2 3
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual
and do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly, or inappropriate use.
PACKAGE CONTENTS
33lbs
(15kg)
ASSEMBLY STEPS
STEP 1
Apply Pads (D) to underside of Keyboard Tray (B). Assemble Stopper (C) to Kayboard Tray (B) using
ST4.2x12mm Screws (S-A) and a Phillips screwdriver.
WARNING!
A (x1)
Desk
B(x1)
Keyboard Tray
S-A (x2)
ST4.2x12mm Screw
F (x2)
Cable Clip
D (x3)
Pad
E (x4)
Rubber Feet
STEP 3
Apply Cable Clips (F) to underside of Desk (A).
STEP 5
STEP 6
Raise Desk (A) by liing the handle on
the right side of the frame.
TOOLS NEEDED
Scissors
Raise desktop
slowly to keep
items stable.
Keep monitor and
laptop base fully on
the desktop.
Leave enough slack
in cable to allow for
full range of vertical
motion (15” / 38 cm).
Follow the cable
routing instructions to
avoid the potential to
pinch cables.
CAUTION!
Failure to follow these instructions may result in property damage and/or personal injury.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Phillips
Screwdriver
STEP 2
Install Rubber Feet (E)
to the bottom of Desk
(A). Then cut the large
shipping tie.
NOTE: DO NOT squeeze
the handle on Desk
(A) while cutting the
shipping tie.
STEP 4
Place Keyboard Tray (B) on the metal brackets on
Desk (A). Secure Keyboard Tray (B) to brackets using
M5x10mm Screws (S-B) and tighten with a Phillips
screwdriver.
If installing a monitor mount,
remove the plug from the
desktop, then secure the
mount using grommet
mounting hardware included
with your monitor mount.
DESKTOP
4.4lbs
(2kg)
KEYBOARD TRAY
C (x1)
Stopper
S-B (x4)
M5x10mm Screw
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
DO NOT place hands on or near support bars.
Moving parts can crush and cut. Pinch points
are created during liing and lowering the work
surface. Failure to follow these instructions may
result in serious personal injury.
WARNING: PINCH POINT
E
A
A
B
S-B
DB
C
S-A
A
A
F
