ADTRAN 1442530G1 User manual

jobAid
DESCRIPTION
TheSmallForm‐FactorPluggable(SFP)isasingle‐modefiberSFP
thatplugsintoanADTRANopticalinterfacedesignedtoaccept
SFPs.TheSFPprovidesasingleopticalinterfacetoaphysical
interface,andisintendedforusewithaGigabitPassiveOptical
Network(GPON)OpticalLineTermination(OLT)module.
Installedintoanappropriatemodule,theSFPprovidesaGPON
interfacetothesupportingsystem.
ThisSFPisdesignedforuseinWavelengthDivisionMultiplexing
(WDM)applications.
ThisSFPhasaDigitalDiagnosticMonitoring(DDM)function
withinternalcalibration.
ThefollowingfeaturesaresupportedontheSFP:
♦Dataratedownstream:2.488Gbps
♦Daterateupstream:1.244Gbps
♦TransmitWavelength:1490nm
♦ReceiveWavelength:1310nm
♦Opticaldistance:30kmmaximum
♦HotPluggable
Operational Specifications
♦OpticalSpecifications:
◊Opticaltransmitlevel:+1.5dBmto+5dBm
◊Opticalreceivelevel:–30dBmminimum
◊Opticalconnectors:SC
♦ExtendedEnvironmentalSupport:
◊Operationaltemperaturerange:–40°Cto+85°C
◊Storagetemperaturerange:–40°Cto+85°C
◊Relativehumidityto95%,noncondensing
◊OperatingAltitudeRange:–197feet(–60meters)to13000
feet(3962meters)
NOTE
Theoperatingambienttemperatureisderatedby1°C/1000feet
(3.3°C/km).
CAUTION
!
Duetocompliancecertificationrequirements,onlySFPs
approvedbyADTRANaretobeusedwiththehostmodule.
ADTRANcannotcertifysystemintegritywithotherSFPs.
INSTALLATION
ToinstalltheSFPintoanappropriatemodule,completethe
followingsteps:
InspecttheSFP.Ifdamaged,fileaclaimwiththecarrierandthen
contactADTRANCustomerSupport.
CAUTION
!
DonotremovetheprotectiveendcapfromtheSFPuntilthefiber
opticcableisreadytobeconnected.
1. InserttheSFPintotheSFPcageonthemodule.Ensurethe
latchontheSFPisfacingupwardforcorrectinstallation.
2. SlidetheSFPallthewayintotheSFPcageuntilthereisan
audible“click”.
NOTE
♦ ThelatchontheSFPisusedtoremovetheSFPfromthecage
onthecircuitcard.
♦ TheSFPmeetsorexceedsalltheapplicablerequirementsof
NEBS,TelcordiaGR‐63‐CORE,andGR‐1089‐CORE.
COMPLIANCE
CAUTION
!
ElectrostaticDischarge(ESD)candamageelectronicmodules.
Whenhandlingmodules,wearanantistaticdischargewriststrap
topreventdamagetoelectroniccomponents.Placemodulesin
antistaticpackingmaterialwhentransportingorstoring.When
workingonmodules,alwaysplacethemonanapproved
antistaticmatthatiselectricallygrounded.
NOTE
♦ TheSFPisaClass1LaserProductandcomplieswiththeLaser
SafetyrequirementsofFDA21CFR1040.10and1040.11,and
EN60825‐1and‐2.TheSFPisNRTLListedandCBCertifiedto
allapplicableAmericanandEuropeansafetystandards.
♦ TheSFPhasbeenevaluatedtointernationalsafetystandards
EN60950‐1,AS/NZS60950.1,andIEC60950‐1.TheSFPmeets
therequirementsforCEmarkingundertheEMCDirective
andLowVoltageDirective.Standardsusedtodemonstrate
ComplianceareEN300386,EN50222,EN55024asapplicable
andEN60950.
CLEI: BVL3AHFD_ _
Product P/N: 1442530G1
Issue Date: April 2010
Document P/N: 61442530G1-22A
Small Form-Factor Pluggable
GPON OLT
Transceiver SFP

C A U T I O N
C A U T I O N
!
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.
CAUTION
!
TheSFPisintendedfordeploymentinCentralofficetype
facilities,EEEs,EECs,andlocationswhereNECapplies(for
example,CustomerPremises).TheSFPmustbeinstalledby
trainedservicepersonnelinADTRANproductsthatarelocated
inRestrictedAccessLocations.
ThisdevicecomplieswithPart15oftheFCCrules.Operationis
subjecttothefollowingtwoconditions:
1. Thisdevicemaynotcauseharmfulinterference.
2. Thisdevicemustacceptanyinterferencereceived,including
interferencethatmaycauseundesiredoperation.
ChangesormodificationsnotexpresslyapprovedbyADTRAN
couldvoidtheuserʹsauthoritytooperatethisequipment.
CAUTION
!
♦ PerGR‐1089‐COREtheADTRANsystemthattheSFPisbeing
deployedinisdesignedandintendedforinstallationaspartof
aCommonBondingNetwork(CBN).TheADTRANsystem
thattheSFPisbeingdeployedinisnotdesignednorintended
forinstallationaspartofanIsolatedBondingNetwork(IBN).
♦ PerGR‐1089‐CORESection9,theSFPdoesnothaveaninternal
DCconnectionbetweenbatteryreturnandframeground.The
SFPcanbeinstalledinaDC‐I(isolated)orDC‐C(common)
configuration.Forinstallationswhereothercardsorthehost
systemhaveinternalconnectionsbetweenbatteryreturnand
frameground,thesystemwouldbeintendedfordeployment
onlyinaDC‐Cconfiguration.
♦ TheADTRANsystemchassisframegroundterminalmustbe
connectedtoareliableearthgroundtoensurethatthemetal
enclosureoftheSFPisproperlygroundedviathebackplane
connector.
NOTE
♦ TheGPONisopticalandthereforeisnotclassifiedasanytype
ofportasdefinedinAppendixBofGR‐1089‐COREIssue5.
♦ TheSFPisdesignedfordeploymentinGR‐3108‐CORE
environmentalclass1and2,asdefinedinGR‐3108,Issue2.
TheSFPisdesignedtomeetthefollowingenvironmentalclasses:
♦ETSIEN300019‐1‐1“Classificationofenvironmental
conditions;Storage,”Class1.2
♦ETSIEN300019‐1‐2“Classificationofenvironmental
conditions;Transportation,”Class2.3
♦ETSIEN300019‐1‐3“Classificationofenvironmental
conditions;Stationaryuseatweather‐protectedlocations,”
Class3.3
Theequipmentisdesignedtofunctionwithoutdegradation
duringexposuretoalltestseveritiesperClass3.3.
Warranty:ADTRAN will replace or repair this product within the warranty period if it does not meet its
published specifications or fails while in service. Warranty information can be found online at
www.adtran.com/warranty.
©2010 ADTRAN, Inc. All Rights Reserved.
*61442530G1-22A*
ADTRAN CUSTOMER CARE:
From within the U.S. 1.800.726.8663
From outside the U.S. +1 256.963.8716
PRICING AND AVAILABILITY 1.800.827.0807
NOTE
♦ ThisSFPiscompliantwithSFF‐8472“DigitalDiagnostics
MonitoringInterfaceforOpticalTransceiver,”Revision9.3
♦ ThisSFPiscompliantwithSmallForm‐FactorPluggable(SFP)
Multi‐SourceAgreement(MSA).
♦ TheSFPcomplieswithG984.2ClassB+opticsrequirements
withthefollowingexceptions:
1.EnhancedReceiverSensitivityof–30dBm
2.MinimumReceiverOverloadof–10dBm