Vivo DESK-E143TB User manual

Black 43" x 24" Electric Desk
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
Instruction Manual
https://vivo-us.com/products/desk-e143tb
SKU: DESK-E143TB
[email protected]om www.vivo-us.com 309-278-5303
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

2
If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualified technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specified in this manual and do not exceed weight capacity. We cannot be liable for damage
or injury caused by improper mounting, incorrect assembly, or inappropriate use.
WARNING!
PACKAGE CONTENTS
A (x1)
Non-motorized
Leg
B (x2)
Foot
C(x2)
Side Bracket
D(x1)
Motorized
Leg
E(x1)
Support Bar
F (x1)
Crossbar
G (x1)
Desktop
(Back)
I (x1)
Sync Rod
J(x3)
Connecting
Plate
K(x1)
Adapter
Holder
ELECTRICAL SAFETY INSTRUCTIONS
THIS PRODUCT IS POWERED BY ELECTRICITY. IN ORDER TO AVOID BURNS, FIRE AND ELECTRIC
SHOCK, PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY.
• DO NOT CLEAN PRODUCT WHILE POWER IS CONNECTED.
• DO NOT DISASSEMBLE OR REPLACE COMPONENTS WHILE POWER IS CONNECTED.
• NEVER OPERATE THE SYSTEM WITH A DAMAGED CORD OR PLUG. PLEASE CONTACT YOUR
SELLER TO REPLACE DAMAGED PARTS.
• NEVER OPERATE SYSTEM IN DAMP ENVIRONMENTS OR IF ANY ELECTRICAL COMPONENTS HAVE
MADE CONTACT WITH LIQUIDS.
• ALTERATIONS OF THE GIVEN POWER UNIT ARE NOT ALLOWED.
• OUTDOOR USE IS PROHIBITED.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
L (x1)
AC Adapter
M (x1)
Power Cord
N (x1)
Controller
S-A (x4)
M6x12
S-B (x8)
M6x16
S-C (x8)
M6x35
S-D (x4)
M5x60
S-E(x4)
M6x30
H (x1)
Desktop
(Front)
S-F(x18)
ST4.2x13
S-G (x5)
ST3.5x13
S-H (x10)
Silicone Pad
S-I (x8)
D6 Washer
S-J (x3)
Cable Clip
S-K(x1)
4mm Allen Wrench
S-L (x1)
8mm Allen Wrench
S-M (x4)
Wooden Dowel
Pin

3
ASSEMBLY STEPS
STEP 1
Assemble the feet (B) to
the motorized and non-
motorized legs (A, D) using
M6x16 bolts (S-B). The longer
end must be facing forward
as shown. Assemble the side
brackets (C) to the legs using
M6x30mm bolts (S-E), making
sure the arrow and long end
is facing the same direction
as the feet. Tighten with the
4mm Allen wrench (S-K).
110lbs
(50kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
TOOLS NEEDED
Phillips
Screwdriver
Drill
Level

4
STEP 2
STEP 3
Attach the support bar (E) to the back of the legs using M6x12 bolts (S-A), and the crossbar (F) to the
side brackets using M5x60 bolts (S-D). Tighten with the 4mm Allen wrench (S-K).
Loosen both knobs on the sync rod (I) and slide the right end socket onto the hex rod for the
motorized leg (D), making sure the sync rod meets the red bumper on the motor hex sha. While
holding the sync rod with one hand, extend the hex sha into the non-motorized leg (A), using the
8mm Allen wrench (S-L) to align the le end socket if needed and making sure the red bumper on the
hex sha is contacting the leg. Tighten both knobs.

5
STEP 4
STEP 5
Hang the Adapter Holder (K) over the Crossbar (F) and tighten thumb screws. Remove adhesive
protection film from the Silicone Pads (S-H) and place pads on the assembly as shown. Join the
desktop halves (H,G) with Wooden Dowel Pins (S-M) until there is no gap between halves, then attach
Connecting Plates (J) using ST4.2x13 Screws (S-F) and tighten with a Phillips screwdriver. Assemble
desktop to desk frame using M6x35 bolts (S-C) and D6 Washers (S-I), making sure the controller
mounting holes on the front desktop (H) are facing forward, and tighten with a Phillips screwdriver.
Mount the control panel (N) to the front desktop (H) using ST3.5x13 Screws (S-G) and tighten with a
Phillips screwdriver.

6
STEP 6
STEP 7
Connect the AC Adapter (L) and motor cable to the Controller (N). Connect Power Cord (M) to the AC
Adapter (L). Organize cables using the adhesive Cable Clips (S-J). The cable clips may optionally be
secured using ST3.5x13 Screws (S-G) and a Phillips screwdriver.
If necessary, adjust the foot pads on the bottom of the Feet (D) to level the desk.

7
CAUTION!
Failure to follow these instructions may result in property damage and/or personal injury.
Do not exceed desk
weight limit.
Keep area of vertical
motion free of
obstacles.
Keep weight on desk
balanced for correct
operation and longer
life of components.
Leave enough slack in
cables to allow for full
range of vertical motion.

LAST UPDATED: 01/08/2021
Open Monday - Friday 7:00am - 7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times. If any
parts are received damaged or defective, please contact us. We are happy to replace parts to
ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
[email protected] AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
AVG. RESOLUTION TIME (within oice hrs): < 15 M
www.vivo-us.com
Chat live with an agent!
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
309-278-5303