Vivo DESK-V000G User manual

Sit to Stand Desk / Workstation
DESK-V000G
[e-mail]
Assembly Instructions
Model: DESK-V000G

UNPACKING INSTRUCTIONS





 

IMPORTANT SAFETY INFORMATION



!"#

"$


Scan our QR code below with your mobile device
or go to the link for our installation video
https://vivo-us.com/collections/sit-stand-desk-
converters/products/desk-v g

Supplied Parts Tools
required
O

Connect “L” Plate to Keyboard Tray
1. Install the Clamp Brace(C) to the Pole(A)
using 3 M5x14 Bolts(F). See figure 1.
2. Install the Clamp(B) to the pole
assembl according to the thickness of the
desktop. The thickness can be changed to 3
positions. Connect using 2 M8x12 Bolts(G)
and tighten using the Allen Ke (O). Tighten
the Clamp to the desktop using the plastic
knob. See figure 2.
Step 1
Option A Desk Clamp Install
Existing Grommet Hole Installation
If the existing grommet hole comes with a
plastic protector, remove it to ensure a flat
surface before installing the desk mount.
1. Install the Grommet Base Plate(M) to the
Pole(A) using 3 M5x14 Bolts(F). See figure 3.
2. Position the Pole(A) on the mounting
surface and secure using the Support
Plate(J), M10 Washer(K), Spring Washer(L)
and M10 Bolt(I). Fasten the M10 Bolt using
provided Wrench(P). See figure 4.
Option B Grommet Base Install
Attach Square Pads to Back of Keyboard Tray
Step 2
Attach the “L” Plate(e) to the
back of the keyboard tray(c)
with M6x12 Bolts(g) and
tighten using Allen Key(p).
Peel backing from
Square Pads(n) and
apply to back of
Keyboard Tray(c).

Step 3 Connect L Plate to Gas Spring Arm
LEFT RIGHT
Choose lever location

Step 4 Connect Gas Spring Arm to Monitor Platform
Step 5 Attach Lever to Back of Monitor Platform
Attach Gas Spring
Arm(d) to Monitor
Platform(a) using
M6x12 Bolts(h).
Attach the lever to
Monitor Platform(a)
using M6x35
Bolts(j) and
Spacers(k).

Step 6 Connecting Base to Gas Spring Arm
Step 7 Attach Round Pads to Back of Base
Attach Base(b) to Gas
Spring Arm using M6x28
Bolts(i) and tighten with
Allen Key(p).
Peel backing from Round
Pads(o) and apply to
back of Base(b).

Step 8 Attach Wrist Pad to Keyboard Tray
Step 9 Operating the Lever to Loft or Lower the Desk
Peel backing from
adhesive pads on Wrist
Pad(f) and press into place
on the Keyboard Tray.

Adjusting the Tension of the Desk
Step 10
Manage cables and store the Allen Ke s(O) in Wire Clip(N1) for future use
Still ave questions?
Please contact us for assistance
Email: [e-mail]
Live Chat: www.vivo-us.com
Phone: [phone]
For more VIVO products please visit us at
WWW.VIVO-US.COM