YBIKE YBX User manual
OWNER’S MANUAL
THE ART OF BALANCE
Read this manual carefully:
Read and understand this entire manual before use the product!
This Owner’s Manual contains important information on safety,
operation and maintenance of your YBX Stunt Scooter
www.ybike.co.za
SAFETY INFORMATION
- Warning! not suitable for children under 5 years of age due to small parts - choking hazard.
- Adult assembly required.
- This product is for children aged 5 years +.
- Maximum total weight 100 kg.
- Always wear a helmet, wrist, knee and elbow pads when riding your scooter and keep the helmet chinstrap securely buckled.
- Always wear closed shoes when riding your scooter.
- Ride on smooth, paved surfaces away from motor vehicles and other road users.
- Avoid sharp bumps, drainage grates, and sudden surface changes, that might cause the scooter to suddenly stop.
- Avoid streets and surfaces with water, sand, gravel, dirt, leaves and other debris. wet weather impairs traction, braking and visibility.
- Do not ride at night.
- Brake will get hot from continuous use, do not touch after braking.
- Avoid excessive speed associated with downhill rides.
- Watch out for pedestrians.
- Check and secure all fasteners before every ride.
- The scooter is designed for one rider at a time.
- Do not use the scooter if it has any damage.
- Replace worn or broken parts immediately.
- Read the information supplied by the manufacturer.
- Do not ride scooter with one hand.
- Both hands should be on both handles at all times.
- Adult supervision is required during the initial assembly and maintenance procedures.
- Injury may occur if the precautions above are not observed and followed.
- Please check the limitation of use according to regulations of road safety.
- Important! The self-locking bolts and other self-locking parts may lose their eciency.
1
- Keep the product in a dry place. if the scooter gets wet, dry metal parts to prevent rusting.
- Clean with damp cloth. do not use solvents or bleaches for cleaning.
- This scooter is equipped with precision bearings which were lled with lubricant at high pressure during manufacturing.
For this reason, the wheels can only run easily and quickly when there is a load on the scooter.
- The bearings are maintenance free.
- The wheels should be replaced when they get worn.
- For your own safety, please use original spare parts only. Do not make any structural changes.
- No modication other than to the manufacturer's instruction shall be made.
- Please rotate the bearings and wheels to check if they are rolling smoothly.
- Clean regularly paying attention to the moving parts, clearing them of grit and dirt so they move freely.
- Ensure parts specications are correct with the dealers if some parts need to be replaced.
- Ensure the front fork, wheels and handlebar are xed tightly.
- You can use a wrench to tighten the locking nut. Use rm pressure but don’t over tighten.
CARE
TRICK/STUNT RIDING AND WARRANTY
- If you ride your scooter in a manner that places large forces and stresses on the product, the scooter will not be covered under warranty.
- The scooter is designed to meet and exceed applicable safety standards,
however the forces exerted through extreme riding will cause premature wear to all parts.
2
PLEASE CHECK THAT YOU HAVE ALL THE PARTS LISTED BELOW
1. HANDLE BAR X 1
2. SCOOTER BODY X 1 3. CLAMP X 1
5. ALLEN KEY X 2
3
www.ybike.co.za
6. STUNT PEG X 2 7. STUNT PEG BOLT SET X 24.BOLT SET X 3
4
www.ybike.co.za
PRO HAND GRIPS
STEEL Y-BAR 460MM (Y)
ALUMINIUM TRIPLE CLAMP
STEEL FRONT FORK
HIGH SPEED
ABEC 9 BEARINGS
CONCAVE
ALUMINIUM DECK
FLEX REAR BRAKE
100mm PU CAST WHEEL
A) Place the clamp over the vertical tube of the handle bar, then insert the handle bar onto the fork stem.
B) Push the handlebar with clamp onto the fork stem until it’s up against the headset.
C) Tighten the bolt set one by one from bottom to top. Repeat the process until all bolts are securely tightened.
5
www.ybike.co.za
INSTRUCTIONS FOR USE
- Grip the handlebars with your hands, place one foot on the deck (board)
and the other foot on the ground.
- Pay attention to your surroundings and make sure that your riding area is clear.
- Kick backwards with your foot beside the scooter to give you motion.
- Repeat this kicking action in order to stay in motion.
- To stop or slow down, place your kicking foot on the brake pedal
above the rear wheel or put your kicking foot on the ground.
- Do not over-steer as this could cause you to fall o the scooter.
6
www.ybike.co.za
USE
HOW TO INSTALL
FRONT STUNT PEG AND STUNT PEG AXLE
HOW TO INSTALL
REAR STUNT PEG AND STUNT PEG AXLE
www.ybike.co.za
ENJOY YOUR NEW
Table of contents
Other YBIKE Scooter manuals
