3D Systems CUBE User manual

2016年6月14日
1
1
3D SYSTEMS University
Cube 3D Printer
“Lesson –Replacing the Print Tip”
Revision date: 10/20/13

Objectives
After completing this lesson you will:
Be able to remove the damaged print tip
Know the steps for installing the new print tip

Tools You Will Need
Print Tip Assembly
2.5mm Hex Driver
Pliers
T10 Torx Key
3

First Steps
Before beginning this process please remove all
filament from the print jets and check that your print
pad is level. For instructions on how to do this please
refer to the CubeX users guide
4

Removing the Damaged Print Tip
Turn off the CubeX and Unplug it
from the mains power.
Unplug the print tip from the Print
jet sensor board and feed the wire
down the hole to the print tip.
5

Removing the Damaged Print Tip
Unfasten the print tip holding bolt.
6

Removing the Damaged Print Tip
The print tip and print jet are assembled by sliding the
print tip into the print jet and twisting it (as pictured).
7

Removing the Damaged Print Tip
To remove the print jet you will need to twist it and pull down,
eventually you will find the correct orientation and the print tip
should easily slide out.
8

Installing the New Print Tip
Feed the print tip wires up through the print jet carriage
and plug them into the Print Jet sensor board.
9

Installing the New Print Tip
Slide the new print tip into the print jet and turn it until
the print tip wires are orientated to travel straight up to
the Print Jet sensor board.
10