Whalen BRA7PD-E User manual

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Whalen Furniture Mfg., Inc. Page 1 Factory No. 16650
Braxton 2-pk Chair
Model # BRA2PC-E
ADULT ASSEMBLY REQUIRED
If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the
store where it was purchased. Please call our toll-free customer service number and have your
instructions and parts list ready to provide the model name, part name or factory number:
1-866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday to Friday
Or visit our website www.whalenfurniture.com
Or e-mail your request to [email protected]
LOT NUMBER:
DATE PURCHASED: / /

Model # BRA2PC-E
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 2 Factory No. 16650
QUALITY GUARANTEE
We are confident that you will be delighted with your Whalen Furniture purchase.
Should this product be defective in workmanship or materials or fail under normal use, we will repair
or replace it for up to one (1) year from date of purchase. Every Whalen Furniture product is designed
to meet your highest expectations. We guarantee that you will immediately see the value of our fine
furniture.
This warranty gives you specific legal rights and you may also have other rights which vary from
province to province (state to state).
Customer Service: 1-866-942-5362
8:30 a.m. - 4:30 p.m., PST, Monday to Friday
www.whalenfurniture.com
1. Maximum load weight 136 kg (300 pounds).
1. Please read the Assembly Instructions prior to assembling the unit.
2. To avoid damage, assemble the unit on a sturdy, level and non-abrasive surface.
3. Keep all hardware and parts out of the reach of children.
4. Please wait until all steps are completed before fully tightening bolts.
5. Make sure all bolts and screws are tightly fastened before the unit is used.
6. Check that all bolts, screws and knobs are tight at least every 3 months or as needed.
GENERAL INFORMATION, TIPS & TRICKS
MAXIMUM RECOMMENDED WEIGHT LOADS
THIS UNIT IS INTENDED FOR USE ONLY WITH THE MAXIMUM
WEIGHTS INDICATED. USE WITH LOAD HEAVIER THAN THE MAXIMUM
WEIGHTS INDICATED MAY RESULT IN INSTABILITY, CAUSING POSSIBLE INJURY.

Model # BRA2PC-E
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 3 Factory No. 16650
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A - Chair Backrest (2) B - Seat Frame with Cushion (2)
C - Left Front Leg (2) D - Right Front Leg (2)
E - Left Side Stretcher (2) F - Right Side Stretcher (2)
(1) 1-3/4” Bolt (4+1 extra) (2) 3-1/2” Bolt (8+1 extra)
(3) Hex Nut (4) Lock Washer (5) Flat Washer
(8+1 extra) (20+1 extra) (20+1 extra)
(6) 2” Wood Screw (8+1 extra) M5 Allen wrench (1) Open wrench (1) Touch-up Pen (1)
Tools required: Allen wrench and Open wrench (provided) and Phillips screwdriver (not provided).

Model # BRA2PC-E
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 4 Factory No. 16650
Assembly Instructions
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. Lay one Chair Backrest (A) on a smooth and protective surface with the threaded inserts facing up.
3. Place one Seat Frame (B) onto the middle rail of the Chair Backrest (A) with the end dowels fully
inserted. Make sure that the cushion faces up when the unit is turned upright. Insert and screw the 3-1/2”
Bolts (2) with Lock Washers (4) and Flat Washers (5) through the pre-drilled holes on the seat frame at
rear corner blocks and loosely tighten into the threaded inserts on the Backrest.
4. Secure the Seat Frame (B) onto the Chair Backrest (A) by inserting two 1-3/4” Bolts (1) with Lock
Washers (4) and Flat Washers (5) through the pre-drilled holes on the rear rail of the Seat Frame.
NOTE: DO NOT fully tighten the bolts.
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
1-3/4” Bolt
(2 used in this step)
①
Lock Washer
(6 used in this step)
④
Flat Washer
(6 used in this step)
⑤
3-1/2” Bolt
(4 used in this step)
②

Model # BRA2PC-E
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 5 Factory No. 16650
Assembly Instructions
5. Position the last assembly upside down on the carton or other support surface, as shown.
NOTE: Place a protective cover (like the bubble wrap packing material) over the carton or other support
surface to prevent from scratching.
6. Insert the tenon of Left and Right Side Stretchers (E and F) into the mortises of the rear legs (A). Make
sure that the slant holes on the Side Stretchers will face the floor when the unit is turned upright.
7. Remove the plastic caps from the hanger bolts of the Front Legs (C and D). Attach the Front Legs (C and
D) to the front corner blocks of the Seat Frame (B) by inserting the hanger bolts on the Front Legs
through the pre-drilled holes on the corner blocks and insert both Side Stretchers into the Front Legs
respectively. Fit the Flat Washer (5), Lock Washer (4) and Hex Nut (3) onto each hanger bolt. Securely
tighten the Nuts with the provided Open wrench.
NOTE: DO NOT fully tighten all the Nuts until the chair has been adjusted and level all the legs so that
they do not wobble. Once adjusted, go back and tighten while making sure that the unit remains level.
8. Insert and screw four 2” Wood Screws (6) into the slant holes in the Side Stretchers (E and F). Tighten
the screws with a Phillips screwdriver.
9. Stand the assembled chair upright on a flat surface. Press down the Seat Cushion (B) to even all legs.
Now, tightly fasten all bolts and nuts with the provided Allen wrench and Open wrench.
10. Repeat the same process to assemble the other chair.
B
D
CE
F
Hex Nut
(4 used in this step)
③
Lock Washer
(4 used in this step)
④
Flat Washer
(4 used in this step)
⑤
2” Wood Screw
(4 used in this step) ⑥

Model # BRA2PC-E
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 6 Factory No. 16650
Care and Maintenance
Use a soft, clean cloth that will not scratch the surface when dusting.
Use of furniture polish is not necessary. Should you choose to use polish, test first in an inconspicuous area.
Using solvents of any kind on your furniture may damage the finish.
Never use water to clean your furniture as it may cause damage to the finish.
Always use coasters under beverage glasses and flowerpots.
Liquid spills should be removed immediately. Using a soft clean cloth, blot the spill gently. Avoid rubbing.
Always use protective pads under hot dishes and plates. Heat can cause chemical changes that may create
spotting within the furniture finish.
Stains or marks from crayons or ink markers will be difficult to remove.
In the event that your furniture is stained or otherwise damaged during use, we recommend that you call a
professional to repair your furniture.
Check bolts/nuts periodically and tighten them if necessary.
Further advice about wood furniture care
It is best to keep your furniture in a climate-controlled environment. Extreme temperature and humidity
changes can cause fading, warping, shrinking and splitting of wood. It is advised to keep furniture away from
direct sunlight as sun may damage the finish.
Proper care and cleaning at home will extend the life of your purchase. Following these important and helpful
tips will enhance your furniture as it ages.
A touch-up pen has been provided to repair any small nicks or scratches that may occur during
assembly or shipping.
We hope you enjoy your purchase for many years.
Thank you for choosing Whalen Furniture!

IF YOU NEED TO ORDER ANY REPLACEMENT PARTS, PLEASE USE THE LIST BELOW
Braxton 2-pk Chair (BRA2PC-E)
*BRA2PC-E-1-CB Chair Backrest *BRA2PC-E-8-3 1/2B 5/16" x 3-1/2" Bolt *BRA2PC-E-2-SF Seat Frame *BRA2PC-E-9-1 3/4B 5/16" x 1-3/4" Bolt *BRA2PC-E-3-SC Seat Cushion *BRA2PC-E-10-HN Hex Nut *BRA2PC-E-3A-SCS Seat Cushion Screw *BRA2PC-E-11-LLW Large Lock Washer *BRA2PC-E-4-LSS Left Side Stretcher *BRA2PC-E-12-LFW Large Flat Washer *BRA2PC-E-5-RSS Right Side Stretcher *BRA2PC-E-13-2WS 2" Wood Screw *BRA2PC-E-6-LFL Left Front Leg *BRA2PC-E-14-M5AW M5 Allen Wrench *BRA2PC-E-7-RFL Right Front Leg *BRA2PC-E-15-OW Open Wrench *BRA2PC-E-CH Complete Hardware *BRA2PC-E-16-TUP Touch-up Pen