Volt Big Par36 Brass Black Flood User manual

VOLT®LOW VOLTAGE LANDSCAPE LIGHTING
V O LT ® Big Par36 Brass Black Flood
ITEM: VFL-4520-BBK
INSTALLATION INSTRUCTIONS
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

V O LT ®Big Par36 Brass Black Flood Light VFL-4520-BBK
INSTALLATION INSTRUCTIONS
IMPORTANT: PLEASE READ BEFORE INSTALLATION
!
IMPORTANT SAFETY INSTRUCTIONS
!
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
LIGHTED LAMP IS HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before reducing lamp.
2. Lamp gets HOT quickly!
3. Do not touch the hot lens, guard or cowl.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time.
6. Use a soft cloth.
7. Oil from skin may damage lamp.
8. Do not operate the xture with a damaged or missing lens or shield.
813.978.3700 • [email protected] • www.voltlighting.com
2
This luminaire is intended for installation in accordance with local codes and the
National Electric Code (NEC). Failure to adhere to these codes and instructions may
result in serious injury, property damage and void the warranty.
These instructions do not intend to cover all variations in installation, operation
maintenance or mounting situations.
1. Make sure that the power is turned OFF before installing or servicing this
luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or more
from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply (transformer)
rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with UL listed wire connectors that are
suitable for outdoor use.
5. Position the low voltage wire and wire connector so that it is located within 6
inches (15.2 cm) from a building structure, a luminaire or tting.
6. The main low voltage cable is intended for shallow burial - less than 6 inches
(152 mm).
7. If additional lengths of low voltage cable is required, please contact www.
voltlighting.com or call 1-813-978-3700.

PACKAGE CONTENTS
PRODUCT DIMENSIONS
INSTALL STAKE
1
Determine the desired location
for mounting the stake mount.
Hammer the stake into the
ground until ange of stake is
ush to grade. To avoid damage
to the stake, place a board on top
of the stake while hammering.
Note: If the ground is hard and
the stake is difcult to install,
make a crosscut in the ground
using a at shovel.
Board
Ground
Soil
Stake
813.978.3700 • [email protected] • www.voltlighting.com
3
A. (1) Fixture
B. (1) Stake
6 1/2”
2”
4 3/4”

INSTALL LAMP
2
Install Lens
3
V O LT ®Big Par36 Brass Black Flood Light VFL-4520-BBK
INSTALLATION INSTRUCTIONS
813.978.3700 • [email protected] • www.voltlighting.com
4
Use a PAR36 lamp (sold
separately), with correct wattage
and type as marked on luminaire
label.
Connect supply wires to screws
on the bottom of lamp, tighten
until snug with screwdriver. Push
lamp into lamp holder and seat in
place.
CAUTION: Do not exceed
maximum wattage marked on
luminaire label.
NOTE: DO NOT touch lamp with
bare hands. Use soft cloth to
handle lamp.
Supply Wire
Lamp
Fixture Body
Install the lens to the xture
body by aligning the locking
parts on both of them. Be
sure to position the lens so
when it turns it locks properly
into place.
Lens
Fixture Body

Install Fixture to Stake
4
Wire Connection
5
813.978.3700 • [email protected] • www.voltlighting.com
5
Clear away an area in the
ground at the wireway slot on
top of the stake. Lay luminaire
pigtail into the wireway slot
and secure the xture onto the
stake. Tighten until snug.
Luminaire
Wireway Slot
Base
Pigtail
Stake
Strip both leads from the luminaire pigtail. Using two wire
connectors (sold separately), connect the leads from the
luminaire to the main low voltage supply cable leads.
Pigtail
Wire Connector Main Low Voltage Supply Cable
INSTALL/REPLACE LAMP
Reverse Step 2 - Step 3 to expose the lamp and replace it
with the correct wattage and type marked on the luminaire
label.
IMPORTANT: Halogen lamps must be protected from mois-
ture and dust at all times. Always reinstall the lens when
removed.

Specications and product details subject to change without notice.
© Copyright 2023, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • www.voltlighting.com
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)