Aaeon HSB-440I User manual

HSB-440I
Half Size CPU Card
STPC Atlas SoC 133MHz
With LCD, Ethernet,
Two USB Ports
HSB-440I Rev. A Manual
July 2003

Half-size CPU Card HSB-440I
i
Copyright Notice
This document is copyrighted, 2003. All rights are reserved. The original
manufacturer reserves the right to make improvements to the products
described in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated, or
transmitted in any form or by any means without the prior written
permission of the original manufacturer. Information provided in this
manual is intended to be accurate and reliable. However, the original
manufacturer assumes no responsibility for its use, or for any in-
fringements upon the rights of third parties that may result from its use.
The material inthis document is for product information only and is
subject to change without notice. While reasonable efforts have been
made in the preparation of this document to assure its accuracy,
AAEON assumes no liabilities resulting from errors or omissions in this
document, or from the use of the information contained herein.
AAEON reserves the right to make changes in the product design
without notice to its users.

Half-size CPU Card HSB-440I
ii
Acknowledgments
All other products’ name or trademarks are properties of their
respective owners.
l Award is a trademark of Award Software International, Inc.
l CompactFlash™is a trademark of the Compact Flash Association.
l STPC® is trademarks of STMicroelectronics.
l DOC2000®is a registered trademark of M-System Co., Ltd
l Microsoft Windows®is a registered trademark of Microsoft Corp.
l VGA®is a registered trademark of IBM Corp.
l Winbond is a trademark of Winbond Electronic Corp.

Half-size CPU Card HSB-440I
iii
Packing List
Before you begin installing your card, please make sure that the
following materials have been shipped:
•1 HSB-440I Half-size CPU Card
•1 Quick Installation Guide
•1 CD-ROM for manual (in PDF format), BIOS, and drivers
•1 HDD Cable
•1 FDD Cable
•1 Short-copper and support
•1 Y-Cable (Keyboard and Mouse)
•1Parallel Port and Serial port cable with bracket
•1Dual Serial port cable with bracket
If any of these items should be missing or damaged, please contact your
distributor or sales representative immediately.

Half-size CPU Card HSB-440I
iv
Contents
Chapter 1 General Information
1.1Introduction .................................................................................... 1-2
1.2Features ............................................................................................ 1-3
1.3Specifications................................................................................... 1-4
Chapter 2 Quick Installation Guide
2.1 Safety Precautions .......................................................................... 2-2
2.2 Location of Connectors and Jumpers......................................... 2-3
2.3 Mechanical Drawing ...................................................................... 2-5
2.4 List of Jumpers................................................................................ 2-7
2.5 List of Connectors.......................................................................... 2-8
2.6 Setting Jumpers............................................................................... 2-9
2.7 LCD Voltage Selection (JP1)........................................................ 2-10
2.8 TTL-LCD Clock Selection (JP2) ................................................. 2-10
2.9 Onboard COM Port on/Off Selection (JP3)............................ 2-10
2.10 Clear CMOS (JP4)........................................................................ 2-10
2.11 COM2 RS-232/422/485 Selection (JP5 & JP7)..................... 2-11
2.12 DiskOnChip 2000 Address Selection (JP6)............................. 2-11
2.13 Front Panel Connector (CN1) ................................................... 2-11
2.14 LPT Port Connector (CN2) ....................................................... 2-12
2.15 TTL LCD Connector (CN3)...................................................... 2-12
2.16 AT Power Connector (CN4)...................................................... 2-13
2.17 COM3/COM4 RS-232 Serial Port............................................ 2-14

Half-size CPU Card HSB-440I
v
2.18 Digital I/O Connector (CN7).................................................... 2-14
2.19 USB Connector (CN8)................................................................ 2-14
2.20 COM2 RS-232/422/485 Serial Port......................................... 2-15
2.21 Internal Mouse Connector (CN10)........................................... 2-15
2.22 Internal Keyboard Connector (CN11) ..................................... 2-15
2.23 IrDA Connector (CN12) ............................................................ 2-16
2.24 PS2 Keyboard/ Mouse Connector (CN13)............................. 2-16
2.25 4P Power Connector(CN14)...................................................... 2-17
2.26 3P Power Connector (CN15)..................................................... 2-17
2.27 Floppy Connector (FDD1) ........................................................ 2-17
2.28 EIDE Connector (HDD1)......................................................... 2-18
2.29 VGA Display Connector (VGA1) ............................................ 2-19
2.30 COM1 RS-232 Serial Port Connector (COM1)...................... 2-20
2.3110/100Base-Tx Ethernet Connector (LAN1)......................... 2-20
Chapter 3 Award BIOS Setup
3.1 System Test and Initialization. ..................................................... 3-2
3.2 Award BIOS Setup......................................................................... 3-3
3.3 Standard CMOS Feture................................................................. 3-5
3.4 Advanced BIOS Features ............................................................. 3-6
3.5 Advanced Chipset Features .......................................................... 3-7
3.6 Integrated Peripherals.................................................................... 3-8
3.7 Power management setup............................................................. 3-9
3.8 PnP/PCI configuration ................................................................. 3-10
3.11 Load Fail-Safe defaults ................................................................ 3-11
3.12 Load Optimized defaults ............................................................ 3-11

Half-size CPU Card HSB-440I
vi
3.13 Set Supervisor/User password................................................... 3-11
3.14 Save & Exit setup......................................................................... 3-12
3.15 Exit without saving ...................................................................... 3-12
Appendix A Programming the WatchDog Timer
Programming the watchdog timer .........................................................A-2

Half-size CPU Card HSB-440I
Chapter 1 General Information 1-1
General
Information
Chapter

Half-size CPU Card HSB-440I
Chapter 1 General Information 1 -2
1.1 Introduction
HSB-440I is AAEON’s half-size ISA bus CPU card with STPC Atlas
low power consumption single chip solution. This single chip
integrated many kinds of functions like: processor, graphic controller
(with LCD interface), PCI bridge, and simple super I/O.
Fanless and Low power Consumption Design
With AAEON’s HSB-440I half-size CPU card, the STPC Atlas 133
MHz low power consumption CPU has been specially designed to
work well in environments with temperatures of up to 60℃without
the cooling fan. Eliminating the CPU cooling fan from a system
significantly reduces MTBF worries and increases application
possibilities.
Easy Installation Process
From now on, the system engineers will be able to upgrade their
386-based systems to 486 level without as many worries, because with
HSB-440I a 486 level STPC Atlas processor is mounted directly on
board. It eases the configuration and installation process because the
system engineers don’t have to set any jumpers for speed or voltage
difference between various CPUs.
Networking
Targeting on the rapid growing networking and embedded system
markets, the HSB-440I integrates a PCI-bus Realtek RTL8139DL
10/100 Base-Tx Ethernet controller. Running on the STPC Atlas low
power consumption CPU, it also ideal for the demanding Internet
Access Devices or Mobile Applications that require a low power
consumption and low heat dissipation SBC.
Others
Other impressive features include a PC/104 expansion connector is
provided, a built-in 18bit TFT LCD interface, a 32-pin M-Systems
DiskOnChip socket supports Flash memory capacity from 8MB to 1
GB, a Compact Flash card connector, four serial ports, one parallel
port, and IrDA support.

Half-size CPU Card HSB-440I
Chapter 1 General Information 1 -3
1.2Features
•Supports STPC Atlas SoC 133MHz (BGA)
•Integrated LCD controller supports 18-bit TFT panel
•10/ 100Mbps high speed Ethernet
•Supports DiskOnChip 2000 socket and Compact Flash
Type Ⅱ
•IrDA transmission
•Expansion ISA interface
•Support PC/104 socket
•Fanless and +5V active
•Watchdog & Digital I/O
Note: TFT resolution only supports 640 x 480 and 800 x 600 (default). If you
want to change the resolution, please visit AAEON’s website
(www.aaeon.com.tw) and download the BIOS.

Half-size CPU Card HSB-440I
Chapter 1 General Information 1 -4
1.3 Specifications
System
lCPU: STPC Atlas SoC 133MHz
lI/O Chipset: STPC Atlas + Winbond 83977F
lSystem Memory:Onboard 64MB memory
lVGA/LCD Controller STPC Atlas, Share up to 4MB, LCD
Support VGA/SVGA 18bit TFT,
CRT Support VGA/SVGA/XGA.
lEthernet One LAN, Use External RJ-45
Connector
Realtek 8139DL 10/ 100Mbps LAN
chips x 1
lBIOS: Award Plug & Play ISA BIOS –
2Mb ROM
lIDE Interface PIO-Mode 4 x 1 channel (Support
two ATAPI devices)
lFloppy Drive Interface One Standard FDD port, support
up to two floppy devices
lSerial Port Four COM ports : (Three internal
pin headers, One external on
bracket)
COM 1/3/4 : RS-232
COM2: RS232/RS-422/RS-485
lDigital I/O Digital I/O, 4-In, 4-Out

Half-size CPU Card HSB-440I
Chapter 1 General Information 1 -5
lParallel Port Supports SPP/EPP/ECP mode
lK/B and Mouse One Mini-DINPS/2 keyboard and
Mouse connector
One internal keyboard pin header
One internal mouse pin header
lUniversal Serial Bus Two USB Port (One 5x2 pin header)
lDisk On Chip/ Supports DOC 2000 Socket
Compact Flash Support CF type ⅡSlot (USED
IDE Secondary Interface)
lPC/104 Module Support PC/104 Slot
lExpansion Interface ISA Interface
lIR Interface Supports One IrDA header (only in
Windows OS environment)
lWatchdog timer: Can generate a system reset.
Software selectable time-out interval
(15sec~240 sec, 16 step)
lRTC Internal RTC
lOperation Temp. 0℃~ 60℃

Half-size CPU Card HSB-440I
Chapter 2 Quick Installation Guide
Quick
Installation
Guide
Chapter
Part No. 2007440I10 V.1 Printed in Taiwan April/2003
Notice:
The Quick Installation Guide is derived from
Chapter 2 of
user manual. For other chapters and
further installation
instructions, please refer to the user manual CD-ROM
that
came with the product.

Half-size CPU Card HSB-440I
Chapter 2 Quick Installation Guide 2 -2
2.1 Safety Precautions
Always completely disconnect the power cord from
your board whenever you are working on it. Do not
make connections while the power is on, because a
sudden rush of power can damage sensitive
electronic components.
Always ground yourself to remove any static charge
before touching the board. Modern electronic
devices are very sensitive to static electric charges.
Use a grounding wrist strap at all times. Place all
electronic components on a static-dissipative surface
or in a static-shielded bag when they are not in the
chassis

Half-size CPU Card HSB-440I
Chapter 2 Quick Installation Guide 2 -3
2.2Location of Connectors and Jumpers
Locating connectors and jumpers (component side)

Half-size CPU Card HSB-440I
Chapter 2 Quick Installation Guide 2 -4
Locating connector (solder side)

Half-size CPU Card HSB-440I
Chapter 2 Quick Installation Guide 2 -5
2.3 Mechanical Drawing
Mechanical drawing (component side)

Half-size CPU Card HSB-440I
Chapter 2 Quick Installation Guide 2 -6
Mechanical Drawing (solder side)

Half-size CPU Card HSB-440I
Chapter 2 Quick Installation Guide 2 -7
2.4List of Jumpers
The board has a number of jumpers that allow you to configure your
system to suit your application.
The table below shows the function of each of the jumpers of the
board:
Jumpers
Label Function
JP1 LCD Voltage Selection
JP2 TTL-LCD Clock Selection
JP3 Onboard COM Port On/Off Selection
JP4 Clear CMOS
JP5 COM2RS-232/422/485 Selection
JP6 DiskOnChip 2000 Address Selection
JP7 COM2 RS-232/422/485 Selection

Half-size CPU Card HSB-440I
Chapter 2 Quick Installation Guide 2 -8
2.5List of Connectors
The board has a number of connectors that allow you to configure
your system to suit your application.
The table below shows the function of each of the connectors of the
board:
Connectors
Label Function
CN1 Front Panel Connector
CN2 LPT Port Connector
CN3 TTL_LCD Connector
CN4 Power Connector
CN5 COM3 RS-232 Serial Port Connector
CN6 COM4 RS-232 Serial Port Connector
CN7 Digital I/O Connector
CN8 USB Connector
CN9 COM2 RS-232/422/485 Serial Port Connector
CN10 Internal Mouse Connector
CN11 Internal Keyboard Connector
CN12 IrDA Connector
CN13 PS2 Keyboard/Mouse Connector
CN14 4P Power Connector
CN15 3P Power Connector
FDD1 Floppy Connector
HDD1 EIDE Connector
VGA1 VGA Display Connector
COM1 COM1 RS-232 Serial Port Connector
LAN1 10/100 Base-Tx Ethernet Connector
CFD1 CompactFlash Slot
P104-1PC/104 Connector