Welch Allyn Connex VSM 6000 series Service manual

Welch Allyn Connex VSM 6000 Series
Care & Routine Service
Maintenance and service
Replace the printer paper
The printer is located on the top of the monitor. Follow these steps to replace the roll of printer paper:
1. Grasp the two tabs and pull up to open the printer door.
2. Remove the empty core.
WARNING: Hot surface. Do not touch the printer mechanism.
3. Insert a new roll of paper.
Note: The paper roll must be installed as illustrated. If the paper roll is not installed correctly,
the printer will not print properly.
4. Thread the end of the roll past the roller so that it extends past the printer door, as shown.
5. With one hand, pull lightly on the paper to take up any slack. With the other hand, close the printer
door by pushing it down and into place until it clicks.
Be certain that the paper does not catch in the printer door.

Welch Allyn Connex VSM 6000 Series
Care & Routine Service
Change the battery
Before removing the battery, shut down the monitor.
1. Turn the monitor upside down to access the battery door.
2. Locate the battery cover, indicated by.
3. Press downward and slide to open the door.
4. Pull the battery out by pulling the battery label, which is visible when you open the battery door.
5. Slide in the new battery. Ensure that you insert the new battery in the same orientation as the old
battery.
6. Replace the battery door by positioning the end below and then pressing firmly on the
opposite end.