Volt VWL-703 User manual

VOLT®LOW VOLTAGE LANDSCAPE LIGHTING
V O LT ®Salty Dog MR16 In-Grade Light
ITEM: VWL-703
INSTALLATION INSTRUCTIONS
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

V O LT ®Salty Dog MR16 In-Grade Light - VWL-703
INSTALLATION INSTRUCTIONS
IMPORTANT: PLEASE READ BEFORE INSTALLATION
!
IMPORTANT SAFETY INSTRUCTIONS
!
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the warranty.
These instructions do not intend to cover all variations in installation, operation
maintenance or mounting situations.
1. Make sure that the power is turned OFF before installing or servicing this
xture.
2. Warning: this xture is not intended to be installed within 10 feet [3 meters]
of a pool, spa or fountain.
3. This xture is intended to be used only with a power supply (transformer)
rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Underground Low Energy Cable must not be buried over 6” (15.2 cm) in
order to connect to the main low voltage cable.
5. Wiring connections must be made with UL Listed wire connectors that are
suitable for the application.
6. Position the wire connector so that it is located within 6 inches (15.2 cm)
from a building structure, a luminaire, or tting.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
LIGHTED LAMP IS HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before reducing lamp.
2. Lamp gets HOT quickly!
3. Do not touch the hot lens, guard or cowl.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time.
6. Use a soft cloth.
7. Oil from skin may damage lamp.
8. Do not operate the xture with a damaged or missing lens or shield.
813.978.3700 • [email protected] • www.voltlighting.com
2

PACKAGE CONTENTS
Parts Required (sold separately)
813.978.3700 • [email protected] • www.voltlighting.com
3
PRODUCT DIMENSIONS
A. (1) Fixture B. (1) Stake
A. (1) MR16 Lamp
4.25”
4”

Remove Faceplate and Lens
1
Install/Replace Lamp
2
V O LT ®Salty Dog MR16 In-Grade Light - VWL-703
INSTALLATION INSTRUCTIONS
813.978.3700 • [email protected] • www.voltlighting.com
4
Unlock the screws and remove the
faceplate, gasket, and lens from the
housing.
Screw
Gasket
Lens
Faceplate
Housing
Insert lamp with correct wattage
and type marked on xture label.
CAUTION: Do not exceed
maximum wattage marked on
luminaire label.
NOTE: DO NOT touch lamp with
bare hands. Use a soft cloth to
handle lamp.
MR16 Lamp
Socket

Install Lens and Faceplate
3
Install Fixture to Stake
5
Install Stake
4
813.978.3700 • [email protected] • www.voltlighting.com
5
Place the lens, gasket and faceplate
back onto the housing. Secure them
with screws previously removed.
Hand tighten until snug, then use a
screwdriver to secure them in a star
Screw
Faceplate
Gasket
Lens
Housing
Determine the desired location for
mounting the xture. Hammer the
stake into the ground until ange
of stake is ush to grade. To avoid
damage to the stake, place a board
on top of the stake while hammering.
NOTE: If the ground is hard and the
stake is difcult to install, make a
crosscut in the ground using a at
shovel before hammering the stake.
Board
Stake
Ground
Soil
Clear away an area in the ground
at the wireway slot on top of the
stake. Lay the luminaire pigtail into
the wireway slot and screw the
xture onto the stake. Tighten until
snug.
Wireway Slot
Fixture
Pigtail
Stake

Wire Connections
6
V O LT ®Salty Dog MR16 In-Grade Light - VWL-703
INSTALLATION INSTRUCTIONS
813.978.3700 • [email protected] • www.voltlighting.com
6
Strip both leads from the luminaire pigtail. Using two wire
connectors (sold separately), connect leads from luminaire to
the main supply cable.
Wire Connectors
Pigtail
Main Supply Cable

Specications and product details subject to change without notice.
© Copyright 2023, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • www.voltlighting.com
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)