Vivo STAND-TV00L User manual

Tabletop TV Stand
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
Instruction Manual
https://vivo-us.com/products/stand-tv00l
SKU: STAND-TV00L
[email protected]om www.vivo-us.com 309-278-5303
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

2
PACKAGE CONTENTS
WARNING!
a1 (x2)
TV Plate
a2 (x1)
TV Plate
Connector
b(x2)
Bracket
h (x2)
M6x14
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED
c(x1)
Tempered
Glass Base
d1(x1)
Lower Support
Column
d2 (x1)
Upper Support
Column
e(x1)
Plastic Cover
f (x1)
Metal Pad
g (x1)
Swivel Pad
i (x3)
M6x18
j(x2)
Cable Clip
k(x4)
Rubber Foot
l(x10)
M6x10
m (x8)
Washer
n (x4)
M4x12
o(x4)
M4x30
p (x4)
M6x20
q(x4)
M6x35
r (x4)
M8x20
s (x4)
M8x45
t(x4)
M4 Washer
u1 (x4)
M6 Washer
v(x4)
M8 Washer
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
• NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF TV OR TV STAND.
• USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIPOVER.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
w(x4)
M4 Spacer
x (x8)
M6/8 Spacer
y(x1)
Allen Wrench
z(x1)
Security Wire Kit
A(x2)
Buckle
B(x4)
M4x6
u2 (x2)
6.5x18x2
Washer
u3 (x3)
6.5x20x1.5
Washer
C(x1)
Bubble Level

3
ASSEMBLY STEPS
STEP 1
TOOLS NEEDED
88lbs
(39.92kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
Phillips
Screwdriver
Stick rubber feet (k) to bottom of glass base (c). Assemble upper and lower support columns (d1, d2)
using M6x10 bolts (l) with 6.5x18x2 washers (u2), then attach support column to swivel pad (g) using
M6x14 bolts (h) and tighten with Allen wrench (y). Attach column with pad to glass base using metal
pad (f), M6x18 bolts (i) and 6.5x20x2 washers (u3), making sure the metal pad is placed between the
glass base and swivel pad, and with the tabs inserted into the swivel pad. Tighten bolts with the Allen
wrench (y) and slide plastic cover (e) onto column.
c
k
g
h
y
e
f
u3
y
i
l
d2 d1
u2

4
STEP 2
Attach TV plates (a1) to TV plate connector (a2) using M6x10 bolts (l) and washers (m) and tighten
with the Allen wrench. Attach TV plate to support column at desired height using M6x10 bolts (l) and
washers (m). Clip bubble level (C) onto plate to ensure the plate is level, then tighten bolts with the
Allen wrench. Attach wire clips (j) to back of support column.
STEP 3
Mount TV brackets (b) to the back of your TV using bolts (n, o, p, q, r, s) and washers (t, u1, v)
according to the size of mounting holes on your television. Make sure TV brackets are both in the
correct orientation. For curved or recessed back TVs, spacers (w, x) may be required.
y
a1
lm
a2
y
lm
j
t, u, v
nos
w, x
C
t, u1, v

5
STEP 4
Hang TV with brackets on TV plate (a) as
shown in diagram.
Secure TV brackets using buckles (A) with M4x6 bolts (B) as shown. Route cables through cable
management clips (j) on back of stand.
A
B

6
STEP 5
5a
5c
OPTION A: Wood Wall
Drill 1.75” (45mm) deep holes using a 5/32” (or 3.8mm) drill bit. Secure with screws and washers.
5b
If your TV is located near a wall as shown in Diagram 5a, then a steel wire from security wire kit (z) can
be attached for added security. Attach the two ends of the steel wire to the top two holes on the back of
your TV as shown in Diagram 5b. Attach the center loop to your wall according to wall type as shown in
Diagram 5c, 5d or 5e.
Wall
45m m
3. 8m m

7
STEP 5 (Continued)
5d
OPTION B: Concrete/Brick Wall
Drill 2” (50mm) deep holes using a 5/16” (or 8mm) drill bit, and press anchors into holes. Secure with
screws and washers.
5e
50 mm
8m m

LAST UPDATED: 03/06/2020
Open Monday - Friday 7:00am - 7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times. If any
parts are received damaged or defective, please contact us. We are happy to replace parts to
ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
[email protected] AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
AVG. RESOLUTION TIME (within oice hrs): < 15 M
www.vivo-us.com
Chat live with an agent!
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
309-278-5303