Yowza Sanibel i35 User manual

Express Assembly Guide
Use this Guide for the following Yowza M od e ls :
Sanibel i35

1.1 Place the unit in the room where you will exercise. Cut the
straps and bottom of the carton all the way around.
1.2 Lift carton from the pallet and discard plastic wrap. Remove
all components from the interior of the box.
**IMPORTANT: Handle hardware pack carefully to avoid
the dislocation of screws and bolts inside the pack.
1.3 Cut straps at front and back of the unit and remove the
elliptical.

2.1 Attach Incline Frame Lower Covers (341, 342) to the Incline
Frame. Carefully snap pieces together using plastic guides,
then secure with Cone Point Screw (408).
TIP: Using a magnetic screwdriver will be beneficial
when inserting all screws during assembly.

3.1 Remove the Undercarriage Covers (704, 705) from the main
frame by lifting the pedal assembly.
Carefully handle covers to avoid snapping the plastic
push pins (403).
Make sure the Rear Incline Frame Holders (206) are
securely fastened to Main Frame.

4.1 Attach Incline Frame Assembly (A3) to the main frame.
Secure Incline Frame Holder-Front (708) to Incline Frame
using Allen Head Bolts (511) and Washers (517). Do not
fully tighten Bolts (511) until step 4.2.
4.2 Align bolt hole of Incline Frame with Transmission Tube
Front (110) and secure using Allen Head Bolt (507) and
Nylon Nut (508). Fully Tighten Allen Head Bolt (507) with
8mm Allen Key provided.

5.1 Attach Console Support Tube Assembly (A2) to the Main
Frame using M8x20mm Allen Head Bolts (504). Connect 8-
Pin Power Wire-Upper (601) to Power Wire-Lower (602).

6.1 Attach the Undercarriage Covers (704, 705) to the Main
Frame by lifting pedal arm and securing with Flat Point
Screw (506), Screw (509) and Screw (510).
6.2 Attach Incline Frame Front Cover (703) to Incline Frame
using two Screws (520).

7.1 Slide Bolt (505) through Washer (494), Wave Washer (521),
Pedal Arm and thread into Pedal Swing Arm (108) securing
with 8mm Allen Key.
7.2 Insert Back Out Screw (516) into Pedal Swing Arm (108)
using the 2.5mm Allen Key –Fully Tighten.
7.3 Press the Pedal Arm Pivot Cover (702) into the ends of the
Pedal Arm.

8.1 Connect Action Arms (118, 119) to the Moving Linkages
(104, 105), secure using Bolt and Nut (502, 503) using 6mm
Allen Key. **Do not over-tighten these bolts, over-
tightening will result in friction related sounds.
8.2 Put the Action Handlebar Lower Covers on (701) to the
Action Arm and secure using Cone Point Screw (501).

9.1 Install the moving handlebars and tighten Allen Head Bolts
(514) to lock the handlebars in place using the 5mm Allen
Key.