Waeco Easy Cool EC-2500 User manual

Installation of roof air conditioning
system Easy Cool EC-2500 or EC-3000
on display stand
PB4
Pom/Fh
Page 1/4
22.10.03 Display EC2500/3000 4445100103
Illustration 1:
¾The installated roof air conditioning
system on display stand contains:
•a display stand with support holder
•a roof air conditioning system EC-
2500 or EC-3000 with fixing frame
•an air outlet unit
•a remote control with holder
Illustration 2:
¾Attach the support holder to the display
stand.
¾Fasten the holder on the side and on top
with the supplied round head bolts (4xM8).
Illustration 3:
Caution!
Danger of finger clamping!
¾Put the system fittingly on the stand!

Installation of roof air conditioning
system Easy Cool EC-2500 or EC-3000
on display stand
PB4
Pom/Fh
Page 2/4
22.10.03 Display EC2500/3000 4445100103
Illustration 4:
¾Fasten the fixing frame with key screws
(4xM8) from below.
Illustration 5:
¾Insert the mains cable (230V) into the
borings from above.
¾Pull the mains cable out below the stand.
Illustration 6:
The condenser outlets are both on the left
and the right side!
¾Drill the condener outlets to a diameter of
8 mm.
¾Stick in the corrugated hoses. There are 2
hoses on each side.

Installation of roof air conditioning
system Easy Cool EC-2500 or EC-3000
on display stand
PB4
Pom/Fh
Page 3/4
22.10.03 Display EC2500/3000 4445100103
Illustration 7:
¾Insert the long condenser hose (one on
each side) into the boring of the stand from
below and push through to the top.
¾Attach the lower end to the condensator
container.
Illustration 8:
¾Connect the other end of the long
corrugated hose to the two short
corrugated hoses with T-fitting.
This must be made on both sides!
Illustration 9:
¾Shorten the connection connection shaft
for about 70 mm!
Caution!
Do not shorten the side of the connection
shaft which is pushed on the suction opening
of the roof air conditioning system.

Installation of roof air conditioning
system Easy Cool EC-2500 or EC-3000
on display stand
PB4
Pom/Fh
Page 4/4
22.10.03 Display EC2500/3000 4445100103
Illustration 10:
¾Connect the 8-pole connector of the
connecting line from the system to the air
outlet socket.
Illustration 11:
¾Fasten the air outlet unit with the suppllied
self-tapping screws (8 screws) to the fixing
frame.
Illustration 12:
¾Fasten the holder of the remote control to
the intended borings on the display stand.