WowWee Alive Lion Cub User manual

User
manual
Ages 3 +
Items No. 9007, 9008, 9009, 9010

Contents
Contents p1
Introduction
Package contents p2
Alive Cub overview p3
Battery details
Battery requirements p3
Battery installation p4
Important battery installation
Getting to know your Cub p5
Alive Cub’s basic features
Powering ON/OFF the rst time
Try Me setting p6
Normal setting
Powering ON/OFF in normal play p7
Volume control
Sleep Mode
Playing with the Cub p8
Important safety information p8
FAQs p9
Limited warranty p10
1
Introduction

Contents Introduction
Thank you for purchasing an Alive™ Cub from
WowWee®!
Your WowWee Alive™ Cub is a huggable and lifelike animal cub that wants you to
adopt him and take him home! Give him love and attention and he comes “alive”!
Stroke his back, pat his head or cradle him in your arms and he responds with
blinking eyes, an animated mouth and cub sounds. And, he even purrs to let you
know when he’s falling asleep!
Take a few minutes to look through this user manual so you can get to know
your Cub!
Package contents:
1 x WowWee Alive Cub
1 x User manual 1 x Adoption certi cate
2
• Lion Cub • White Tiger Cub • Panda Cub • Polar Bear Cub

Alive Cub overview
Battery details
This section outlines battery requirements and installation procedures.
The Cub will tell let you know when his batteries need changing. His movements will
slow down and his audio level is always low, even if you try to adjust the volume.
Battery requirements
The Alive Cub requires 4 x “AA” size alkaline batteries (included).
Alive Cub overview / Battery details / Battery requirements
3
Touch sensor (back)
Main power switch
(underneath)
Battery compartment
(underneath)
Moving mouth
Try Me button
Blinking eyes
Touch sensor (head)
Volume toggle/
Quick power switch

Alive Cub overview / Battery details / Battery requirements Battery details / Battery installation / Important battery information
Battery installation
NOTE: Make sure the main power switch is set to OFF prior to changing the
batteries.
To install or change the Cub’s batteries:
1. Locate and open the battery
compartment door on the belly of the
Cub by opening the ap of fur.
2. Use a Phillips screwdriver (not included) to remove the two screws on the
battery compartment door.
3. Insert the batteries according to the
diagram. Ensure that the positive
and negative polarities match the
illustrations inside the battery
compartment.
4. Replace the battery compartment
door and replace the screws using the
screwdriver. Do not over-tighten.
Close the ap on the Cub’s belly.
4
Important battery information
• Use only fresh batteries of the required size and recommended type
• Do not mix old and new batteries, different types of batteries [standard (Carbon-zinc),
Alkaline or rechargeable] or rechargeable batteries of different capacities
• Remove rechargeable batteries from the toy before recharging them
• Rechargeable batteries are only to be charged under adult supervision
• Please respect the correct polarity, (+) and (-)
• Do not try to recharge non-rechargeable batteries
• Do not throw batteries into the re
• Replace all batteries of the same type/brand at the same time
• The supply terminals are not to be short-circuited
• Remove exhausted batteries from the toy
• Batteries should be replaced by adults
• Remove batteries if the toy is not going to be played with for some time
• This instruction manual should be kept as it contains important information
OFF
Try Me Normal
6V
1.5VLR6
UM3“AA”
1.5VLR6
UM3“AA”
1.5VLR6
UM3“AA”
1.5VLR6
UM3“AA”
OFF
Try Me Normal

Getting to know your Cub / Alive Cub’s basic features
5
Getting to know your Cub
Now that you’ve adopted your own WowWee Alive Cub, it’s time to get to know
him better.
Alive Cub’s basic features
The Cub has a moving mouth and eyes that blink and respond. He also makes an
array of baby animal sounds.
He is equipped with a touch sensor on his head, and one on his back. He also has
a tilt sensor which can tell him when he’s turned over or upright.
Powering ON/OFF the first time
The Cub’s main power switch is located on his belly which you can access
through the ap beneath in his fur. The switch has three settings: Try Me,
OFF, and Normal.
NOTE: You will only need to access the main power switch when you rst
use him and/or when you change his batteries. After that, you can turn him
on or off using his quick power switch (see the section Powering ON/OFF in
normal play).

Getting to know your Cub / Alive Cub’s basic features Getting to know your Cub / Powering ON/OFF the first time
Try Me setting
When you rst remove the Cub from his packaging, the switch will
be set to Try Me. The Try Me function is used for demonstrating
basic functions.
Normal setting
When you want to play with him and access all
his functions, you need to rst set the switch to
the OFF setting, and then wait 3 seconds before
moving it to the normal position or setting it in
the normal position.
IMPORTANT: When switching between Try Me and Normal power settings, you
need to set the switch to OFF rst, and then wait 3 seconds before changing the
power setting. If you do not wait after switching the Cub to the OFF setting, he
will remain in the previous power setting.
NOTE: In Normal power setting, the Try Me button becomes a button sensor
located on his left ear. You can use this button to activate his cub behaviors, just
as you would by scratching his head or rubbing his back!
6
OFF
Try Me Normal
OFF
Try Me Normal
OFF
Try Me Normal
OFF
Try Me Normal
3 seconds

Powering ON/OFF in normal play
The Cub’s quick power button is located on his right ear. Once you set (rather than
switch) the power switch to Normal setting, your Cub should automaticallly be in
normal play mode when turned on. To turn him on after he powers down and enters
Sleep Mode:
• Ensure the main power switch is set to Normal. Locate the quick power button
and press it once.
NOTE: If you press it more than once after switching it to
the Normal setting, you will be toggling the volume levels.
To turn him OFF:
• Locate the quick power button and hold it down for about 3 seconds.
Volume control
You can adjust the volume to high or low on the Cub’s right ear using the quick
power switch to toggle the levels. To do so:
• Press the quick power button once to toggle between high and low volume levels
Sleep Mode
To conserve batteries, the Cub will go to into Sleep Mode after about 5 minutes if
you leave him unattended. He will close his eyes and purr for about 5 minutes in
Sleep Mode if continued to be left unattended, after which he will power down to
save batteries.
When you want to wake him from Sleep Mode, interact with him by touching his
head or his back, or you can press the buttons on either ear.
NOTE: You should turn the Cub off after he enters Sleep Mode if you are not going to
play with him after he goes to sleep.
The Cub reacts like a real animal cub – he will squeal, growl and purr, as well as blink,
and smile.
Powering ON/OFF in normal play / Volume control / Sleep Mode
7

Powering ON/OFF in normal play / Volume control / Sleep Mode Playing with the Cub / Important safety information
When you rst turn him on, he will open his eyes , open and close his mouth,
and then make a wake up sound. After that, he is ready to play with you!
Scratch or pet his head to see how he reacts. You can also stroke him on his back and
feel his “bones”!
Turn him over on his back and he’ll react. Turn him upright again to see what he does.
Be careful though – if you touch him or turn him over too many times, he might get
annoyed and growl at you!
Spend some time to get to know your Cub by cuddling up with him and giving him
affection!
NOTE: When you are done playing with him, make sure you turn him off.
8
Important safety information
Take note of the following when playing with the Cub:
• Avoid putting articles of clothing on him as it might inhibit the proper functioning of his sensors.
• Do not immerse the Cub or any parts of him in water or any other form of liquid.
• Do not drop, throw, or kick the Cub as this might damage his mechanical functions.
• If his fur becomes dirty, you can clean it using a clean cloth slightly dampened with warm water.
• Do not jam anything into his mouth or into his eyes.

FAQs
Q. My Cub seems to be moving and responding slower than normal… what’s wrong?
A. You probably need to change the batteries in the Cub. Refer to the Battery
details section for information on battery requirements and installation.
Q.
My Cub speaks more quietly than normal… how do I x that?
A. Either you have the Cub’s volume levels set at low (see the section Volume
control ), or you probably need to change the batteries in the Cub. Refer to the
Battery details section for information on battery requirements and installation.
Note that when you turn him on his back, his volume level automatically
lowers if it is set to high volume level. When you put him upright again, his
volume level should return to high volume if he was already at high volume.
Q.
The Cub’s facial animations have stopped and he just purrs… what’s wrong?
A. Your Cub is probably in Sleep Mode. To wake him from Sleep Mode, pick him up
or touch him on his head or back, or press on his quick power button on either
ear once.
Q.
The Cub seems to say only 4 different things… what’s wrong?
A. Your Cub is probably in Try Me power setting. See the section Powering ON/OFF
the rst time for how to set him in Normal play setting.
FAQs
9
For more information on Alive Cubs, go to
www.wowweealiveonline.com
If you have any questions that are not answered in this manual, refer to
www.wowweesupport.com
To see the full range of WowWee products, go to
www.wowwee.com
Register at www.registerwowwee.com
Limited warranty