Allegion Von Duprin 374-T-BE User manual

*941146-00*
941146-00
1. Prepare door for exit device. See exit device
instructions for holes and backset.
2. Transfercenter line from inside (exit device
side) ofdoor to outside (control side) of door.
Use extra care if edge of door is beveled. Be
sure center line is parallel to edge of door.
3. Locate and prepare all holes as indicated in
diagrams on other side.
4. Install exit device.
5. Make sure control cam is in position shown
in Figure 1.
6. Install cylinder, if used, in control (Figure 2).
7. Make sure control cylinder plate is correct for
desired function (NL or TL; Figure 3).
8. Disconnect top vertical rod.
9. Apply control, wood door cover plate, and rub
plate to door and secure with screws (Figure 4).
10. Place rod member on top vertical rod so rod
member finger faces door and curved side of
rod member finger faces down (Figure 5).
11. Insert rod member finger into slot in door.
Reconnect top vertical rod.
12. With top latch bolt extended, slide rod
member up rod so rod member finger
touches control cam.
13. Tighten set screws in rod member with 1/8”
hex wrench.
14. Test key, control, and exit device action.
Figure 1. Control cam position.
Control
cam
Cylinder nut
Mortise cylinder
cam must be in
position shown with
key removed; if
necessary, remove
cam and install in
correct position
Figure 2. Cylinder installation.
Mortise
cylinder
Figure 3. Cylinder plate.
1/4-20 x 7/8”
undercut flat
head screw
Countersunk
washer with
1/4-20 oval
head screw
#14 wood screw
Rub plate
Wood door cover plate
Figure 4. Control and rub plate
application.
Figure 5. Rod member position.
Rod
Rod member
Curved side of
rod member
finger faces down
Cylinder plate
NL
TL
To change
cylinder plate,
remove screw
and washer
2227
2227-F
9827/9927
9827-F/9927-F
Surface Vertical Rod Device
Application Schedule
3327/3527
3327A/3527A
3327A-F/3527A-F
Control for Wood Door Applications
374-T & 374-T-BE
Installation Instructions
© Allegion 2014
Printed in U.S.A.
941146-00 Rev. 01/14-b
Customer Service
1-877-671-7011 www.allegion.com/us

3”
1 7/8”
6 1/4”
1/2” dia.
2 places
11/16” R, 2 places
1-3/8” dia.
BE only
53-1/2”
to finished
floor
5/16” dia.
2 places
1-1/4”
5/8”
1/8”
1”
2-7/8”
Drill pilot hole 3/4” deep for
#14 wood screw; size of pilot
hole for wood door depends
upon hardness of wood
5/16” R
L
C
thumbturn
Omit
slot
for BE
OUTSIDE FACE
OF LOCK STILE
INSIDE FACE
OF LOCK STILE
For cutouts on inside face of door, see exit device instructions.
1-5/8” dia.
1/4”
1”
LHR shown
RHR opposite
Inside
Outside
Center line exit device and latch case corresponds to
center line exit device and latch case on exit device instructions
L
Cexit device
and latch case
L
C
exit device
and latch case