YOTRIO Target Martti FRS60725 User manual

steel wicker club chair
style # FRS60725
dpci # 009002175
>>assembly instructions TM
Martti

Congratulations on your latest Target purchase.
Now what? Don't start sweating over this box of parts. This will be easy. We did the hard work for you.
All you need to do is follow our simple instructions and you'll be on your way to transforming your patio in no time.
Good luck – though we're confident you won't need it.
ATTENTION:
This Chair is not intended for use during any kind of inclement weather and the manufacturer is not
and can not be held responsible for any damages caused as a result of such weather. Weather-related
damage, or damage as a result of the Chair not being stored properly when not in use is not the
responsibility of the manufacturer.
During extended periods of non-usage, off season, or in inclement weather (wind, rain, snow, hail,
sleet), freezing conditions and extreme heat, the Chair needs to be stored in a dry sheltered place to
prolong the life and to avoid damage to the Chair.
2
IMPORTANT WARNING:
Unpack the box on a clean soft level surface and make sure all parts have been included.
To replace missing or damaged parts please call 855-MYTGTHOME (855-698-4846) during 7am - 7pm CST M-F, and 8am - 5pm CST Saturday.

otrio 2020
3
WARRANTY:
This Chair comes with a one year limited warranty against original manufacture defects. If you experience
trouble with your new chair, please call the customer service number below.
before you begin
1. Check for damage or missing parts. Call 855-MYTGTHOME (855-698-4846) to order missing supplies.
2. Use the carton as a working surface to prevent product damage during assembly.
3. Gather all tools prior to assembly.
Target Corporation
Toll Free at: 855-MYTGTHOME (855-698-4846) during 7am - 7pm CST M-F, and 8am - 5pm CST Saturday.
Code: Y

table of contents
introduction
hardware
parts list
assembly
2-3
5
6
7-8
QUESTIONS?
4Please call 855-MYTGTHOME (855-698-4846) parts and service. For faster service, have th e style number and DPCI number r eady when calling.

hardware
5
(Part C)×8
M6*35mm bolt with washer
(Part D)×1
allen wrench
ATTENTION: THE HARDWARE KIT IS FOR 2 CHAIRS

ITEM DESCRIPTION QUANTITY
2
A
6
chair frame
Bchair base 2
A
B

7
step 01:
(Part C)×4
M6*35mm bolt with washer
(Part D)×1
allen wrench
ATTENTION: To avoid damage to your new patio furniture, please
use either the carton or another soft surface such as carpet as a
working surface to prevent product damage during assembly.
2. Secure with M6*35mm bolt with washer (C) using allen wrench (D).
Do not completely tighten screws until all screws are in place.
C
B
A
1. Connect the chair base (B) to the chair frame (A) by aligning the bolt holes at the
end of the chair frame (A) with the corresponding bolt holes on the chair base (B).
3. Repeat above step for the other chair.

step 02
8
1. Tighten all the bolts.
2. Turn the chair to upright position onto a flat level surface.
Put the cushions on the chair.
You are now ready to enjoy your new chair.

9

TM
2020 Target. The Bullseye Design is a trademark of Target Brands Inc. All rights reserved.