2 3
ASSEMBLY STEPS
OPTION A: Wood Stud Mounting
Install Cover (G) onto top and bottom of Mount
(C). Use a stud finder and determine your desired
mounting location. Hold Mount (C) up to the wall
and mark the mounting hole locations. Use of a
level is highly recommended. Drill 1.2” (30mm)
deep holes using a ⅛” (3mm) drill bit. Install Mount
(C) to the wall using M6x50mm Screws (W-A) and a
Phillips screwdriver.
Remove protective film from Pads (F) and apply them to Laptop Tray (E).
PACKAGE CONTENTS
TOOLS NEEDED
13.2lbs
(6.6kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
WARNING!
Phillips
Screwdriver
A (x1)
Upper Arm
B(x1)
Lower Arm
C (x1)
Mount
S-B (x3)
Screw Cap
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED
D(x1)
Arm
Extension
E(x1)
Laptop Tray
F(x4)
Pad
M-A (x8)
M4x12mm
Screw
S-A (x3)
M6x25mm
Spring Screw
T-A (x1)
3mm Allen
Wrench
T-B (x1)
5mm Allen
Wrench
W-B (x3)
Concrete
Anchor
W-A (x3)
M6x50mm
Screw
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
• NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
• USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIPOVER.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
STEP 1
OPTION B: Concrete Wall Mounting
Install Cover (G) onto top and bottom of Mount
(C).Hold Mount (C) up to your desired position
and mark mounting hole locations. Use of a level is
highly recommended. Drill 2” (50mm) deep holes
using a 5/16” (8mm) drill bit. Install Mount (C) to
the wall using Concrete Anchors (W-B), M6x50mm
Screws (W-A), and a Phillips screwdriver.
CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO
MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us.
W-A
C
C
W-B W-A
STEP 2
F
E
Per Arm
G(x2)
Cover
G
G
