Winners Only DST54041 User manual

WINNERS ONLY
®
ASSEMBLY INSTRUCTIONS
PROD. NO: DST54041
Thank you for purchasing this quality product. Please read instructions thoroughly before unpacking
the assembly parts.
1 OF 2
Caution : Sharp exposed staple tips can cause injury, therefore for your protection, please remove any exposed
staples used in packing.
Please keep all hardware parts out of the reach of children.
1. We recommend that you should assemble this product with assistance of another person; this will
make the assembly easier, and will help to prevent personal injury and to insure parts are not damaged during
the assembly process.
2. Before beginning, please check the packing materials carefully for small parts which may have come
loose inside the carton during shipping. Please do not discard any packing material until all parts have been
located. If any parts are missing, please contact your dealer for prompt replacement.
3. To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residues and rough surfaces and also check for staples or nails left after removing the packing materials.
The manufacturer will not be held responsible if preventive steps are not taken prior to installation.
4. Please do not over tighten screws or bolts. During normal use everyday, screws, bolts, nuts and wooden
plugs may loosen up. They should be periodically inspected and re-tightened to prevent damage to the furniture
and (or) peronal property or cause injury. Always check to be sure all hardware on this list and the below
mentioned components are attached to the furniture properly and kept tightened.
5. Please lay all parts and hardware on a non abrasive surface such as a carpet, and follow the assembly.
Hardware List:
2
QTYSKETCHDESCRIPTION
NO
1
SIZE
This product will take 15-20
minutes to assemble
3
Screw driver is require for assembly (not included)
TIP: store the Allen key and or Wrench used in assembly in
this product's drawer or use masking or painter's tape to
affix it to the underside of the product. This will make it
easier to find if you want to periodically tighten bolts or
disassemble the product.
Components List:
B
QTYSKETCHDESCRIPTION
NO
ATABLE TOP
4 PCS
LEG
1 PC
4
MADE IN MALAYSIA
516
"
X 65mm 8 PCS
SPRING WASHER
M8 X 13mm 8
PCS
8 PCS
FLAT WASHER M8
X 18mm
HEX BOLT
1 PCWRENCH 12.8mm

Step.2 Turn the table to a standing position.
Step.3 Check the table balance and tighten
all the screws and bolts to complete the
assembly.
Step 1.1 Attach Leg (B) to Table top (A)
as shown on FIG 1.1
Step 1.2 Secure all Legs (B) by tightening
Hex bolt (1), Spring washer (2) and
Flat washer
（ 3 ） with Wrench (4) provided
as shown on FIG 1.2
Assembly is now complete.
2 OF 2
WINNERS ONLY
®
ASSEMBLY INSTRUCTIONS
PROD. NO: DST54041
Protective surface
A
1
23
4
B
FIG 1.2 FIG 1.1