Whalen Breckenridge Executive Chair User manual

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Whalen Furniture Mfg., Inc. Page 1 Factory: ANJCHA
Date 2014-06-04 Rev. 2
Breckenridge Executive Chair
Model # WC-594
ADULT ASSEMBLY REQUIRED DUE TO THE PRESENCE OF SMALL PARTS,
SHARP POINTS, SHARP EDGES AS RECEIVED.
If you have any questions regarding assembly or if parts are missing, DO NOT return this
item to the store where it was purchased. Please call our toll-free customer service number
and have your instructions and parts list ready to provide the model name, part name or
factory number:
1-866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday to Friday
Or visit our website at www.whalenfurniture.com
Or e-mail your request to [email protected]
LOT NUMBER:
DATE PURCHASED:
/
/

Model # WC-594
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 2 Factory: ANJCHA
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware
are present before beginning assembly.
A – Backrest (1) B – Seat Cushion (1) CL – Left Armrest (1)
CR – Right Armrest (1) D – Mechanism (1) E – Telescoping Cover (1)
F – Gas Lift (1) G – 5 Star Base (1) H – Caster (5)
(1) Ø5/16” x 7/8” Bolt (2) Ø1/4” x 1-1/8” Bolt (3) Ø1/4” x 2” Bolt
(Qty. 4+1 extra) (Qty. 4+1 extra) (Qty. 4+1 extra)
(4) Flat Washer (Qty. 4+ 1 extra) (5) Plastic Cap (Qty. 4+ 1 extra) Allen Wrench (Qty. 1)
Tools required: Allen wrench (provided).

Model # WC-594
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 3 Factory: ANJCHA
Assembly Instructions
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. To begin assembly, place 5 Star Base (G) upside down and press the Casters (H) into the
holes at the end of each leg.
3. Turn the Star Base (G) upright and insert the thick end of the Gas Lift (F) into the center hole
of Star Base. Then position the Telescoping Cover (E) over the Gas Lift (F) and rest it on the
Star Base.

Model # WC-594
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 4 Factory: ANJCHA
Assembly Instructions
4. Place the Seat Cushion (B) upside down on a flat and protective surface. Align the Mechanism
(D) over the threaded holes on the underside of Seat Cushion (B) with the black tension knob
facing the front of the seat, as shown below. Fasten the Mechanism (D) in place with four 7/8”
Bolts (1). Securely tighten the bolts with the enclosed Allen Wrench.
B
D
1
1
Ø5/16” x 7/8” Bolt
(4 used in this step)
①

Model # WC-594
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 5 Factory: ANJCHA
Assembly Instructions
5. Locate the Backrest (A) and set the lumbar support facing up. Align and attach Left & Right
Armrests (CL & CR) to the Backrest (A) by inserting two 2” Bolts (3) with the Flat Washers (4)
through the upper holes on Armrests and loosely tighten into the backrest. As shown below.
6. Fit the Seat Cushion (B) between the Left & Right Armrests (CL & CR) making sure the drilled
holes on the armrests overlap the threaded inserts on the side of the Seat Cushion properly.
Fasten the Seat Cushion (B) to the Armrests (CL and CR) with two 2” Bolts (3) and two Flat
Washers (4). As shown below. DO NOT tighten the two bolts in this step.
Flat Washer
(4 used in this step)
④
Ø1/4” x 2” Bolt
(4 used in this step) ③

Model # WC-594
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 6 Factory: ANJCHA
Assembly Instructions
7. Gently pivot the Seat Cushion (B) to the upright position so that the bottom threaded inserts
are aligned with the drilled holes on the back support bar of the Backrest (A).
8. Insert four 1-1/8” Bolts (2) through the drilled holes on the back support bar of the Backrest (A)
and screw into the threaded inserts on the Seat Cushion (B). Go back and fully tighten all the
bolts with the enclosed Allen wrench.
Ø1/4” x 1-1/8” Bolt
(4 used in this step)
②

Model # WC-594
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 7 Factory: ANJCHA
Assembly Instructions
9. Turn the assembled seat upright and locate the center hole of Mechanism (D) over the Gas
Lift (F). Press down firmly until the seat locks in place.
10.Insert the Plastic Caps (5) to cover the countersunk holes on Armrests (CL & CR).
Plastic Cap
(4 used in this step)
⑤

Model # WC-594
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 8 Factory: ANJCHA
OPERATING INSTRUCTIONS
1.To Adjust Seat Height:
While seated, lean forward and reach under the right side of the chair to find the handle. Lift the
handle and raise your body up slightly to allow the chair to rise to the desired height. To lower the
seat, lift the handle while applying more weight downward on the seat. The chair will descend until
the handle is released or the chair reaches the bottom position.
2.To Operate Tilt Lockout:
While seated, reach under the right side of the chair to find the height adjustment handle. Pull the
handle all the way out (away from the gas lift) to allow the chair to tilt backwards. To lock the chair
in the upright or vertical position, sit upright and push the handle in towards the gas lift.
3.To Adjust Tension on The Tilt:
Reach under the front center of the chair, grasp the round knob and turn it counter-clockwise to
stiffen the tilt mechanism. Turn the knob clockwise to loosen the tilt mechanism. Turn the knob
until the desired resistance is reached.

Model # WC-594
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 9 Factory: ANJCHA
INFORMATION FOR USE
1. This is one type of office chair for commercial or home use. Please use it only on
smooth, even flooring.
2. The height of the seat can be raised up and down by adjusting the handle of the
mechanism. The back can tilt after you pull the handle out.
3. Please check all bolts, screws and knobs are tight at least every 3 months or as needed.
4. If parts are missing, broken, damaged or worn, please stop using this product until
repairs are done by a trained person.
5. Only a trained person may replace or repair seat height adjustment components.
Do not stand on this chair, do not use chair as a stepladder.
Use this product only for seating one person at one time.
Do not use this chair unless all bolts, screws and knobs are securely tightened.
Dispose of packing material properly. Do not use plastic cover as head covering. It may
cause suffocation.
Use this chair for its intended purpose only.
Use mild detergent only for cleaning.
Failure to follow these warnings could result in serious injury.
Maximum load weight on chair is 225 pounds (102 kg).
LIMITED WARRANTY
We are confident that you will be delighted with your Whalen Furniture purchase.
Should this product be defective in workmanship or materials or fail under normal use, we
will repair or replace it for up to one (1) year from date of purchase. Every Whalen Furniture
product is designed to meet your highest expectations. We guarantee that you will
immediately see the value of our fine furniture.
To make a warranty claim, contact Parts Department. Provide model number, proof of
purchase, description of the problem and obtain return authorization. At its option Whalen
Furniture will:
(a)Supply compatible components of current manufacture.
(b)Repair the customer’s component.
The customer must prepay freight on any components returned to the factory. Return
freight on components still in warranty will be paid by Whalen Furniture.
This warranty gives you specific legal rights and you may also have other rights which vary
from State to State. Customer Service: 1-866-942-5362
8:30 a.m. - 4:30 p.m., PST, Monday to Friday
THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE MAXIMUM
WEIGHTS INDICATED. USE WITH LOAD HEAVIER THAN THE MAXIMUM WEIGHTS
INDICATED MAY RESULT IN INSTABILITY, CAUSING POSSIBLE INJURY.

IF YOU NEED TO ORDER ANY REPLACEMENT PARTS, PLEASE USE THE LIST BELOW
Breckenridge Executive Chair (WC-594)
F
1
2
CL
CR B
A
3
*WC-594-A-BR Backrest *WC-594-H-C Caster *WC-594-B-SC Seat Cushion *WC-594-CH Complete Hardware
*WC-594-CL-LA Left Armrest *WC-594-1-7/8B Ø5/16" x 7/8" Bolt *WC-594-CR-RA Right Armrest *WC-594-2-1 1/8B Ø1/4" x 1-1/8" Bolt *WC-594-D-M Mechanism *WC-594-3-2B Ø1/4" x 2" Bolt *WC-594-E-TC Telescoping Cover *WC-594-4-FW Flat Washer *
WC
-
594
-
F
-
GL
Gas Lift
*
WC
-
594
-
5
-
PC
Plastic Cap
4
H
G
E
D5
6
WC 594 F GL
Gas
Lift
WC5945PC
Plastic
Cap
*WC-594-G-5SB 5 Star Base *WC-594-6-AW Allen Wrench