ADC Diagnostix Adstation User manual

1
TM
ADSTATION
Diagnostix
TM
Modular Diagnostic System

2
ADC®Diagnosti TM AdstationTM
Wallboard Installation
Your DiagnostixTM AdstationTM comes complete with assembled
Wallboard, mounting mollies and wood screws for easy installa-
tion.
1. Choose a location for the ADC®DiagnostixTM AdstationTM near
the examination table and an electrical outlet. See Figure 1.
2. We recommend a height of 67 in. (170 cm) from the floor, to
the top edge of your Wallboard. See Figures 2-3.
3. Using Mollies (Small Wallboard): On the selected wall, mark a
horizontal line using a level, to indicate the top of your wallboard.
While holding the wallboard in the desired position, mark through
the mounting holes the position of the screws. Remove wallboard.
Press tip of mollie into the drywall using a #2 Phillips screwdriver
or screw gun into the marked spots. Drive mollies clockwise into
the drywall until it stops flush with the outer wall surface.

3
Reposition the wallboard over the anchors and secure the wall-
board by inserting screws and tightening. Be sure to double
check level before installing all the mounting screws. se the en-
closed screw caps on top of each screw once they are securely
tightened to finish.
4. Using Studs (Large Wallboard): Locate and mark studs on se-
lected wall. Mark a horizontal line (approx. 67 in. - 170 cm) from
floor using a level, to indicate the top of your wallboard. Center the
drill holes on the first stud and mark. While holding the wallboard in
the desired position, use the supplied wood screws and secure the
top corners into the wall/stud, while double checking that the wall-
board is level. Repeat for all mounting screws. se the enclosed
screw caps on top of each screw once they are securely tight-
ened, to finish.
5. Module Connectivity: In order to add additional extension mod-
ules, they must be electrically joined with the transformer station
before mounting it on the wallboard.

4
sing the enclosed module connection cable, plug one side of
the connector into the socket on the transformer module located
on the right side transformer panel behind sliding door.
Plug the opposite end into the extension module contact,
located on the left side panel sliding door.
As you add additional modules, each needs to be connected in
similar fashion using the additional connection cables for each
module.
Tuck excess wiring into each extension to ensure a close side-
by- side fit to each extension module.
CAUTION: Make sure when plugging the connecting cable, that
the 4 contacts of the socket strip be positively connected to the 4
contacts of the pin strip (Figure 4).
6. Mounting AdstationTM Modules: After all modules are electrically
connected, you can now carefully hang the transformer and ad-
ditional modules on to the wallboard mounting pins. Make sure
each module locks securely in a downward position.
STOOL
EDIS
RIAHC
TM
ADSTATION
Modular Diagnostic System
Diagnostix
TM
EXAM
TABLE
(Figure 1)
EXAM
TABLE STOOL
SIDE
CHAIR

5
(Figure 4)
IB p/n: 93-5600-00 rev 1
(Figure 3)
Large Wallboard
(Figure 2)
67”
170 cm
13.625”
34.62 cm
23.25” (59.05 cm)
Small Wallboard
67”
170 cm
13.625”
(34.62cm)
32.75” (83.19cm)