WE-EF LTM440 LED User manual

Safety Notice
The manufacturer is discharged from liability when damage
is caused by improper use or installation.
If any luminaire and/or accessory is subsequently modi-
fied, the persons responsible for the modification shall be
considered as manufacturer.
LTM440 LED_241121 / 006-1175
Technical specifications are subject to change.
© WE-EF 2022
we-ef.com
WE-EF LIGHTING USA
Tel [phone]
[email protected]
WE-EF LIGHTING
Installation and
Maintenance Instructions for
Light Column
LTM440 LED

LTM440
Light Column
IP55, IK08
Mounting Accessory
Planted Root ESV10 300-0948 55.8 lb
Flange plate 300-0803 4.4 lb
ø 17.5
2
ø 11.81– 14.49
0.86
6
157.48
22.68
15.75
ø 6.69
39.3
7
19.69










[S65]
[R65]
[C50] [C60]
ø 0.354 – 0.669 in
Light source
[S65] / [R65] .................9 LED 18W / 27W*
[C55] / [C60] .........LED-FT 17W / 24W / 37W*
* Nominal power, for latest data refer to
www.we-ef.com
Class I, ta = 25 °C
These products contain a light source of energy
efficiency class C and D.
Maintenance
Apart from cleaning the product’s exterior surfaces,
no special maintenance work is required.
Tools required
– Screwdriver PH recessed head size 2
– 3 mm / 4 mm / 6 mm Allen keys
120-
277 V
Installation
The product must be installed and maintained by
a suitably qualified professional in compliance with
latest building/construction and/or electrical regu-
lations and relevant legislation.
The LED should be replaced by a qualified tech-
nician
In case of questions please contact our technical
hotline: [phone] (from Monday - Friday
from 08.00 until 16.00 hours).

Installation Procedure
It is recommended to incorporate either the supplied
anchor bolts or the optional WE-EF planted root
ESV10 to facilitate a rigid installation.
1) Switch off the mains electrical supply.
2) For Planted Root Installation:
Adjust the planted root Aand fix it on the
ground (the post can get adjusted in 90° steps).
In the case of [S] & [R] lenses, the focus is on
the alignment. An arrow in the luminaire shows
how the direction of light should be orientated.
3) Loosen the screws Cand remove the screw
cover B. Twist the locking screw Gand open the
door Hof the post and take it off.
4) Insert the connecting cable through the post D
and the door opening. Adjust post with the cast
base Eand fix it with the provided mounting
hardware. Put on the screw cover Band firmly
tighten the screws C.
5) Cut connecting cable to the required length.
Connect the mains supply leads to their respec-
tive connecting cable leads. (N = neutral, L1 =
phase, = earthing). Check that rating shown
on the luminaire label conforms with the mains
electrical supply.
6) Reposition door Hand tighten the locking
screw G.
O
D
C
B
E
A
G
H