Watermark Élan Vital 38-7.65-L-V-EV4-PC User manual

Élan Vital
Bridge Kitchen Faucet w/ Side Spray
Élan Vital – Series 38 – Bridge Kitchen Faucet w/ Side Spray Page 1
•
FEATURES
•Flexible hose connections
¼ turn washerless ceramic disc valve cartridges
•Flow rate 1.5 gpm (5.7 lpm) maximum flow rate
•Solid brass construction
•Warranty:
oLimited lifetime warranty (residential
use)
oOne year (commercial use)
•Shipping weight (lbs.) 10
•Shipping dimensions (in.): 29x12x4

Élan Vital
Bridge Kitchen Faucet w/ Side Spray
Élan Vital – Series 38 – Bridge Kitchen Faucet w/ Side Spray Page 2
1. Place base through hole in counter top.
2. Tighten base onto counter making
sure base is aligned so lever can turn
equally to the right and to the left. Turn
lever to leftmost position.
3. Screw gear box top lock nut onto base.
Do not tighten.
4. Raise gear box with valve up to base.
The valve may be aligned in any
direction. Gear box may need to be
turned slightly in order for pins to
properly mate with gear.

Élan Vital
Bridge Kitchen Faucet w/ Side Spray
Élan Vital – Series 38 – Bridge Kitchen Faucet w/ Side Spray Page 3
5. Screw gear box bottom lock nut onto
base until it contacts the bottom of the
gear box. Do not tighten.
6. Lower gear box top lock nut until it
touches the top of the gear box. Tighten
top and bottom lock nuts.
7. Tighten gear box bottom lock nut set
screws. One or both set screws may be
tightened.
8. Put hose through hole in base and
screw into correct port on valve.

Élan Vital
Bridge Kitchen Faucet w/ Side Spray
Élan Vital – Series 38 – Bridge Kitchen Faucet w/ Side Spray Page 4
For technical support, please call 718-257-2800
IMPORTANT INSTALLATION INFORMATION
•USE TEFLON TAPE OR PIPE SEALANT FOR THREADED CONNECTIONS
•DO NOT USE PLUMBER’S PUTTY ON ANY OF THE BRASS COMPONENTS
This will cause the finish to tarnish and void the warranty. A non-corrosive Alkoxy Silicone is
recommended.
•DURING SWEATING OF LINES DO NOT OVERHEAT CASTING
Overheating may cause damage to internal mechanism
•COPPER ADAPTORS MAY BE REQUIRED TO COMPLETE YOUR INSTALLATION
9. Attach cold and hot supply hoses to
valve.
10. Verify handle and valve are aligned
properly by pushing the button on the
spray and turning the handle from all the
way left to all the way right. When in the
leftmost position the water flow should
be off. As the handle is turned to the
right the water should progress from off
– low cold – high cold – high mixed –
high hot – low hot. If turning the handle
from the leftmost position to the
rightmost position does not produce the
full range of flow please see the
troubleshooting guide.
Troubleshooting Guide
If the valve cannot be opened or closed
fully:
1. Loosen gear box bottom lock nut
and lower gear box until the gear
disengages from the pin.
2. Turn the handle all the way to the
right.
3. Raise the gear box so the pins mates
with the gear. The gear box should
not be tightened on at this point.
4. Holding the gear box in place, turn
the handle to the left until it stops.
5. Lower the gear box to disengage
from pins.
6. Turn the handle all the way to the
left. Repeat steps 4 – 7 of the
installation instructions.