ZKTeco ZL400 User manual

Installation Guide
Version: 1.0
Date: February 2020
Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual
product and the written information in this manual.
ZL400

Installation Diagram
P
A
E
H
I
T
A
B
C
D
F
G
J
K
L
M
K
N
O
Q
R
H
S
1

Precautions
Do not overexert the screws
during installation.
Do not use electric tools
to tighten the screws.
Wear safety glasses to protect
your eyes when drilling and
slotting
2
R
R
Inward
direction
Outward
direction

Installation Steps
1. Align the template along the vertical center line of the mortise at a
desired handle height and hold it together with the door. Then,
drill holes on the door.
Desired handle height
Handle centerline
Door thickness 35 to 55mm
Backset 70mm
3

2. Remove the two screws (D) from the mortise latch plate
A
C
D
D
A
4

3. Fix the Mortise (A) 4. Fix the Mortise latch plate (C)
C
D
D
B
B
A
Note: Two Triangles on the mortise must be aligned horizontally
(as shown in the above image).
5

5. Affix the lock cylinder (E)
EFG
G
F
E
F
E
6

6. Attach the 8x8 spindle (H) and fix the outdoor unit (I)
H
H
H
J
K
H
I
JK
Note:
Make sure that two triangles of the mortise are always horizontally aligned as described in step 3.
K
7

H
L
M
H
L
L
H
L
M
K
7. Attach the 8x8 spindle (H) and 5x5 spindle (L). Then fix the
indoor unit (M)
8

O
N
125mm
89mmX25mm
22mm
3mm
S
S
QR
P
P
8. Connect the batteries (N)
9. Measure the doorframe for strike
dimensions and drill the hole
9

10. Test lock
1. Test the lock by rotating the handle and emergency key.
2. You can use the emergency key by removing the cover
on the lock cylinder with a screwdriver or nails.
Maintenance
1. Avoid contact with corrosive substances.
2. Do not hang any object on the handle.
3. When the battery power is low, the lock will
beep to remind the user to renew the batteries.
4. Please do not mix up with the positive and
negative terminals while replacing the battery.
5. To avoid battery leakage, it is preferable to
renew the battery at least once in half-a-year.
Do not use a battery of poor quality.
1.The demonstration figures in this installation
guide may different with the actual product,
the actual product shall prevail.
2. The software within the lock manages the
RFID cards. For more details, please refer the
software user manual.
3. Keep the emergency key safe as a backup.
4. For further queries, please contact the seller.
T
10
Disclosure

www.zkteco.eu
Copyright 2020 ZKTECO CO., LTD. All Rights Reserved.