ADLINK Technology NuPRO-598 Series User manual

NuPRO-598 Series
Half Size Socket7 ISA Bus Low Power Pentium SBC
With VGA/LCD/Ethernet/WOL Interface
User’s Guide
Recycled Paper

Manual Rev 1.00: Nov 8, 2001
Part No:
This publication is protected by copyright and all rights are reserved. No
part of it may be reproduced or transmitted by any means or in any form,
without prior consent of the original manufacturer.
The information in this document has been carefully checked and is
believed to be accurate. However, the original manufacturer assumes no
responsibility for any inaccuracies that may appear in this manual. In no
event will the original manufacturer be liable for direct, indirect, special,
exemplary, incidental, incidental or consequential damages resulting from
any defect or omission in this manual, even ifadvised of possibility of such
damages. The material contained herein is for informational purposes only.
Acknowledgments
Award is a registered trademark of Award Software International, Inc.
IBM and PS/2 are trademarks of International Business Machines
Corporation.
C&T is a trademark of Chips and Technologies Inc.
Intel and Pentium are registered trademarks of Intel Corporation.
Microsoft Windows is a registered trademark of Microsoft Corporation.
All other product names or trademarks are properties of their respective
owners.

Getting service from ADLINK
•Customer Satisfaction is always the most important thing for ADLINK
Tech Inc. If you need any help or service, please contact us and get it.
ADLINK Technology Inc.
Web Site http://www.adlink.com.tw
Sales & Service [email protected]
NuDAQ + USBDAQ [email protected]
NuDAM [email protected]
NuIPC [email protected]
NuPRO [email protected]
Software [email protected]
Technical
Support
AMB [email protected]
TEL [phone] FAX [phone]
Address 9F, No. 166, Jian Yi Road, Chungho City, Taipei, 235 Taiwan, R.O.C.
•Please inform or FAX us of your detailed information for a prompt,
satisfactory and constant service.
Detailed Company Information
Company/Organization
Contact Person
E-mail Address
Address
Country
TEL FAX
Web Site Questions
Product Model
OS :
Computer Brand :Environment to Use M/B : CPU :
Chipset : BIOS :
Video Card :
Network Interface Card :
Other :
Challenge Description
Suggestions for ADLINKk

NuPRO-598 Series Comparison Table
Model NuPRO-598
Processor
Intel Pentium
AMD K6-2, K6-3
Cyrix MII
Processor Socket Socket7
Chipset Intel 430TX
BIOS Award
L2 cache 512KB
Max. SDRAM 128MB
Memory Sockets 1 x DIMM
VGA CRT/LCD C&T 69000
Watchdog Timer 0~255 seconds or minutes
PC/104 Connector NO
Multi I/O Chip Winbond83977EF
Enhanced IDE yes
2S/1P yes
USB yes
Ethernet
(10/100Mbps) Intel 82559
H/W Monitoring Winbond W83781D
Board Size 185mm x 122mm

Table of Contents•i
Table of Contents
Chapter 1 Introduction............................................................1
1.1 Checklist.......................................................................2
1.2 Description ...................................................................2
1.3 Features .......................................................................3
1.4 Specifications................................................................4
1.5 Intelligence ...................................................................7
Chapter 2 Installations ..........................................................10
2.1 CPU Installation..........................................................11
2.2 Memory Installation.....................................................11
2.3 Jumpers on the NuPRO-598 ........................................11
2.4 Connectors on the NuPRO-598....................................18
2.5 Watchdog Timer Configuration.....................................30
2.6 Disk On Chip Address .................................................32
Chapter 3 BIOS Configuration..............................................33
3.1 BIOS Introduction........................................................33
3.2 BIOS Setup.................................................................34
Chapter 4 Intel PIIX Bus Master IDE Driver Installation....62
4.1 System Requirements .................................................63
4.2 Installing the Software .................................................64
Chapter 5 VGA Driver Installation........................................66
5.1 Installing the Drivers for Windows 95 ............................66
5.2 Installing the Drivers for Windows 98 ............................67
5.3 Installing the Drivers for Windows NT 4.0......................67
Chapter 6 LAN Driver Installation Guide.............................69
6.1 Introduction.................................................................69
6.2 Features .....................................................................69
6.3 Software Drivers Support .............................................70
6.4 Running Diagnostics....................................................70
6.5 Driver Installation on Windows 98.................................74
6.6 Driver Installation on Windows NT................................75
6.7 Driver Installation on Windows 2000.............................76
Chapter 7 Hardware Doctor Utility.......................................77

ii •Table of Contents
Product Warranty/Service.....................................................82

Introduction •1
1
Introduction
This manual is designed to give you information on the NuPRO-598 CPU
board.
The topics covered in this chapter are as follows:
♦Checklist
♦Description
♦Features
♦Specifications
♦Intelligence
♦Layout of Key Components and Dimensions

2•Introduction
1.1 Checklist
Please check that your package is complete and contains the items below.
If you discover damaged or missing items, please contact your dealer.
•The NuPRO-598 Industrial CPU Board
•This User’s Manual
•1 IDE Ribbon Cable
•1 Floppy Ribbon Connector
•2 Serial Port Ribbon Cable and 1 Parallel Port Attached to a
Mounting Bracket
•1 Optional 2-port
•1 CD Containing Intel PCI IDE Driver, Flash Memory Utility, C&T
69000 VGA Driver, Intel 82559 LAN Driver and Hardware Monitor
utility
1.2 Description
The NuPRO-598 is a Pentium Industrial CPU board based on the Intel
430TX chipset and is fully designed for harsh industrial environment. It
features a Socket7 processor connector that is compatible with Intel
Pentium MMX, AMD K6-2, K6-3 and Cyrix MII processors. This board
accommodates up to 128MB SDRAM configuration.
The NuPRO-598 comes with Winbond’s W83781D hardware monitoring
device that monitors system and CPU temperature, system voltages, and
CPU and chassis fan speeds to prevent system crashes by warning the
user of adverse conditions. NuPRO598 also has a case-open indicator for
security.

Introduction •3
1.3 Features
•CPU Speed 166~400MHz, Intel Pentium MMX & Low power
Pentium &AMD K6-2,K6-3 &Cyrix MII processors
•Bus Speed 66MHz
•Intel 430TX PCIset
•Up to 128MB SDRAM system memory
•C&T 69000 VGA chipset for LCD & CRT displays
•COM1 and COM2 serial ports configurable as RS232 and
RS232/422 respectively
•Programmable watchdog timer, 0~255 second/minutes
•High speed bi-directional SPP/ECP/EPP parallel port
•Modem ring-on
•Hardware Monitoring
•10/100 Mbps Ethernet interface

4•Introduction
1.4 Specifications
♦Processor Socket:Socket7 connector
♦Processor:Intel Pentium MMX, Low Power Pentium, AMD K6-2,K6-3
166~400MHz
♦Bus Speed: 66MHz
♦Chipset: Intel 82430TX, 82371EB
♦Secondary Cache: 512KB
♦Memory Sockets:
•One 168-pin DIMM sockets
•Max. 128MB SDRAM
•Memory type: SDRAM (Synchronous DRAM)
♦BIOS:Award BIOS, PnP support
•FLASH EEPROM (256KB) for BIOS update
•ISA Plug and Play (PnP) extension
•Power management
•Y2K Compliant
♦DMI BIOS Support:
Desktop Management Interface (DMI) allows users to download
system hardware-level information such as CPU type, CPU speed,
internal/external frequencies and memory size.
♦Super I/O: Winbond W83977EF
♦Parallel Port:
•One high-speed parallel port, SPP/EPP/ECP mode
•ESD protection to 4KV
•Downstream device protection to 30V

Introduction •5
♦Serial Port:
•Two 16550 UART compatible ports with COM1 as RS232 and
COM2 as selectable RS232/422
•ESD protection to 2KV
♦Enhanced IDE:
One Enhanced IDE interfaces for up to two devices, support PIO Mode
3/4 or Ultra DMA/33 IDE Hard Disk and ATAPI CD-ROM, LS-120, ZIP.
♦FDD Interface:
One floppy drives (360KB, 720KB, 1.2MB, 1.44MB, 2.88MB).
♦CRT/LCD: C&T 69000 chipset
•Embedded 2MB SDRAM display memory
•Simultaneous CRT & LCD display
•LCD panel supports DSTN/TFT
•1280x1024x8bpp colors CRT resolution
•Up to 1280x1024x8bpp colors resolution for color active matrix TFT
panels (12, 18, and 24bit analog) or (12+12), (18+18) double
pixel/CLK interface
•RAMDAC Latch-up protection
♦USB Interface:
•Two USB pin-header connectors, compliant with USB Specification
Rev. 1.1
•Individual over-current protection
♦DiskOnChip:
The M-Systems flash disk supports system boot and storage capacity
from 2MB to 144MB.
♦Watchdog Timer: programmable
•Program I/O port 3F0H and3F1H to configure watchdog timer
•Time-out timing select 0~255 seconds/minutes
♦Green Function:
Power management via BIOS, activated through mouse/keyboard
movement.

6•Introduction
♦PCI Bus Ethernet Interface: Intel 82559 chipset
•PCI local bus Ethernet controller
•IEEE 802.3 10Base-T and 100Base-TX compatible physical longer
support
•IEEE802.3u auto-negotiation supportforautomaticspeedselection
•10/100Mbps operation in a single port PCI bus master architecture
•IEEE 802.3x (100Base-TX Flow control support)
•Wake on Lan support
•Management communication support to reduce the total cost of
ownership (TCO)
♦Keyboard and Mouse Connectors:
PS/2 type mini-DIN that supports PC/AT; supports a 5-pin external
keyboard connector.
♦PICMG Compliance:Fully compliant to PICMG standards
♦Power supply: AT or ATX
♦Environmental and Mechanical:
•Power Consumption: +5V @11.8A (max)(while K6-3/400 CPU is
installed)
•Temperature: 0°C to 60°C
•Humidity: 5% to 95%
•Dimensions: 185mm x 129mm

Introduction •7
1.5 Intelligence
•System Health Monitoring:
A sensor for the CPU temperature on the NuPRO-598 monitors the
CPU temperature, an external sensor for system temperature,
case-open indicator, fan speed detection, system voltage
monitoring.
•Windows 98 shut-off:
Allowsshut-off controlfrom within Windows 98 and through an ATX
power supply.
•Modem ring-on:
Allowssystempoweringonthroughanexternalmodemandthrough
an ATX power supply.
•Year 2000 Compliant BIOS:
The onboard Award BIOS is Year 2000 Compliant.
•Wake On LAN:
Through an ATX power supply and network connection, systems
can be turned on from the power-off state.

8•Introduction
Figure 1 Layout of key components
JP4

Introduction •9
Figure 2 NuPRO-598 Mechanical Drawing

10 •Installations
2
Installations
This chapter provides information on how to use the jumpers and
connectors on the NuPRO-598 in order to set up a workable system. The
topics covered are:
♦CPU Installation
♦Memory Installation
♦Jumpers on the NuPRO-598
♦Connectors on the NuPRO-598
♦Watchdog timer configration

Installations •11
2.1 CPU Installation
The NuPRO-598 Industrial CPU Board supports a Socket7 processor
socket for Intel Pentium MMX, Low power Pentium, AMD K6-2/-3 and Cyrix
MII processors.
The Socket7 connector comes with a lever to secure the processor. Before
insertingtheCPU,makesurethelever is raised perpendicular to the socket
and the notch on the corner of the CPU corresponds with the notch on the
inside of the socket.
After you have installed and lock the processor into place, check if the
jumpers for the CPU type and speed are correct.
Note: Ensure that the CPU heat sink and the CPU top surface are in total
contact to avoid CPU overheating problem that would cause your
system to hang or be unstable.
2.2 Memory Installation
The NuPRO-598 Industrial CPU Board supports a 168-pin DIMM sockets
for a maximum total memory of 128MB SDRAMs. The memory modules
can come in sizes of 16MB, 32MB, 64MB, 128MB SDRAM.
2.3 Jumpers on the NuPRO-598
The jumpers on the NuPRO-598 allow you to configure your CPU board
according to the needs of your applications. If you have doubts about the
best jumper configuration for your needs, contact your dealer or sales
representative. The following table lists the jumpers and dipswitches on
NuPRO-598 and their respective functions.

12 •Installations
Figure3 Jumper Locations on the NuPRO-598
JP4
JP13