Warmup 5iE User manual

5iE
The Smartest Smart Thermostat
Boiler Receiver Installation Manual
Technical Helpline
0345 345 2288

When installing the Boiler receiver Warmup recommends it is
either mounted onto a 1 gang surface box or mounted directly to
a stud wall.
The Boiler receiver in most situations should be installed within
the boilers vicinity.
Large metal objects such as the boiler, hot water cylinder or
radiators, should be at least 300mm away from the Boiler
Receiver and not directly between it and the 5iE.
5iE - Boiler Receiver
This product uses mains voltage electricity
and work should only be carried out by a
qualied electrician. Electrical installation to
be in accordance with latest edition of BS7671
Wiring Regulations and appropriate Statutory
Regulations.
!
• Feed the connecting wires
through the centre of the
baseplate
• Screw the baseplate to the
backbox (or wall if cable are
within the void)
• Remove the two screws
from the base of the Boiler
receiver
• Gentle pull the faceplate
from the bottom and slide
up to remove from the
baseplate
12
NL
1
2
3
4

5iE - Boiler Receiver
• Loosen the terminal screws
slightly
• Inserted the wires into the
relvent terminals, as per the
wiring diagrams
• Ensure all terminals are
tightened suciently
Note: Ensure the terminal is
only on the wire and not the
sheathing
• Switch the power supply
back on to boiler
• The Boiler receiver will
have a blinking red LED, indi-
cating that it is unpaired
• Remove the wire sheathing
as shown above
• Ensure no strands of the
wire are frayed
• Re-attach the faceplate
by gently placing the top
on and sliding down, before
pushing the bottom on
• Replace the two screws
from the base of the Boiler
receiver
3
5
4
6
NL
1
2
3
4