing the right-hand side of the bike.
SEAT POST
621-D East Lake Street • P.O. Box 280 • Lake Mills. WI 53551
toll free 1.800.335.4348 • phone [phone] • fax [phone]
www.visionfitness.com
1999 Vision Fitness. All Rights Reserved. 7.99 Part #Z66EP05-001