Vivo DESK-V402P User manual

Pink Kids’ Deluxe Height Adjustable Desk and Chair
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
Instruction Manual
https://vivo-us.com/products/desk-v402p
SKU: DESK-V402P
[email protected]om www.vivo-us.com 309-278-5303

2 3
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
inappropriate use.
WARNING!
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
• NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF DESK OR CHAIR
• USE TIPOVER RESTRAINT OR ANCHOR DESK TO WALL
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIPOVER.
PACKAGE CONTENTS
A1 (x12)
Plastic Washer
A2 (x8)
Short Bolt
A4 (x4)
Lock Nut
A5 (x4)
Long Bolt
A6 (x2)
Knob
A3 (x4)
Screw
A8 (x1)
Hook
B1 (x1)
Chair Leg
B2 (x1)
Center Bar
B3 (x1)
Rear Support Bar
B4 (x1)
Plastic Seat
Bottom
B5 (x1)
Plastic Seat
Back
B6 (x1)
Desk Leg
B7 (x1)
Desk Support
Bar
A7 (x1)
Allen Wrench
B8 (x1)
Desk
ASSEMBLY STEPS
STEP 1
Mount plastic seat bottom (B4) to assembled frame using 4 plastic thread screws (A3).
Tighten with Phillips screwdriver.
STEP 2
Attach rear support bar (B3) to back of chair legs (B1)
using 4 short bolts (A2) and 4 plastic washers (A1),
leaving the bolts slightly loose. Place center bar (B2)
into large holes on le and right chair legs (B1), then
tighten bolts on rear support bar using the Allen
wrench (A7).
TOOLS NEEDED
Phillips
Screwdriver
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
50lbs
(22.68kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury. 150lbs
(68.04kg)
DESK CHAIR
NOTE: Not all hardware included will be used.
B9 (x1)
Lamp
B10 (x1)
Book Stand
B1
B3
B2
A1x4
A2x 4
A7
h
h
B4
A3x4

4 5
STEP 3
Secure seat back using knobs (A6).
STEP 5
Adjust chair feet to sit level if needed.
STEP 6
STEP 4
STEP 7
STEP 8
Adjust legs to equal height using the indicators on the sides as a reference, then place desk (B8) on
legs.
Loosen knobs on sides of desk to raise the desktop,
then secure desk to frame using 4 long bolts (A5) with
4 plastic washers (A1) and 4 lock nuts (A4), and tighten
with the Allen wrench.
Slide plastic seat back (B5) onto chair
frame, aligning upper or lower holes
in seat back with screw holes in frame
depending on the needed height.
Attach desk support bar (B7) to back of desk legs (B6) using 4 short bolts (A2) and 4 plastic washers
(A1), then tighten bolts on rear support bar using the Allen wrench (A7).
STEP 9
Squeeze sides of hook (A8) and fit into slot on
le or right side of desk.
B5
A
B
or
A6 x2
B6
B7
A7
A1x4
A2x4
B8
H
H
54
56
58
60
54
56
58
60
A7
A5x4
A1x4
A4x4
A8

6 7
STEP 10
STEP 11
Adjust desk feet to sit level if needed.
Loosen knobs on sides of desk to adjust
desktop tilt angle, and tighten knobs to
secure position.
Step 13
Raise: Loosen knobs/screws on back of desk/chair legs. Step on support bar with one foot and pull up
with even motion on both sides until the desk/chair reaches desired height. Tighten knobs or screws.
Lower: Loosen knobs/screws on back of desk/chair legs. Step on support bar with one foot and pull up
with even motion until the desk/chair reaches max height, then fully lower. Tighten knobs or screw
STEP 12
Raise desktop slowly
to keep items stable.
Keep monitor and laptop
base fully on the desktop.
CAUTION!
Failure to follow these instructions may result in property damage and/or personal injury.
Place lamp (B9) into le side hole in desktop,
and book stand (B10) into center hole.
Connect power adapter to lamp and plug into
wall outlet.
Lamp Operation. Touch power button to turn
lamp on. Touch button again repeatedly to
change brightness (low, medium, high). To
turn lamp o, hold power button.
0˚- 50 ˚
300-440mm
540- 720m m

LAST UPDATED: 09/16/2019
Open Monday-Friday from 7:00am-7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times.
If any parts are received damaged or defective, please contact us.
We are happy to replace parts to ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
[email protected]
www.vivo-us.com
309-278-5303
AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
AVG. RESOLUTION TIME (within oice hrs): < 15 M