Abus FUBE50011 User manual

FUBE50011 USER GUIDE
FUBE50011
[UK] User Guide.............................9
12263086

11
Preface
Dear customer,
Thank you for purchasing this wireless remote control. In choosing our product,
you now have a piece of equipment that is built according to state-of-the-art
technology.
This document refers to the V1.3 software version of the wireless remote control.
This user guide contains important installation and operation information. Store
this user guide in a safe place for future reference. This user guide belongs to
this product –bear this in mind if you pass on this product to others.
Conformity
This product complies with current domestic and European regulations.
Conformity has been proven. The related certifications are available from the
manufacturer on request. To maintain this status and to guarantee safe
operation, it is your obligation to observe these operating instructions. If you have
any questions, please contact your local specialist dealer.
This product complies with the requirements and other relevant terms of the EC
directive: R&TTE 1999/5/EC of the European Parliament and the directive of

12
March 9, 1999 regarding wireless systems and telecommunication transmitters
and the mutual recognition of their conformity.
Intended use
Read the notes and advice in this user guide carefully. If you do not
follow these instructions, your guarantee claim becomes invalid. No
liability can be accepted for resulting damages. No part of the
product may be changed or modified in any way. The remote control
is not waterproof. Please avoid direct contact with water. Everything possible has
been done to ensure that the contents of this user guide is correct. However,
neither the author nor ABUS Security-Center GmbH & Co. KG can be held liable
for loss or damages caused by incorrect or improper use or failure to observe the
safety instructions and warnings. We reserve the right to make changes to these
instructions without prior notice.

13
Refer to the end of the user guide for more notes and information on
operating the wireless remote control. [beginning on page 48]
Information on the battery
The device is supplied with direct current from a 3V lithium battery. To guarantee
a long service life and avoid fire and injury, please note the following:
Do not dispose of the battery in domestic waste.
The battery must not be directly exposed to heat or sunlight, and must not
be stored in a place with a very high temperature.
The battery must not be burned.
The battery must not come into contact with water.
The battery must not be dismantled, pierced or otherwise damaged.
The battery contacts must not be short-circuited.
The battery must be kept away from small children.
The battery cannot be recharged.

14
Disposal
Disposal as per directive WEEE 2002/96 EC
The product contains valuable raw materials. At the end of its
service life, dispose of the product according to the applicable
legal requirements. Within the EU, the product and its
accessories must be collected and disposed of separately.
Devices displaying this symbol may not be disposed of as
domestic waste. Please contact your dealer or dispose of the products at the
local collection point for electronic waste.
Features
The wireless remote control is used for arming and disarming alarm systems. It
indicates the current status of the alarm system. A switching output can also be
armed as an option. The wireless remote control has a panic feature. This can
also be used for controlling 868 MHz transceivers in the Secvest/Terxon product
range.

15
Technical data
Wireless frequency: 868.6625 MHz
Transmission power: max. 10 mW (amplifier output)
Range (outdoors): approx. 200 m
Range (indoors): Depending on ambient conditions
Power supply: Lithium battery type / CR 2450 Li-Mn 3V
Operating temperature: -10° C to +40° C
Humidity: max. 75% (non-condensing)
Dimension (WxHxD): 36.2 x 62 x 17 mm
Weight: 35 g
Security level: 2 (EN 50131-1:2006)
Environmental class: II (EN 50131-1:2006)
Standard: EN 50131-3

16
Operation
Inserting or changing the battery
Before the wireless remote control can be used,
the battery has to be inserted. When inserting
the battery, all the LED pairs light up red and
green one after another which show that all the
LEDs are working properly.
Reading the software version
The software version of the remote control is then shown by the two LEDs at the
top. The main version is shown by the flashing red LED and the sub version is
shown by the flashing green LED.
Learning in
Follow the steps described in the user guide for the compatible component. The
“” button can be used for “arming internally” or for switching an output.

17
Find out more details from the user guide for the compatible component.
Customer service and support
End consumer
Please consult your dealer or installer if you have any questions.
Dealer/installer
Consult our website for product information.
ABUS Security-Center GmbH & Co. KG
86444 Affing
Linker Kreuthweg 5
GERMANY
www.abus-sc.com
[email protected]
© ABUS Security-Center GmbH & Co. KG, August 2012

50
Operation
[UK] Arming the alarm system

51
Vds konforme Verwendung
VdS conformal usage
[UK] When arming the system, you are not allowed to be in the controlled
area. When using alarm panels which are installed regarding
VdS3438 this device is not allowed for arming or disarming the panel.

52
[UK] Arming internally

53
[UK] Arming failure
v

54
[UK] Disarming

55
[UK] Disarming after alarm

56
[UK] Status query [System is armed]

57
[UK] Status query [System is armed internally]

58
[UK] Status query [System is disarmed]

59
[UK] Trigger panic alarm

60
[UK] Reception time
[UK] Default setting
10 s *
20 s

61
[UK] Switching output