Wilson Electronics 301104 User manual

Antenna
Antenna
Installation
G
u
ide
stallatio
stallat
Dual-Band
NMO Mount
Antenna
Features:
• Vehicle use
• Easy to install
• Permanent installation
• Requires antenna adapter (sold separately)
• Compatible with Wilson amplifiers (sold separately)
Wilson
®
Electronics, Inc.

1
30-Day Money-Back Guarantee
All Wilson Electronics products are protected by Wilson’s 30-day money-back
guarantee. If, for any reason, the performance of any product is not acceptable,
simply return the product directly to the reseller with a dated proof of purchase.
90-Day Warranty
Wilson Electronics antennas are warranted for ninety (90) days against defects in
workmanship and / or materials. Warranty cases may be resolved by returning the
product directly to the reseller with a dated proof of purchase.
Antennas may also be returned directly to the manufacturer at the consumer’s
expense, with a dated proof of purchase and a Returned Material Authorization
(RMA) number supplied by Wilson Electronics. Wilson shall, at its option, either
repair or replace the product. Wilson Electronics will pay for delivery of the repaired
or replaced product back to the original consumer.
This warranty does not apply to any amplifiers determined by Wilson Electronics
to have been subjected to misuse, abuse, neglect, or mishandling that alters or
damages physical or electronic properties.
RMA numbers may be obtained by phoning Technical Support at 866-294-1660.
Disclaimer: The information provided by Wilson Electronics, Inc. is believed to
be complete and accurate. However, no responsibility is assumed by Wilson
Electronics, Inc. for any business or personal losses arising from its use, or for
any infringements of patents or other rights of third parties that may result from
its use.
Copyright © 2008 Wilson Electronics, Inc. All rights reserved.
How it Works
Wilson’s Dual-Band NMO Mount antenna will collect the cell tower signal and
send it through the cable to an amplifier or directly to the cell phone or cellular
data card. When the cell phone or cellular data card transmits, the signal is
transferred to an amplifier or directly to the antenna and broadcast back to the
cell tower. See the back cover for information on Wilson amplifiers.
Antenna Adapter
An 18-inch external adapter is required to connect the cell phone or cellular data
card to the antenna. The external adapter is cell phone/data card-specific and
may be purchased through a local retailer. Refer to Wilson’sAdapter Guide to
identify the right adapter for your cell phone or cellular data card. TheAdapter
Guide is available through a local retailer. It is also available on our web site,
www.wilsonelectronics.com, or you may call Technical Support at 866-294-1660.

2
Select a location for mounting the antenna. The best location would be
centered on the vehicle roof, although other locations are acceptable.
For mounting the antenna on the trunk of a vehicle, use Wilson Part #
901101. Slide the bracket into place on the trunk or hood lip. Tighten the
two set screws on the bottom lip underneath the trunk or hood lip.
For roof mounts, Wilson part # 901102 or #901103, drill a hole in the
selected location. The size of the hole should be 3/8” or 3/4” depending
on the mount purchased. Place the NMO mount up through the bottom
of the hole. Place the threaded nut on top of the mount, outside of the
vehicle and tighten.
Route the cable between the hole or the mount, and the location of the
amplifier or the cell phone.
Screw the antenna coil into place on top of the vehicle.
1
1
2
2
3
3
4
4
5
5
Installing the NMO Mount Antenna

3301 East Deseret Drive, St. George UT 84790
For additional Technical Support visit
www.wilsonelectronics.com
Phone: [phone] Fax: [phone]
Part# 103040 AIG NMO 006 / 01.30.08
Wilson
®
Electronics, Inc.
Antenna Specifications
Part Number 301104
Frequency Range 806-894 MHz / 1850-1990 MHz
Impedance 50 ohms
Antenna Gain 4.9 dBi 806-894 MHz / 5.9 dBi 1850-1990 MHz
Radiation Omni
Polarization Vertical
Wavelength 1.0 Wavelength 806-894 MHz / 2.1 Wavelength 1850-1990 MHz
Ground Plane Metal ground plane required
Connector FME-Female
Material Whip - Stainless Steel
Height 13.88 inches / 35.3 cm
Mount
NMO Mount Types (sold separately)
Trunk Mount (14’ RG-58 Coax) Part# 901101
3/8” Hole - Roof Mount (14’ RG-58 Coax) Part# 901103
3/4” Hole - Roof Mount (14’ RG-58 Coax) Part# 901102
Wilson Amplifiers Boost Coverage
When used in conjunction with your antenna, a Wilson Amplifier can improve
your cell phone and laptop data card coverage area up to 50 miles. Wilson
manufactures a wide range of wireless and direct-connection amplifiers
for mobile or in-building use. See your dealer for details or visit www.
wilsonelectronics.com.