Waterco MultiCyclone 70XL User manual

www.waterco.com
Notice to Installer
This manual contains important information about the installation, operation
and safe use of this product. Once the product has been installed this manual
must be given to the owner / operator of this equipment.
This equipment must be installed and serviced by a qualified technician.
Improper installation can create electrical hazards which could result in property
damage, serious injury or death. Improper installation will void the warranty.
WARNING
!
70XL
Manual

SAFETY INFORMATION ------------------------------------------- 00
INTRODUCTION -------------------------------------------------- 01
INSTALLATION ---------------------------------------------------- 02
PLUMBING CONNECTION --------------------------------------- 02
FILTER MAINTENANCE ------------------------------------------- 03
FLUSHING OUT THE SEDIMENT CHAMBER ------------------- 03
WARRANTY -------------------------------------------------------- 03
TECHNICAL SPECIFICATION ------------------------------------- 04
DIMENSIONS ------------------------------------------------------ 04
EXPLODED DIAGRAM -------------------------------------------- 05
SAFETY INFORMATION
1. MultiCyclone 70XL is designed to work with water at temperatures greater than 0º C and less
than 45ºC. The lter should never be operated outside of these temperatures or damage may
occur.
2. The installation should be carried out in accordance to the safety and the specic instructions for
each facility.
3. Any modication of the lter requires the prior consent from Waterco. Original replacement
parts and accessories authorized by the manufacturer ensure a high level of safety. Waterco
assumes no liability for the damage and injuries caused by unauthorised replacement parts and
accessories.
4. The user should make sure that the installation is carried out by qualied authorised persons and
that these persons have rst carefully read the following instructions.
5. The operating safety of the lter is only guaranteed if the installation and operation instructions
are correctly followed.
6. In the event of defective operation or fault, contact Waterco or its nearest authorised service
agent.
7. To reduce the risk of injury, do not permit children to use this product unless they are closely
upervised at all times.
8. Incorrectly installed equipment may fail, causing severe injury or property damage.

Waterco Multicyclone 70XL
I pg 01
INTRODUCTION
MultiCyclone 70XL is capable of saving water and reducing lter maintenance.
The MultiCyclone 70XL works on the basis of centrifugal water ltration. There are no moving parts
to wear and tear, and no lter media to clean or replace.
EXIT PIPE
CYCLONE RH
CYCLONE LH
TOP SHELL
WATER OUTLET 4” PORT
MAINFOLD PLATE
CYCLONE HOLDER
BOTTOM SHELL
WATER INLET 4” PORT
CLEAR PIPE
STAND
DRAIN / FLUSH VALVE
Incoming water is guided by a diverter plate so that it enters multiple hydro cyclones tangentially
generating a strong centrifugal effect. This spins the sediment out to the hydro cyclone’s wall and
then spirals it down to the sediment chamber, while the cleansed water spirals upwards.

The accumulation of sediment can be visibly monitored through the MultiCyclone 70XL’s clear sight
glass. The MultiCyclone 70XL is cleaned by simply opening the purge valve.
MultiCyclone 70XL is ideal as a pre-lter to extend the life of your existing lter.
• Save Water
• Reduce backwash frequency.
Please Note: The MultiCyclone 70XL is designed to filter sediment that is heavier than water; floating
debris cannot be filtered out by centrifugal filtration.
INSTALLATION
Be sure to comply with the local plumbing codes. The lter may be plumbed into a drinking water
system and would, therefore be subject to whichever local regulations that may apply.
Be sure that all provisions for wastewater disposal meet local, state or national codes. Do not
discharge water where it will cause ooding or damage.
If the incoming water pressure is higher than the maximum operating pressure of 250kPa /2.5Bar /36
psi, a Pressure Regulating Valve (PRV) must be installed upstream of the lter inlet.
The PRV should be set to 90% of the maximum operating pressure of the tank.
If the incoming water ow is less than the lter’s minimum ow requirements, the lter’s ltration
efciency will be affected, please consult Waterco.
MultiCyclone 70XL Recommended Operational Flow Rates
Minimum ow rate: 36m3/hr (158.5 GPM)
Maximum ow rate: 96 m3/hr (422.7 GPM)
PLUMBING CONNECTION
1. Connect the outlet from your pump to the inlet of the MultiCyclone 70XL.
Glue the plumbing to the Barrel unions and Allow 24 hours for glue (solvent) to set. Ensure
solvents are not excessively applied to ttings as this could run into o’rings and create sealing
problems. Screw the barrel union on to the inlet of your MultiCyclone 70XL and hand tighten.
2. Connect from the outlet of the MultiCyclone 70XL to the inlet of your
filter.
Glue the plumbing to the Barrel unions and Allow 24 hours for glue (solvent) to set. Ensure
solvents are not excessively applied to ttings as this could run into o’rings and create sealing
problems. Screw the barrel union on to the outlet of your MultiCyclone 70XL and hand tighten.

Waterco Multicyclone 70XL
I pg 03
3. Connect to Waste Line.
Glue the plumbing from the Sediment Purge Valve to your waste line.
4. Turn on pump.
Be sure to check that there are no leaks from the connectors. If required, tighten by hand.
FILTER MAINTENANCE
Filter maintenance determined by the following conditions:
1. The ow rate through the MultiCyclone 70XL is insufcient to meet the demand.
2. The sediment chamber is half lled with sediment.
The accumulation of sediment can be visibly monitored through the MultiCyclone 70XL’s clear sight
glass. The MultiCyclone 70XL is cleaned by simply opening the purge valve
FLUSHING OUT THE SEDIMENT CHAMBER
Whilst the water pump is running simply open the sediment purge valve until the sediment has been
ushed out. This is visible through the clear sight glass.
Once the sediment has been ushed out, close the sediment purge valve.
WARRANTY
MultiCyclone 70XL is covered by a 2 warranty.
For more information please refer to the Waterco “Warranty Terms & Conditions” booklet. With our
on going commitment to quality products and service Waterco Limited reserves the right to alter the
product in any manner and at any time without prior warning.
This information is to the best of our knowledge, accurate at the time of printing. Any recommendations
or suggestions are made without warranty and without prejudice, since the use of our product is
beyond our control.

0.00
1.00
2.00
3.00
4.00
5.00
6.00
7.00
8.00
0.00 20.00 40.00 60.00 80.00 100.00 120.00
MultiCyclone 70XL
Total Head Loss Curve
Head Loss (m)
Flow Rate (m3/hr)
TECHNICAL SPECIFICATION
Pressure Rating: 250 kPa / 2.5 bar /36 psi
Minimum Flow Rate: 36m3/hr (158.5 GPM)
Maximum Flow Rate: 108 m3/hr (475.6 GPM)
DIMENSIONS
1359
730
71
654
478,5
740
542,5

Waterco Multicyclone 70XL
I pg 05
EXPLODED DIAGRAM
NO DESCRIPTION QTY
34 Nut M6 (Not Shown) 40
33 Rubber Washer (Not Shown) 1
32 O Ring BS 112 1
31 Air Relief Valve 1
30 Bolt M10 48
29 Bolt M6 40
28 Washer M6 40
27 O Ring BS 009 40
26 O Ring BS 018 70
25 O Ring BS 025 14
24 O Ring BS 392 1
23 O Ring Special 2
22 Washer BH 100mm 2
21 O Ring BS 474 2
20 Washer M10 96
19 Nut M10 48
18 Clear Pipe 50mm 1
17 2 Way Valve 50mm 1
16 Base 1
15 Elbow 50mm 1
14 Half Union 50mm 1
13 Male Valve Socket 1
12 Lower Shell 1
11 Pipe 100mm 1
10 Elbow 90˚ 100mm 1
9Pipe 100mm 1
8Bulkhead 100mm 1
7Cyclone Holder 1
6Cyclone Cone RH 35
5Cyclone Cone LH 35
4Mainfold Plate 1
3Exit Pipe / Vortex Tube 70
2Half Union 100mm 2
1Top Shell 1

Waterco Limited ABN 62 002 070 733
(W99302 / ZZM1449) 07/2013
OFFICES - AUSTRALIA
NSW - SYDNEY
(HEAD OFFICE)
Tel: [phone]
QLD - BRISBANE
Tel: [phone]
VIC/TAS - MELBOURNE
Tel: [phone]
WA - PERTH
Tel: [phone]
SA/NT - ADELAIDE
Tel: [phone]
ACT DISTRIBUTION
Tel: [phone]
OFFICES - OVERSEAS
WATERCO (EUROPE) LIMITED
Sittingbourne, Kent, UK
Tel: [phone]
WATERCO FRANCE
Saint Priest, France
Tel: [phone]
WATERCO (USA) INC
Augusta, Georgia, USA
Tel: [phone]
WATERCO CANADA
Longueuil, Quebec, Canada
Tel: [phone]
WATERCO (NZ) LIMITED
Auckland, New Zealand
Tel: [phone]
WATERCO © LIMITED
Guangzhou, China
Tel: [phone]
WATERCO (FAR EAST) SDN BHD
Selangor, Malaysia
Tel: [phone]
PT WATERCO INDONESIA
Jakarta, Indonesia
Tel: [phone]
WATERCO SINGAPORE INTL PTE LTD
Nehsons Building, Singapore
Tel: [phone]